This appears to be built atop a later frame (and chassis?).

https://www.facebook.com/marketplace/item/1165160044525922

“1946/48 Willy’s Cj2A 225 Dauntless V6 disk front brakes new tires new soft top new seats new paint new dash and gauges some of the gauges need wiring hydraulic clutch”

Ted’s got this 2A for sale.

https://www.facebook.com/groups/837017479769475

“For sale is a 1947 Willys CJ2A,
Serial number 105348
The bad , body pretty rough but I’ve certainly seen much worse , motor bad I’m assuming as the previous owner pulled the plugs and then neglected to put ‘em back. I’m gonna mess with the motor and see if I can get it turning over. They most always will run if they turn over and have compression. But for all intents and purposes and purposes I’d say this one will need a rebuild.
The good , jeep has a very respectable frame under it somehow (see pics). Very nice frame with hat channels still intact and frame rails look pretty good
Jeep has what looks to be an early Newgren Three Point Hitch assembly on it
After doing some research and talking with some buddies that know more about the newgrens than I do it seems this one is early judging by the belt driven pump , and engine bay reservoir , control valve between seats. Ram is present and looks decent , it didn’t have adjusters and lift arms when I got it but have since made some for another Newgren I have and will include a very nice set of lift arm adjusters and Arms made better if anything than the originals as a lot of the Newgren stuff was pretty crude right from the get go.
Jeep also has a nice original Scheneker plow setup on it and blade included
Great candidate for a frame up restoration with motor rebuild or refurbish the Newgren for another jeep and start with the rolling frame.
I have other Willys PTO equipment to turn this one into a farm Jeep if desired for additional cost
I’m valuing the jeep at about what The Three point hitch assemblies have been bringing, with a good rolling frame , plow setup etc as I just sold a large collection of them
I can send additional pics if needed and I have another good hood to go with it as this one is shot
No title but will include a state of CT Bill of Sale etc
Located in Storrs CT
PM me for more info or to come get it , too many projects going
$3500
860 428 3265”

Sounds like a project.

https://www.facebook.com/marketplace/item/908928214578498

“1948 CJ2A 4 cylinder Have all the wiring for conversion to 12 volt system. New gages come with. Will have to be trailered away.”

No description provided. It is a project.

https://www.facebook.com/marketplace/item/609096671410552

“1948 Jeep Cj2a · Convertible”

UPDATE: Price bumped to $2400.

“05/24/2024” Looks like there is some parts value here.

https://www.facebook.com/marketplace/item/423586823952841

“1947 Willy’s jeep cj2a. I bought this already disassembled to restore but my new knees are not going to let me do the work for awhile. original 4-cylinder flat head, 2b windshield, usual rust in floor, couple of dents, but still very restorable. engine turns over with attached 12volt starter.it will be for sale complete until June first, then I will be taking offers on individual parts. message me any questions you may have. Paris Tennessee area. $1600 price is firm as I am taking a loss alread”

Looks like a nicely updated jeep. Some closer up pics would be better.

https://www.facebook.com/marketplace/item/1002335781295710

“I have for sale my 1948 Willy’s. I hate to sell but we bought a house and need the money for projects, this jeep is a “restomod” powered by a Buick dauntless v6 bolted to a t-18 4 speed and a Dana 20 transmission, the jeep also has a warn overdrive and Chevy axles. We have a soft top, bikini top and a spare wheel and tire to go with. Everything works as it should and boy does it get attention, I am not in a rush to sell however feel free to reach out with any questions thanks!”

UPDATE: price dropped to $4500.

(06/26/2024) This has a replacement body, so there seems like value here.

https://www.facebook.com/marketplace/item/1862067244269544

“This is a 1948 Willy’s flat fender jeep. This jeep is a rolling project. New factory tub.Comes with custom bumpers, custom willys vynal seats. Custom dash pads and center console. New gauge cluster Custom hood scoop Fully enclosed frame. Full roll cage, steel chrome wheels, 305 engine and auto transmission. Installed. Over $12000 has been invested into this jeep. My loss is your gain. No time to finish. To many other projects. $5000 obo.”

UPDATE: Price dropped to $2700.

(06/24/2024) This 2A has some early Husky hubs. Note this has Wash State plates.

https://www.facebook.com/marketplace/item/1546736745871357

“1948 Willys CJ2A with GM Iron Duke engine. Has a welded in roll bar, power steering. Body is in great shape. Does not run and has no title. Was set up for trails but is street legal. Bought for parts, but is too nice to strip down.”

This may be worth a look. Has rear mounted custom tank.

https://www.facebook.com/marketplace/item/374736948716973/

“1946 Willy’s, has a Buick v6 motor plenty of power, new paint, new tires, nice seats, has the original running gear that works perfect, new fuel cell, been in the family since 1960, the ultimate side-by-side, if a tree gets in your way just mow it over, this thing is built to last, no flimsy A arms and tiny axles, it’s a tank, I had it lifted, with big tires and rims, it looked good but didn’t perform off road, back to a two inch lift with skinny tires, works the best, put chains on the front tires, and you will never get stuck. The motor so strong it will sling mud thirty feet in front of Jeep.”

UPDATE: Still Available.

(05/24/2024) This looks solid. It’s got a replacement body, so it should be in good shape.

https://www.facebook.com/marketplace/item/736485101688313

“Runs great and looks amazing! Took first place in the one car show I took it to and all the other parts come with it along with a v6 Buick motor. Open to trades but not selling individual parts!”

This has a rear PTO and gear box.

https://www.facebook.com/marketplace/item/961834428834871

“Runs, drives. starts with key. brakes not working. has title. L134 engine, T90 transmission. PTO shifter with complete PTO unit on back of jeep. when you engage the PTO shifter, a spline on the back bumper turns.”

Thanks to John for sharing this one.

https://www.facebook.com/marketplace/item/1473059699985251

“…  if you want to make an offer let that be in person with cash on hand and a way to take it home with you if thats too much to ask then keep scrolling 1948 willy jeep 4cyl 3spd runs and moves on its own power needs restoration good running gear floors are good frame good outter body needs work brakes need to be looked at it starts and drive off a gas can has new coil and spark plugs and fuel filter theres also a pto pump to go with it nice little project to do and fun to drive selling due to health issued so all projects gotta go as i wont be able to finish or get to them”

This has at least one combat rim. It’s also got full floaters in the rear. It might also have been a column shift. It could be a ’45.

https://www.facebook.com/marketplace/item/1020351486169783

“1946 CJ2A military police jeep. Needs a lot of work. Everything is there to put back together. I priced what I think it would take to do it right, you would be looking at probably 10,000. Everything now is original, I think.”

UPDATE: Still Available.

(05/24/2024) Needs work of some type.

https://www.facebook.com/marketplace/item/387272714272991

“This Jeep runs and drives well.We have it legal and ride it on roads some.Many new parts.Needs a little time and effort put into to make it new again.Great little project.”

The front frame rails suggest this might be a 3A chassis. It includes a new body.

https://www.facebook.com/marketplace/item/943480274122072

“1946 Willy’s jeep got a brand new body front fenders good and tail gate paid 5,000$ for the body alone it runs and moves under it’s own power clutch is free had all intentions on redoing it just to many projects 5,000$ or best offer no title!!! Needs gone”

Not sure have much value this column shift CJ-2A has.

https://www.facebook.com/marketplace/item/855016449797592

“I have a 1946 Jeep Willy’s complete running gear everything but the top don’t know much about it other then it ran 13 years ago. Along with it I have a 1947 frame and running gear the motor has already been changed to a 12 volt system it ran 5 years ago would be great to freshen up and fix the buddy on the other 2500 Firm will not respond to is it available When I get the data tag information and serial number the price will go up due to me finding more information on the proper age and exactly what I have.”