To Top

March 2008 Engine Mounts

• CATEGORIES: Biscuit, Features

The CJ-5 I bought last year had been modified to accept a GM 350. I really liked the way they put together the engine mounts, so I chose to reuse the mounts and then modified my frame to accept the mounts.

To make the mounts, I took the standard buick v6 mounts and removed the rubber blocks, leaving only the steel.  Then, I cut and welded some 3×3 square tubing to the mounts.  

To make the holders that are welded to the frame, I used some recycled angle iron and added side braces to create the triangular look.  I look this setup much better than what I did in my first jeep. 


 

2 Comments on “March 2008 Engine Mounts

  1. Pingback: Specs of My Build | eWillys

  2. Arshad k

    I am Arshad k from kerala
    I want willys cj3b orginal chassis
    Very argent
    My address,
    Arshad k
    S/o moidu
    kundaniyil house
    Moochikkel
    valanchery po
    Pin:-676552
    Malappuram distrct
    Kerala
    India

Leave a Reply

Your email address will not be published. Required fields are marked *

Subscribe without commenting