To Top

1949 CJ-3A Tucson, AZ $17,500


UPDATE: Price dropped to $17,500.

(05/12/2020) This is looks like a true frame-off refurb; it does have a few minor mods, such as updated brakes.


“Here we have a 1949 willy’s Cj-3a Jeep. Vehicle has 2,609 miles since full frame off restoration. Build started 2/3/09 and was completed 11/29/11. Has been garage kept since 2009. All new parts and some N.O.S. parts. Original 134ci. flathead (L-head) engine with .40 over bore. New cam, crank, and pistons. Built by C. Bremmer in Phoenix.

T-90 three speed manual transmission. Dana 18 transfer case with 29 tooth final gear. Dana 25 front axle with new ring and pinion, yoke and spicer style axles. Dana 44 rear axle with new ring and pinion, yoke and full floating axles.

5.38 gear ratio. (Both axles built by D. Braun at Willys Works). All new USA made springs and suspension components. 12 volt conversion with high torque mini starter and pertronix distributor module for a factory look but easy drivability. All new wiring harness with asphalt coated cotton jacket wire loom to appear era correct. Front branches have been upgraded to a ford 11″ x 2″ wide drum.

Body is original steel. Many parts custom made for this vehicle. Paint is a single stage urethane metallic in Gumby Green. Excellent driver and 4 wheeler. “This jeep would climb walls , if you could get it to stick”. Far too much to list. Willing to consider trade for early 66-77 ford bronco.”





Leave a Reply

Your email address will not be published. Required fields are marked *

Subscribe without commenting