I’ve included only part of the description.  The seller’s description is extensive.

“This is a 1951 CJ3A Willys jeep that belonged to a SE Georgia Cattle farmer and hasn’t ever been in salty roads of colder areas. This vehicle was one of 3 jeeps that belonged to person and had nice weather proof shelter over head appeared not to have been abused or trashed” and limited use because of multiple “toys. This is not a patch plate or bondo special as some of these older Willys on ebay appear to be and even the under pasenger seat utility box is solid(rare). The wind shield frame is very solid as well and this is recurring problem on Willys exposed to elements as well as floor pans.The paint is recent and is enamel OD green and only pic with dog is pre new paint that jeep is currently….”

View all the pics and info and video on eBay

UPDATE: **SOLD** Was $7000.

This looks pretty nice, so I don’t quite understand the diamond plate dash plaque.

“Here is a 1949 Willys Jeep in beautiful condition. This has had a full restoration and engine/drivetrain rebuild. If you would like more pictures or to come and take it for a test drive, please email with your number and I will get back to you ASAP. This comes with a clean MA. title. Thank You”

UPDATE: **SOLD** Was $3200

“This is a nice origianl Willys Jeep. This had some retoration work done about 10 years ago. It is all original. The flathead 4 cylinder, T90 trans and spicer 18 TCase were all gone through and rebuilt by the Willys shop in Toledo Oregon. Everything was gone through. It runs and drives good, brakes all work, lights good. We have had a lot of fun with it in the summers. Interior is very nice. ”

Continue reading →

UPDATE:  Was listed at $4900

(04/14/2012) This has a rear PTO with a drum pulley.  It  looks like a nice jeep.

“This CJ-2A spent most of its life on a farm in Nebraska, and was typically kept in the barn, which would explain the relative lack of rust. The paint looks to be the original black. In 2003, it was purchased from the original farmer’s grandson by a classic vehicle collector and mechanic who brought it to his shop and home in Colorado. The collector, who has worked on many older jeeps, purchased this one because it is so close to original condition in every respect. He kept it as a personal vehicle on his farm in Boulder for five years. In 2008 he sold it to a historic architect out there, and I bought it last summer.

This is equipped with a rare working PTO (power take off), that was used on farms to run equipment such as saw mills, threshing machines, and other farm machinery.

Because of slow and hesitant starting, the 6 volt system was changed to a 12 volt system in 2009. Included in the conversion were a new generator, new battery, new wiring, headlights and some distributor components. The starter motor and other components were not changed. At the time of the 12 volt conversion, a new carburetor, fuel pump, trailer hitch ball, 4 pin trailer wiring and used seat were also added, as well as the new top. The Jeep still has the original paint scheme of Princeton Black, also called “Americar Black,” with Harvard Red wheels. The wheels were repainted before 2008 and the new tires were added at that time. The Jeep’s original gauges, horn, single windshield wiper and heater all work. In 2011, an old weld repair on the side of the block was discovered, almost out of sight, below the distributor. There had apparently been a crack at some point in one of the outside (cooling water) chambers of the block. Even though the old weld repair was holding fine, and the compression tested well, the old repair was completely redone by an engine expert company in Virginia. (Terry Walters Performance Engines). During that process, the engine was removed from the Jeep, the block completely disassembled, the crack area re-repaired, and the engine reassembled. Various parts in the clutch and flywheel, along with motor mounts and distributor points, were replaced at that time.

Since I bought it, the wheels have been pulled off and brakes and bearings rebuilt; choke and throttle cables were replaced, and a new fuel sensor put in;
new seatbelts, mirror, blocks and strap on hood were added. A couple of weeks ago I shorted out the horn wire, so that is currently not working.”