To Top

1953 CJ-3B Crawler Project Bloomingburg, NY $500


UPDATE: Price dropped to $500.

(10/20/2018) Not sure how much value is here.


“1953 cj3b Willy’s. Currently has a mopar 318 v8 out of a 86 Dodge Ramcharger, also has the Ramcharger 4 speed auto trans and transfer case in it as well.

Has a Dana 44 front axle, passenger side drop, Chrysler 9 3/4 rear axle. Front axle is vacuum actuated 4×4, was planning on converting it to a push/pull knob on the dash(kits available online)

Original frame, in great shape, frame is stretched 12 inches and fully reinforced for the stretch. Stretched frame b/c I was planning on building a LJ type look, along with the need for the correct drive shaft angle. Axles have been stretched as well. Front is about 3 inches and rear is about 8. Original wheel base was about 76 inches, now is sitting around the same as a jku

Leaf springs have been out boarded to fit half ton axles, re inforcements for that are still needed

Body is in rough shape, floors were gone when I got the Jeep, front half of the tub is pretty solid, grill, hood and windshield are in great shape. Glass is good.

Body was cut in half due to back half being rotted away, was planning on building new rear section to the Jeep to fit the stretch.

Front half of the tub has been reinforced around to hold it square.”


2 Comments on “1953 CJ-3B Crawler Project Bloomingburg, NY $500

Leave a Reply

Your email address will not be published. Required fields are marked *

Subscribe without commenting