To Top

1946 CJ-2A Clinton, Ma eBay (stainless parts)


1946_cj2a_clintonUPDATE:  This is back on eBay

Here’s a fiberglass CJ-2A that also has a stainless steel grille and windshield.  This has a variety of updates.

“You are bidding on (1) 1946 Willys Jeep CJ2A.  I am the second owner of this vehicle.  The original owner worked on this jeep for 2 1/2 years. He has built many Willys Jeeps in the past. the entire chassis was disassembled Media blasted, boxed and repaired.  All welds are 100% pentrated TIG. The front of the chassis was removed and built up with a donor chassis from a jeep CJ5 donor. and 2″x2″ bar Stock.  The chassis was then painted with 2 coats of POR-15 and chassis coat.  A Rancho 2-1/2″ lift kit was installed along with an additional 1/2″ lift and greasable zirks for a total of 3″ lift.  This will easily clear 33″x12.5 tires.  The rear axle is a 1959 CJ5 Dana 44 that was rebuilt and in the front is the stock dana 27 that was rebuilt.  the gear ratio’s are 5:38.  the T-90 tranny and model 18 transfer case along with bearings, seals, and clutch were also rebuilt.  All new brakes front and rear as well as custom bent brake lines, rubbers, and a dual master cylinder kit.  It has the L-138 Flat head motor in it that was rebuilt and bored .040 over. it runs beautifullly.  It has also an aftermarket Solex carb and custom air intake kit.  it has been converted to a 12 volt system with a brand new alternator.  the body is all fiberglass built by AJ’s Body….”


Leave a Reply

Your email address will not be published. Required fields are marked *

Subscribe without commenting