“$1500 OBO. 1953 CJ3B in the process of being restored. Everything is stock, but the stock axles are not under it (they’ll need new lock-out hubs). Currently it has a set of CJ5 axles under it for moving purposes (included). The springs are brand new Rancho 2.5″ lift springs and new shocks. New front and rear bumper and the frame has been stripped and painted. It’s been pretty well cleaned up and ran 2 years ago when I started the rebuild. Engine still turns by hand. The body is gone except for the firewall, but the data plates are here. Basically, I’m bored with it and have no money. As far as I know, to start it all ya need is a bolt for the block (one of the bolts for the carb is stripped. It’s out, but ya need a new one), fuel lines and electrical. Everything is there, with a spare windshield and windshield frame, early CJ roll bar, and an extra set of gauges for the dash.”
1959 DJ-3A Acworth, GA **SOLD**
This might be a very good deal. Note: the engine needs work..
“You are looking at a 1959 Cj-3a. Body is in good shape..there is a new gas tank, fuel pump, coil-over shocks and other small items. I have the frame for the top which will go with the jeep. It needs seats..( I do have the frames that was in it when I bought it ) .. The original 134 L-head engine is complete but does not run…it will turn over. It has a bad rod..but it is an easy rebuild..All parts can be bought from Turner 4-Wheel in Canton. This is a great restorable jeep or a great hunting jeep. All the electrical works and the 4-wheel drive works. For you jeep guys—–it is a 1959 body..looks like a DJ though..but it is on 4-wheel chasis. The vin # is a ’59 DJ.. look at the pics”
Trencher off a CJ-5 in South Dakota
There was no price listed on this trencher. It’s bit rusted, but these are hard to find.
“Trencher from an old jeep. Just removed from the jeep. Complete. Call Bob at 605 852 2156”
1952? CJ-2A? Calhan, Co $1500
This appears to have a CJ-3B windshield with a CJ-2A body and maybe a CJ-3A title?
“1952 Willys jeep. Would be a great project or hunting vehicle. Runs but needs a new carb. Has recently been converted to 12 volt. Has the flat head 4cly.(go devil)? Comes with tow bar and tows great. The jeep has some rust and holes but could be patched. Comes with a hard top also, and a extra military hood. I am in the process of working on this jeep so price is, as is right now. Call Chuck 719-243-3425”
1948 CJ-2A Olathe, CO **SOLD**
It appears in decent shape.
“CHECK THIS OUT. 48 WILLY’S CJ2A, 4X4 , 4 CYL., STICK. RUNS GOOD BUT BODY NEEDS A LITTLE TLC.”
1945 MB Micanopy, Fl $3200
This MB appears in good shape, though I can see some body dents. I think it has a CJ-3B windshield though.
“1945 military Willy’s jeep. 4-cylinder motor. some rust. runs great. clear title. all original. painted military drab. new windshield. with military tires. David Escalera- (352)538-9761”
1948 CJ-2A Whittier, CA **SOLD**
Something is collapsing in the middle of this jeep — either the frame or the front of the body.
“Buick V6 all Edelbrock performance parts. fully locked up, free floating hubs, cb radio, safari top and full top included, removable tow bar, back seat. runs good. WIll take any reasonable offer!!!! Cash only..”
1951 CJ-3A (Aluminum Body) San Jacinto, Ca $6000
UPDATE: Price dropped to $6000
This seller claims this CJ-3A has an aluminum body. These are certainly rare.
“Willey’s Jeep, 350 V-8, all aluminum body, 2″ Rancho lift, new tires and rims(951) 766-7223”
1946 CJ-2A Statesville, NC $450
UPDATED: The seller only has this green one left.
“jeep, 46 has no motor but has everything from the bellhousing back, 450$ I have more pics I can email.Thanks”
Bender, Notchers and a Roller
Today I ran across an Harbor Freight Ad for a tubing roller for only $139. That got me wondering if I could use that for bending too. So, I went did some searches on the HF tubing roller and read some pretty postive reviews for it in a variety of forums. That said, the bending radius is too big for rollcage angles and corners in most cases.
So, I did some additional looking around at low priced benders and notchers. As I went, I recorded some sites that I felt others might be interested in looking at.
One of the more interesting tidbits I found was a Tubing Coping Calculator that creates a 2 dimensional cutout for tracing around a tubing (in place of a notcher).
Building your own — Free plans:
Tubing benders:
- http://www.lowbucktools.com/hydbender.html
- Various Models from JDSquared
- JD2 Model 3 with home made stand and harbor freight hydraulic
- Pro Tools
- Trick tools
- Baileigh Industrial Video
- TJ Diesel Benders
- Go Fast Parts
Tube Notcher:
1946 CJ-2A Glidden, Wi eBay
Check out this old hand winch.
“This is a great restoration project for the right person in the (JEEP WORLD). It is an all original 1946 willy’s. It has the floor shift T-90 transmission, original dana hi-lo transfer case and the L-134 flat head four cylinder 60 hp Go-Devil engine.(It also has an ALLSTATE cab on it.) The bad, I do not have the title for it, but will give bill of sale to the one who wins this 1946 CJ2A, which are getting really hard to find. Thanks for looking and happy bidding.”
1944 MB Raymond, Me $8500
This sounds interesting. The seller claims this is unrestored (and maybe the seller just means it hasn’t bee pieced together). If so, it’s been well maintained.
“1944 Willys MB. Original Survivor, not Restored. All complete needs included correct engine and tranny installed. Jeep is running, driving, and stopping, needs very little. Great jeep for any one looking for a WW2 Jeep. Call (207)615-1733 AFTER 5 pm Only. Ask for Bill”
1942 GPW Kennewick, WA **SOLD**
“165 miles on new build. Buick v6, New aluminum radiator, 8000 lb warn winch, NEW body & frame, New wheels & tires, New mastercraft seats, New spicer gears & Timken Bearings, SM420 with Warn overdrive, Big shaft model 18 TC, Front disc brakes, ARB Locker & air compressor, Dana 44 rear with Warn full floating axles, Dana 30 front, Integrated towbar & Highlift, New paint & Bedliner, high output heater, New soft top & bikini top. Very clean & well built”
Year? CJ-2A? O’Fallon, MO **SOLD**
It’s a running jeep for only $1200. Comes with it’s own ‘wench’ ….
“Very Used and needs a loving owner who wants to recondition or hunt. Has an electric wench in front. Great for a run around vehicle for a farm or family retreat.”
1950 CJ-3A Beford, IN **SOLD**
This CJ appears in very good condition.
“1950 Willys Jeep 4×4 This jeep has lots of new parts. We redone it 4 years ago. It has a 4cyl Ford engine, it starts and runs good”
1953 CJ-3B Drag Jeep Yuma, AZ **Status Unknown**
UPDATE: **Status Unknown** Was $16,500.
This jeep is part of a package that includes a travel trailer and jet skis. I haven’t seen too many CJ-3B drag jeeps.
“53 willy drag jeep original hard body 350 small block 355 cubic inch 327 corvette heads 205 valves, solid steal competion craink, 310 solid competition cam, Roller rockers 12 to 1 compression MSD ignition ,mollory ignition coil, aluminum 4 core radiator ,electric fan .400 turbo trans. manual velve body, trans brake, hurst shifter, 9 inch ford rear end, 31 spline full spool axel ,620 gears, 500 + horse power,$10,000 invested. very very dependable … .”
1953 CJ-3B Grand Junction, CO **SOLD**
UPDATE: **SOLD** Was $6200. Lots of upgrades and a slightly stretched body.
“1953 CJ3B Stretched Body on 1977 CJ5 Frame, Fuel Injected, 10K miles on Professionally Rebuilt 401, ARB Lockers, Avalanche Automotive Quarter Elliptic Rear Suspension, Spring Over Front Suspension, T-18 Tranny, Modified Low Geared Dana 20 T-Case with Twin Stick, Dana 30 Front End, AMC 20 Rear End w/One-Piece Axles, Winch, Custom Redwood Dash w/ VDO Gauges, 33×12.50/15 Super Swampers, Bikini Top w/ Safari Doors”
1942 MB Slat Grille Sacramento, Ca **SOLD**
“Ford V8 Roller Cam, NP435 4 speed, Dana 18 transfer, 1 1/8″ shafts, Dana 44 rear, Dana 30 front, 4.10 gears posi front & rear, 11″ disc brakes in front, PTO winch, Best soft top, power brakes & steering, roll bar frame boxed, custom bumpers, etc. $8500.00.”
1948 CJ-2A Belfair, Wa $2300
This has had a variety of updates.
“302 NP 435 dana 20, nine inch disk brakes, dana 30 disk brakes, springover on blazer springs, 35’s, power steering and brakes. Motor needs some work. Please call Tory at 360-271-4268 with questions any time of day.”
1946 CJ-2A Oregon City, Or **SOLD**
UPDATE: **SOLD** Was listed at No Price.
I can’t tell if this is an early or a late ’46. It appears a bit rough and without matching tires.
“WILLYS PROJECT………….LOOKIN TO TRADE FOR A QUAD FOR DAD PERRAFABLY A UTILITY QUAD JEEP HAS A CHEV V8 POSSIBLE”
1943 GPW Wilburton, Ok $6000
UPDATE: Price dropped to $6000.
I’m not a big fan of the bumpers, but everything else looks good on the GPW.
“1943 Willys Jeep GPW- restoring, new paint,lots of new parts. Have all original parts replaced. New spark plug wires,coil,distributor,points,fuel pump,carburator kit,tires,wiring. All transfer cases cleaned,drained and refilled. New canvas top,seats.,new battery. 6,000 OBO 918-465-1054”
1946 CJ-2A Graham, Wa **SOLD**
“1946 Willys Jeep Siberia Civilian Style Cab and Frame. This is a great Willys, I built it bolt by bolt. I had a Chevy 350 in it and twisted the rear drive line pulling wheelies everything else is just fine though. I will sell the transmission and the T18 transfer case twin stick if you would like it for $450 more. So its your choice. This is a special willies because of its hard top. The body is close to perfect, but not painted. Everything is good on it, if you get the tranny all you would need is the rear drive line and engine and you will be ready for anything. This jeep never has been stuck in anything, it goes up and through everything. I added a heater in it so that you have defrost and heat, if you need it. Call me with any questions, I know everything about this Jeep, I built it, I”
1948 CJ-2A Las Vegas, NV **SOLD**
“PRICED TO GO FAST SINCE IM MOVING OUT OF TOWN, WONT LAST!!! BLACK COLOR. 4 X 4. CAR SOUNDS GOOD, AND IS IN VERY GOOD RUNNING CONDITION”
1947 CJ-2A Kossuth, Pa No Price
No price listed. It appears in good shape.
“1947 Willys Jeep Great condition. This jeep is ready to drive. Runs and drives properly. It is time for some toys to go. for more info Call 814-498-2533 or 814-797-5686”
1953 CJ-3A Foxboro, Ma $975
UPDATE: More pics. Still Available
Only one pic, but it looks in pretty good shape from the one pic.
“‘53 Willys Jeep, Model CJ3A, flathead 4 cylinder Jeep engine, 6 volt system, aluminum cab, plow hooked up and will go as package, 44,000 original miles, No brakes, dead battery, Body has some rust, mostly surface, floors and bed are rusted through, cross members are weak. Frame is solid. No title or registration. My father used only for plowing driveway. Was running fine when last parked in garage in 2007 when he became ill and has not been started since. $975 firm”