UPDATE:  Price dropped to $3000

(05/30/2011) The windshield seems to be tilted a bit far back.

“I have a 1951 Jeep Willys CJ3A for sale. This girl is fun to drive and with summer here, will be a fun in the sun antique to drive. This jeep looks like it could have crawled up the beaches of Normandy and is a 4×4 that won’t get stuck in the mud. This Jeep is not mint or show quality, but it is in overall good body condition. The upgraded engine is a chevy V6 and it runs very well. It has updated wiring and is street legal. Has the side mounted axe and shovel, gas can, and spare tire. It has a front tow bar so that you can pull it with a 2inch ball to the lake or to your hunting spot. This jeep gets a lot of attention wherever it goes. I”m asking $4,500. I’ve brought the Jeep into the city from storage so if interested give me a call at 913-424-2188 to take a look.

1951 Jeep Willys CJ3A features:
4 speed
Updated wiring
4X4 hi and lo
Painted desert sand with WWII D-Day star markings
Tub rubber coated
Under seat tool box
V6 chevy engine
GPS speedometer
Working horn
All terrain tires with spare tire and mount
Gas can mount and can
Shovel and Axe side mounted
Tailgate
Custom storage box for tailgate
PTO
Roll bar
Canvas back seat
Vinyl bikini top
Front tow bar
Titled, tagged as KS antique, and street legal
Manual wipers”

http://kansascity.craigslist.org/cto/2658683591.html

UPDATE: **SOLD** Was $950

(10/10?2011) This is a project or a parts jeep.

“project … as is new Ford 4-cyl motor
3 speed tranny & transfer case
lift springs and lots of extra parts”

UPDATE: **SOLD** Was $925.

There might be some value here. It runs.

“This old jeep has plowed and got my firewood for 8 years without problems.
Tight original running gear, flat head 4, 2/ 4WD high/ low all works fine.
Old tires, but hold air fine, and are deep lug tread, frame is solid, typical body rust, under vehicle has been recently rust preventative applied. Brakes don’t presently work.
Got snow blower for tractor and don’t need this any more.
Use, as is or disassemble and part out worth:

CJ2A aluminum half top $150
12 volt conversion $150
Lock out hubs
Plow assembly and pump $200
Running engine $300
Tranny $200
Transfer case $100
Front diff with axles $300
Rear diff $150
Radiator $100
Solid frame $100
Newer starter $100
good carb with manifold $75”

Nop pics provided.

“Metal top, 283 Chevy Engine,”

http://omaha.craigslist.org/cto/2655335796.html

UPDATE: **SOLD** Was $3200.

Lots of new stuff, but isn’t complete yet.

“I have a 1947 CJ2A 4×4.flatfender Jeep for sale…225 Dauntless V6 engine(ran Good).3spd…..Frame has been ground down and truck bed coated…Brand New Metal Tube cost $2.300.00 alone……..New tail gate…New gas tank….Brand new Best top in the box goes with this jeep.and doors cost over $800.00….Needs to be rewired or wires hooked back up…….new mirrors…new tail lights…..Many new parts….New Paint …..New seat frames….Needs tires….needs a front end linkage part….This is a project…alot of work has been done & alot of money went into this jeep…..New body mounts .Lift…shocks are good..needs roll bar or cage……Have put over $5000.00 into this jeep..need to sell asap. need cash”

UPDATE: **SOLD** Was $2250.

Engine is out (sitting in the back).

“1948 jeep cj2a has a 4 cyl engine and 3 spd it also has the rear seat frame the engine is removed andlooks to have had some work done. All parts are there. A very straight and original old jeep that would make a good project call 402-200-0153”

It runs.

“42 Willy’s Jeep…Purchased to restore, just don’t have the time or the room. Jeep runs, but needs tune up. It has a flat head 6 cylinder I believe it is a studabaker, new radiator, starter, shocks. 559-240-2913”

http://fresno.craigslist.org/cto/2652892963.html