To Top

1948 CJ-2A Kettle Falls, ID **SOLD**


UPDATE:  Was $2200. **SOLD**

(08/06/2010) Might not be a bad price.


To Top

1951 Truck Freedom, Me $500

• CATEGORIES: Willys Trucks

UPDATE:  Price dropped to $500

(12/05/2010) Here’s a cheap plow vehicle.

“has the orginal flat head super hurrican engine with the generator setup all orginal under hood has a 7 1/2 foot fisher plow with the orginal fisher pump works great 4×4 runs drives call for more info… 207-382-3059”

To Top

1953 CJ-3B Lemont, Il **SOLD**


UPDATE: **SOLD** Was $750

(03/06/2010) There is rust, but I can’t tell just how bad it is.


To Top

1947 CJ-2A Rogers, AR **SOLD**


UPDATE:  **SOLD** Was $1800.

(11/24/2010) Doesn’t run.

“1947 Willys Jeep,4×4,original 4 cyl.,3 speed,rare hardtop,needs restored,hasn’t ran in a while,these Jeeps are getting real hard to find.$1,800”

To Top

1948 CJ-2A Phoenix, Az $8500


UPDATE:  Still Available

(12/22/2010) This has some updates.

“1948 Willy’s Jeep, 4X4, 289 Motor, 3 Speed Transmision, Full Floating Rear End, 538 Gears, Lockers Front and Rear, Tara Low Transfer Case, Beard Seats, Rhino Lined inside, New Paint, 6000 lb. Warn Winch, Extra Parts. Runs Perfect. $8500.00 Call Sam 928-533-2940”

To Top

1947 CJ-2A Henderson, Ca **Status Unknown**


UPDATE:  Price bumped to $2000

(12/20/2010) “1947 willys jeep V 6 motor 12volt system runs drives needs tlc call”

To Top

Next Update Jan 2nd


I’ll be taking the next two nights off.  See you next year on the 2nd!  Happy New Year!

To Top

Happy 17th Birthday Chris

• CATEGORIES: Builds, Features

Over the past year and a half Chris (from Mossy Rock, Wa) and I have been trading emails every-so-often as he works his way through his flat fender project.  He recently figured out how to work with some bondo; he also tried his hand at using Herculiner.  You can see the results below.   It’s a bit of a trial and error process for him, but he’s making good progress.

January 1st is his birthday, so have a great birthday Chris and keep the pics coming!

To Top

The Jerry Can Tool Box

• CATEGORIES: Features, Parts

Maggie mentioned to me that she was searching for a Jerry Can Tool Box someone built and displayed on line.  With a little searching we tracked it down to  I’ve included two pics of it below.  You can see all the pics here.

To Top

1958 CJ-5 Chico, Ca eBay

• CATEGORIES: CJ5, Unusual • TAGS: .

Hog forwarded this auction.  Bidding just ended on this CJ-5 previously owned by Bing Crosby, reaching a high of $5850.  I suspect it will be back on eBay at some point.

“Barn stored since 1973. Perfect running condition. Originally used on Rising River Ranch by the Crosby Cattle Co. Owned by Bing Crosby from new until 1973. All original, but seats and turn signal assembly. As you can see in the pictures the cosmetics are not perfect, but are easily fixed. This thing could climb a wall! She’s ready to go and up to date on all paperwork. Pink slip in hand.”

View all the info on eBay

To Top

1943 4 Wheel Steer MB Cannes-La-Bocca, France 15,000 Euros

• CATEGORIES: MB, Unusual • TAGS: .

UPDATE:  Alex forwarded some additional pics that shows more of the rear turning solution.

Alex spotted this unusual MB.  This MB has been modified with 4 wheel drive steering.  Alex has asked the seller to forward some pics of the rear end mods so we can check it out further. According to Alex, “The article says the Jeep was modified by a craftsman in Caen (Normandy) to enable it to pull a plough.”

View all the info and pics at eBay

New pics:

Old pics:
Continue reading

To Top

CJ-5 Parts Boise, Id **SOLD**


UPDATE:  An eWillys reader bought all the parts.

Ken’s located here in Boise and has a variety of parts for sale and wants them gone!

Complete Fiberglass tub and front clip
Complete 304 Engine W/ Headers, Eldelbrock 4BBL, Mallory Distributor, Aluminium Valve Covers,Flywheel & Clutch.
2 Wiring Harness, 1stock, 1aftermarket
Prothane body mount kit, motor mounts, trans mount, complete suspension and steering boot kit, shock boots. (N.I.B.)
Steering Column, Grant steering wheel, Power Steering Gear, Sector shaft.
Heater Assembly (stock)
2 Dashes, 1 with instruments and Cables, The other is painted to match tub
Seat Risers, Driver and Passenger
Front and rear seats (YJ)
1 set new springs
New spring mounts and shackles (full set for front and back)
Spicer 20 T/Case
2 T150 3 speed transmissions in near perfect condition
Roll Bar (stock)
Stainless hard line kit (brake and fuel)
Gas Tank (N.I.B. polyurathane)
Clutch and Brake peddle assy.
Stainless steps

Here are a variety of pics:

Click below to see more pics ….

Continue reading

To Top

1966 CJ-5 Port Crane, NY **SOLD**


UPDATE: **SOLD** Was on $500

This includes a rebuilt engine, though it isn’t installed.

“1966 Jeep with aftermarket solid top, standard on column, 4×4, 4 cylinder, with 6′ MANUAL angle, hydraulic lift plow. This is a project Jeep, does NOT currently run. Needs work, Engine re-built but NOT installed, Needs starter, alternator, battery, etc… to run. This is a cool little Jeep that would make a great winter project.”

To Top

1964 CJ-5 Miami, Fl $1000


There might be some value in this project.

“1964 Jeep CJ5, 4 X 4, manual transmission, 4 cylinder, all original. This jeep was sitting for a while and will need some work to get it running. I am firm in the $1,000 price, dont call if you want it cheaper than that. 786-556-3668”

To Top

1946 CJ-2A Ramona, Ca $9500


This looks good.

“1946 Willys CJ2A jeep, original 4cyl flathead and 4 spd trans both rebuilt, this jeep had a complete resto a few years ago, have the reciepts to prove it, has wide tires on it, runs like a champ full soft top $9500 obo call 760-518-5510 or email”

To Top

1941 Slat Grille MB Las Vegas, Nv **SOLD**


UPDATE: **SOLD** was on eBay

Here’s a slattie project.

“You are bidding on a great restoration project.  I am thinning out my collection because I have a few other rare vehicles that I’m in the process of restoring so some toys must go.  This one up for auction is a 1941 Willys slat grill.  It does have rust in the usual places such as front floors, fuel tank and driver side panel area.  The jeep has been media blasted from top to bottom but surface rust is starting due to the fact that it was not primered.  I was hoping to start restoration sooner but other projects have forced me to push it aside which is why I am selling.  The frame is very solid and has also been blasted.  I do have a front bumper and a rear crossmember that will go with the jeep.  As can be seen in the pictures, the tail panel has been messed with and will need to be fixed.   The jeep comes with a complete MB motor but it is not original to the car as the vin is very high.  I do have one front seat that will go with the jeep and a back seat.  The jeep does have the original low windshield with the early brass windshield clamps which are hard to find.  The jeep also comes with some hard to find parts such as the solid wheels and the original pancake air cleaner. ”

To Top

1955 Truck Gowen, Ok No Price

• CATEGORIES: Willys Trucks

This might make a good project.

“Willys 4 wheel drive truck project. Chassis in excellent condition and body is in good condition for the year.Have flathead 6 motor.The truck came from California so no rust to speak of. Need to see it and then make fair offer.”

To Top

1947 CJ-2A Upland, CA **SOLD**


UPDATE: **SOLD** Was $2750.

(10/06/2010) “We have a 1947 Jeep Willys. Needs a head gasket and tires otherwise in good condition. Pictures to follow this weekend. Really want to trade for a small pickup truck for our almost 16 year old son.”

To Top

1952 Wagon Lake County, CA **SOLD**

• CATEGORIES: Willys Wagons • TAGS: , .

UPDATE: **SOLD** Was $2500.

This looks in good shape for the price.

“2 wd, all stock, been stored over 20 years. 6 vlt. system. new interior. Easy project.”

To Top

Jeepster in Tahiti

• CATEGORIES: Features, Jeepster, Old Images

Alex forwarded this picture of a Jeepster in Tahiti taken in 1951.  As far as I’m concerned, any excuse to show a picture of Tahiti is a good excuse in my book!

To Top

1954 CJ-3B Washougal, Wa $7800


UPDATE: Still Available

(11/21/2010) This looks great.

“4 cyl,3 spd w/overdrive,44rr,gm steering,gm tilt wheel,12v,runs great. no solicitors Call this number for more info or pictures can be mailed, 360-607-3859”

To Top

1954 CJ-3B Missoula, Mt **SOLD**


UPDATE: **SOLD** Was $6000

(12/05/2010) This looks good. Includes a rear PTO.

“1954 CJ3B Jeep Willys, F-Head 134 Hurricane motor, 6 volt system. PTO on back. Runs great. Also a set of 4 studded snow with 33 x9/50 rims. 33 x 9/50 on Jeep now.”


To Top

1947 CJ-2A Royse City, TX **SOLD**


UPDATE: **SOLD** Was $2000

(12/17/2010) It runs.

“For Sale 1947 Willy’s Jeep Asking $2000.00 (Runs).  Would Make A Good Hunting Jeep. New Tires. Call for details or If Interested.”


To Top

A video with some early CJ-2 (not CJ-2A) video

• CATEGORIES: videos

Or forwarded this Israeli video that includes some great shots of early experimental CJ-2 flatties. Check out from :59 seconds until 2:18.  Watch a Willys wrangle cows and more ….

To Top

Colin Provides Some Updates

• CATEGORIES: Builds, Features

Colin provided a couple updates.  He’s got a new top for his Surrey and his son, Lee,  got their CJ-2A project running for the first time.

Colin writes, “I had a new top put on the Surrey.  Here are a couple of photos of it.  I also attached a couple of photos of our project 1952 CJ3A that is nearing completion. It has a CJ2A windshield and is now 12V with upgraded larger 11″ brakes.It still has the L-134 4 banger, but also sports an electric winch, custom built rollbar and custom bikini top.   These were taken the first time we fired it ran like a Swiss watch!”