To Top

My Build: Adding a Rear View Mirror

• CATEGORIES: Biscuit This site contains affiliate links for which I may be compensated.

I’ve been meaning to add a rear view mirror to the Biscuit.  A couple months ago I pulled a rear view mirror off an old Dodge truck at a salvage yard;  I specifically searched for a rear view mirror that could be bolted onto the jeep. I knew there were times that I would want to have a rear view mirror without the windshield, so connecting it to the windshield wasn’t an option.  Also, from past experience, I knew that the windshield flexes at highway speeds a bit, so it would shake a little less connected to the roll bar.

So, last weekend I took a small piece of flat steel and welded it onto a piece of tube cut in half. I then drilled and tapped a hole into the rollbar.  Then all that was left was to drill a couple holes into the mini mount i built, paint it, and attach it. It’s nothing fancy, but gets the job done!

 

4 Comments on “My Build: Adding a Rear View Mirror

  1. Mitch

    Looks good Dave!…That gives me an idea on how to mount a new tach right in front of my face…

Leave a Reply

Your email address will not be published. Required fields are marked *

Subscribe without commenting