UPDATE: Was $4000. **SOLD**

Has updates.

“53 Willy clean title call”

UPDATE: **SOLD** Was $8900.

Has a passenger-side tank.

“1954 WILLY’S JEEP WITH CHEVY 283 SMALL BLOCK ENGINE, REBUILT TRANSMISSION, NEW TIRES.”

UPDATE: **SOLD** was $1200

It’s a project.

“Good frame, tub can be fixed, motor won’t turn, could be stuck or clutch could be stuck. No data plate on tub. Make a nice mud rig or parts truck”

UPDATE: **SOLD** Was $7495.

Not restored, but refurbished and modified.

“This is a 55 willys restored. New factory engine with approx. 3000 miles on it, new bearings, bushings and seals throughout. new viper racing yellow with clear pearl overcoat. New viper racing seats still in original wrapping, epoxy coating on interior, stainless steel dash, rack and pinion power steering,, custom rims and tires, will be putting diamond plate fender flares and bikini top on next , have chrome hood kit coming, I would drive this unit anywhere, top speed is about 60, tires are at 60%. Custom stainless body dressing. Still tweaking on it but ready to go. Fill the tank and drive forever, has the new Hurricane motor, will consider trade on pickup or other later model jeep cj5 or 7. no junk.”

UPDATE: **SOLD** Was $800

(02/05/2015) Looks like there’s some value here.

“Clean and clear Arizona Title. I have both the VIN plate and shift diagram plate that go on the dashboard. Location and Contact info at bottom of post.

I am not parting this out. This sale is for the entire vehicle and it’s spare parts. Most of the parts are present. The only known missing parts for a complete vehicle are: driver and passenger seats/frames, windshield glass, and all rubber hoses, seals, seams etc. I have not done any work on this so I cannot say if the engine/transmission/axles are any good. I bought it in Phoenix. I heard it came from northern AZ.

Continue reading →

UPDATE: **SOLD** Was on eBay.

This is an interesting 3B. It’s got a replacement tub. The side bar has an unusual swoop that must act as a step. Labeled a 1951, it might be a CJ-3A chassis?

“You are bidding on a 1951 Willy’s Jeep.  It was purchased approximately 3 years ago as the foundation of a custom off-road/rock crawler vehicle.  It has nearly new heavy lugged off road tires, custom built roll cage with side skids.  The cage and skids were professionally built.  The jeep body is in very good condition for being 64 years old.  It has a custom gas tank with custom seats (see photos).  The vehicle was scheduled for a complete ground up custom build.  A death in the family forces sale.  It was running and was drove to the spot where it is parked.  It has the Commando OHV engine.  No Battery … sold as is.  Front axle needs differential work.  Some other parts are included, top bows/doors/ and a variety of other small parts. ”

UPDATE: Was $1500. **SOLD**

“Willys CJ3B. Complete but rough body; grille and hood in good shape. Original F-head engine turns partway over by hand. Transmission and transfer case shift fine. Ran when parked but has been sitting on the family farm for many years. No title – bill of sale only. $1500 OBO – will deliver within 30 miles for a small fee. Good parts vehicle for a rebuild. ”

UPDATE: **SOLD** Was $2500.

(03/28/2015) Check out the odd turn signals.

“53 willys over land jeep
Rebuilt motor
Rebuilt front and rearend
Pozzy in the rear
33x1250x17 trailblazers
front 2 hold air back to hold air just have a,small leak due to not rolling around
Jeep could use a new battery and carb cleaning
all the lights work
has a,sheet metal roof to block out the rain
3 speed manual with high low granny gear
Great jeep to cruise around the trails in not road worthy”

UPDATE: **SOLD** Was $1200

(11/13/2013) “Two Willys Jeeps 1953 & 1954 CJ-3Bs. Take two and restore one. One ran and drove when parked. It has an F-head motor, T-90 trans, Dana 18 t-case. The other has an L-head motor, T-90 trans and Dana 18 t-case, never heard it run. Have a title for one. $1200.00 OBO”

UPDATE: **SOLD** Was $4000.

(06/25/2014) This doesn’t run.

“For Sale – 1955 Willy’s CJ3B – This vehicle is being sold as part of my Father’s estate. This vehicle is a 1955 CJ3B body on a 1946 CJ2A frame. The vehicle does not currently run. My Father had the main assembly done on the vehicle, but it does need the gas tank plumbed and wiring done to it. I’m also pretty sure it needs driveshafts done for it. Here are some of the components for it that I can recall –
Dana 30 front axle, Ford 9 Inch rear axle, 33×12.50 BF Goodrich At’s, Ford 302 Small Block (rebuilt), Ford T-18 Tranny and an Atlas T-Case. Please contact me and I will answer any questions as best that I can, or setup a time to look at the vehicle yourself. Thanks.”

UPDATE: **SOLD** Was $850.

Seller won’t part out.

“* * * IF YOU SEE IT HERE, IT’S STILL AVAILABLE * * * *

-CJ3B PART VEHICLE / PROJECT VEHICLE
– ENGINE CRANKS, FRAME NOT RUSTED THROUGH ANYWHERE, DRIVE TRAIN ALL IN WORKING CONDITION.
(BARN FIND) . LOTS OF GOOD PARTS INCLUDING: ENGINE, RADIATOR, TRANSMISSION, FUEL TANK, SEAT FRAMES, ORIGINAL CARTER-WILLYS OVERLAND CARBURETOR, STEERING ASSEMBLY, FIVE WHEELS (MOUNTED).
– GREAT PROJECT VEHICLE FOR SOMEONE WHO’S LOOKING FOR A PROJECT JEEP.
– NOT WILLING TO PICK IT APART. SOLD AS ONE ENTIRE UNIT. IF YOU KNOW WHAT THESE PARTS COST, YOU’LL KNOW THIS IS WELL WORTH THE MONEY.”

UPDATE: Price dropped to $1050.

(09/26/2014) It runs, but needs work to be road worthy.

“61 Jeep CJ3B. Engine and drive train are ok but the body needs replacing. Mileage on odometer is 42,000 and believed to be correct. This Jeep has spent the last 23 years sitting outside. Will start right up when the carburetor is primed but is not roadworthy. The frame and underpinnings are solid making this a great restoration project. Other than the 31″ rims and 2″ lift it is original. I have new brake lines and carburetor that will convey. All parts are available through KaiserWillys.com. To many projects so this one has to go. Is registered and I have a clean title. “

http://winchester.craigslist.org/cto/4942274201.html