Not sure how much value is here.

https://www.facebook.com/marketplace/item/387901492331924

“This is a 1953 Willy’s Jeep. Great project vehicle. 4 cylinder Engine runs. Steering box has been rebuilt. Currently working on Transmission and brakes. I don’t have a place to work on it inside.”

UPDATE: Price dropped to $3200.

(09/06/2020) Lacks a battery and a title.

https://www.facebook.com/marketplace/item/3828836807132212/

“This Willis Jeep has original motor. It is between a 1948 and 1952. Needs battery and a little tlc No title”

UPDATE: Price dropped to $4000.

https://www.facebook.com/marketplace/item/415037812962237

“1950 Willys Jeep , Classic fully restored. Azle texas”

UPDATE: Craig notes the price has also been listed at $1000.

Bill spotted this project or parts jeep.

https://nh.craigslist.org/cto/d/gilmanton-1952-cj3-willys-flat-fender/7235839597.html

“This CJ became more of a project than I planned. The jeep is complete, I do have the original seat frames with steel pans. The motor is stuck. I pulled the head and am soaking the cylinders with mystery oil. SO OBVIOUSLY IT DOES NOT RUN! I have new 19 guage floor panels to weld in and a brand new 12 volt battery. Was going to convert it to 12 v. The tires all have decent tread and hold air as they should. It rolls very easily to move around and load onto a trailer. These are getting as rare as hen’s teeth! If it doesn’t sell, I’ll get it running, get it roadworthy and keep it. $1,500.”

UPDATE: Still Available. Has a replacement body.

https://www.facebook.com/marketplace/item/789659828490354/

“1949 Willys Jeep CJ-3A. Condition is as you see it. I have a clean title. The body is in pretty good condition, and the underneath looks good, from what I’ve seen. I have a few extra wheels, a new steering wheel, and possibly a couple other parts that can go with it. The first $2500 takes it.”

Older pics:

UPDATE: **SOLD** Was $8000.

(11/13/2020) This is a project with various parts and a replacement body.

“Considering trading my Willy’s. It isn’t complete as of yet. It needs breaks, radiator, and wiring. New body 0 rust V6 vortex w/ long Tom headers Top loader 4 speed 65 front and rear New tires and wheels New soft top w/ Bikini top New leather front and rear seats Waren bumpers Original hood, grill and tail gate I would consider trading for a pickup. Older the better”

Listed as a CJ-2A, it looks to be a CJ-3A that needs brakes at the very least. It likely does not have the original engine.

https://www.facebook.com/marketplace/item/677192576327257

“Work in process DOSEN’T come with tow bar its not mine to give Engine runs it drives just needs brakes to be done Everything in the drivetrain works as it should clutch front locking hubs low range high range she will drive whole drive all the syncros all the gears It’s converted to 12 V has a alternator 12 V coil etc. i have a bunch of brand new parts that go with it Full exhaust system old one on it is ok dont need to be replaced Full pre-bent stainless steel brake line kit New rubber brake hoses Brand new wheel cylinders Brand new drums New shoes w hardware  All brand new gauges New master cylinder New gastank”

Not sure how much value is here.

https://www.facebook.com/marketplace/item/971044266755832

“1950 Willys Jeep CJ-3a. Has title, does not run, needs full restoration. Is complete. Great project and cool looking Jeep. Sold as is. Make me an offer”

UPDATE: **SOLD** Was $7000.

“1950 Willys CJ3A / V-6 Conversion • 1995 Chevrolet Vortec 4.3L V6 CPI complete computer and OBD-II port (VIN 1GNDT13W3S2140797) -in tank, “Tanks inc” submerged fuel pump to support 4.3 EFI with high pressure fuel lines all brand new • Hood scoop / air intake • Advance Adapters engine to transmission adapter kit • Rebuilt T90 3-speed transmission and transfer case • Warn Overdrive • FlowTech headers with Thrush mufflers • All suspension and wheel bearings replaced • Saginaw steering conversion • Dual brake master cylinder • Four-wheel 11″ brake conversion • Dual fuel tanks (second not currently connected) • Superlift Super Ride 2.5″ lift springs / shocks • Five 15″ white spoke wheels with new tires (Four Steel Belted All Season P205/75R15 M+S (off vehicle) One Goodyear Wrangler RT/S P205/75R15 Spare [on vehicle]) • Second set of 4 original (?) Willys Steelies with 30/9.5/15 brand new mud tires. (On Jeep) • On board air with 3 gallon tank and regulator(works) • Heater with custom windshield defroster(works) • Driver side electric windshield wiper (works) • Roll bar with front hoop and spreaders making it a cage • Subaru Brat high back reclining bucket seats with covers • Over the shoulder seat belts • BesTop full soft top • Two inch receiver on bumper(not on now) • Swing out spare tire / dual jerry can holders • Lockable rear tailgate storage area (9” x 11” x 36”) • Reproduction 1950 Willys Service Manual • Photocopied V6 emissions/wiring • Updated vehicle wiring diagram Body is in good condition for its age (70 years old)”

UPDATE: **SOLD** Was $4500.

Unclear if it will run or not. Has a PTO winch.

“1950 cj 3a ran when parked owner puts Tran fluid down carb from time to time motor turns over it has all seats including one that fits between the two fronts he recently had the fuel tank cleaned”

Looks like a DJ-5 bumper has been added.

https://www.facebook.com/marketplace/item/1260011304380017

“1954 willy’s Jeep Brand new rebuilt buick 234 engine Runs perfectly Clean title Serious inquiries only please”

UPDATE: Still Available.

(09/20/2020) This is being sold by the folks at Quarter Ton Parts.

https://www.facebook.com/marketplace/item/2162504230561291

“1952 Willys CJ3A. Runs good, Drives good, Stops good, 4×4 works fine. Lots of new parts installed. Rebuilt starter, new fuel pump, carburetor, Master cylinder, plugs, wires, tune up parts, sheering wheel, and steering bell crank pin and bearings. This would make a great parade or farm jeep. It would be an excellent restoration project. There is some bondo here and there, it pops out of second gear when you let off the gas and use the gears to slow it. (typical) It has leaks and some play in the steering. (All very normal for one of these) It is available if it is still listed. It is located at Quarter Ton Parts in Chickamauga, GA. Hours are 8-4 eastern M-F.”

UPDATE: **SOLD** Was $650.

Appears to have some value.

“1951 Willys CJ3A Rolling Chassis, 23,000 miles with title and tags, engine disassembled 30 years ago, been sitting in a garage ever since. Frame is very nice, front horns good, with axles, trans, transfer case, most engine parts, great start for a resto or drop in a 4.3. Lots of extra parts, bring a trailer and cash”

UPDATE: Price dropped to $3000.

(11/02/2020) I’m not sure which winch that is.

https://www.facebook.com/marketplace/item/777351596158371/

“Willy’s Jeep. New brakes. New fuel pump. New rear seat. Has soft top with bows and doors. No trades. Price is negotiable, but not giving it away”