UPDATE: **SOLD** Was $1875.

Are you kidding me? A running GPW that looks pretty good for under $2000?

“1945 GPW HALF HARD TOP RUNS GOOD”

UPDATE: Was $2800 **SOLD**

(11/04/09) “42 GPW, Ford jeep- ex military, was going to be a future project, was purchased in Colorado from the owner who had obtained it from his uncle and was ulitized on both of their farms, I had the vehicle shipped to Illinois- has clean frame ( no road salt used in state) main reason I bought the vehicle. GPW runs but has untill recently has been in inside storage, and is parked outside and needs a little work. Unit is missing original gas tank and support strap but I will donate a cj2a fuel tank to get you going.”

UPDATE: **SOLD** Was $6700.

This is a long, but detailed post.  I’ll show the links, the pics and then the description.

http://www.surfacezero.com/g503/showgallery.php?cat=2167&ppuser=622

1944 Ford GPW WWII Jeep (Similar to Willys MB Jeep)

This was a west coast vehicle (I moved it to Texas this summer) and is fairly good in terms of rust and dents, but there is definitely work to be done. The worst part of the body is the fuel tank sump, which is totally missing. Also, there are the usual sections of the hat channels that will need addressing. There are dents in the rear floor and fender wells, though the steel is in good shape and could be straightened. Same with the rear panel. The chassis has the standard-issue bubba treatment on the front bumper gussets, which are attached to a makeshift front bumper. I think the lower gussets could be salvaged, but the uppers will need to be replaced. The left rear of the chassis has sustained damage and has had a brace welded onto it. The rear crossmember and pintel plate will need to be repaired or replaced.

Okay, so that’s the bad news. The good is that I’ve been collecting a whole bunch of parts over the past couple of years to bring this closer to being a correct restoration.

Among the components I’ve got are: one complete GPW engine and a spare block. The engine is serial number 259468 and the casting date is b28522 (February 28, 1945). This was a running motor when I bought it, but is currently not operating because I took off the Willys head that was on it and have only temporarily bolted on the correct Ford head to keep dirt out of the cylinders. I purchased that engine to transfer all the components over to a November 10, 1944 block, which is dead-on correct for an early December 1944 GPW. (The estimated DoD on this GPW is either December 11 or December 12, 1944. These dates are based on GPW 240211, which is a numbers-matching GPW located in Northern California with a DoD of 12-12-44 on its original data tags. The casting date on GPW 240211’s engine is November 11, 1944.) On the spare block I cleaned up the serial number pad and restamped the “GPW <->” in the correct font, leaving the number blank after that. (There is a cartouche on the manifold side, which identifies this as a replacement block.) I haven’t had the engine tested, but there are no apparent cracks. Three of the holes for the head bolt studs, however, are oversized and will either need to have special studs or be helicoiled. (These are the three studs that are located underneath the oil filter mounting bracket.)

I’ve also acquired a bunch of the peripherals for the engine, including an NOS Autolite GEG 5101 generator (April ’48, with a spare used February ’45 that has the correct SP 484A pulley); a GPW water pump and GPW thermostat housing; GPW exhaust and intake manifolds; a correctly dated 1944 fuel pump with primer handle; replacement tags for all the electrical components (generator, distributor, starter motor, voltage regulator); and the GPW head that I mentioned above.

In terms of the body, I put on all the script-marked grab handles and rear footrests (one footrest will need to have rust welded in the lower center section); original F-marked bumperettes; correct Stimsonite No. 12 reflectors in Guide A2 No.415 A bezels; a matched True Temper axe and shovel set; the correct Stewart-Warner gas and oil gauges; a correct block F amperes gauge; a correct King Seeley speedometer; a 1944 Gerry Can; five original combat rims; an ANCO Rainmaster tandem wiper set (NOS); an original F-script pintel hitch; a pair of NOS Hall grille marker lights; an NOS Corcoran Brown blackout driving light; original rifle rack; and much more. The driver’s seat is F marked, but the spare driver’s seat, passenger and rear seat are not. There is also a complete set of original cushions with steel springs and horsehair inserts.”

I’m not sure what it would take to bring this into the U.S. and it seems pretty high priced for a non-runner, but it looks complete and raw.  Interestingly, it appears to have Cali black plates, so not sure what it’s doing down there.  Check out the email addy … lol

“its a 1942 GPW ford stiil in good conditions, but it doesn´t run, includes a lot of extra parts, some of them are new(new folding top, fuel pump,valves,starter, and the list continues). i also found 2 bullet impacts in the rear, i belive those are from the war. if you are interested call this number (646)152 98 00 nextel ID 152*15*55067 or email oouhshit@hotmail.com”

http://sandiego.craigslist.org/csd/cto/1400077076.html

UPDATE:  **SOLD** Was $5000.

The seller has added a price and clarified thisis a 1944 GPW.

“Nice and fun jeep to drive .. there is a pin hair crack near the distribtor in the block …but the jeep runs and drives it all ready for the next person .. in done lots of money invested”

UPDATE:  Price dropped to $6000.

I’m not a big fan of the bumpers, but everything else looks good on the GPW.

“1943 Willys Jeep GPW- restoring, new paint,lots of new parts. Have all original parts replaced. New spark plug wires,coil,distributor,points,fuel pump,carburator kit,tires,wiring. All transfer cases cleaned,drained and refilled. New canvas top,seats.,new battery. 6,000 OBO 918-465-1054”

http://oklahomacity.craigslist.org/cto/1312946529.html

Kind of a funky paint job, but it would probably clean up well.

“Rare 1942 Ford Jeep WWII. During WWII Willys-Overland Co. could not produce enough jeeps to meet the war demand, thus Ford starting producing jeeps in the exact image of the Willys model so that the parts were interchangeable. Sense limited production were produced these jeeps are a rare find. The jeep has been garaged and in our family for over 20 years. For those collectors out there this jeep can easily be restored to its original glory. I believe the seats and rollbar and rear bumpre are the only changes made. The jeeps body and engine are in great condition, I drove the jeep this past weekend around the farm. Please send me an email at katzjigs@yahoo.com or call 559-446-1071 and leave a message if you are interested and we can arrange a viewing.”

http://fresno.craigslist.org/cto/1300785489.html