UPDATE: **SOLD** Was $3000.
This might be a good price.
“1975 Jeep CJ-6: 6 Cylinder, 4WD and Granny Drive, Metal Top, Metal Doors and Half Doors,
Roll Bar, Free Standing Top Lifts, Plow, Tire Chains, New Battery”
UPDATE: **SOLD** Was $3000.
This might be a good price.
“1975 Jeep CJ-6: 6 Cylinder, 4WD and Granny Drive, Metal Top, Metal Doors and Half Doors,
Roll Bar, Free Standing Top Lifts, Plow, Tire Chains, New Battery”
UPDATE: **Status Unknown** Was $2700.
There can’t be too many CJ-6 fiberglass bodies out there.
“Dauntless V-6 engine\T86 three speed trans\DANA18 transfer case\Dana 27 front diff| DANA 44 rear diff. Lift springs included. Fiberglass tub and fenders. Steel hood and grille. PO started to restore and gave up. Frame is excellent, as is the windshield frame. Engine\trans\case all installed. Has a roll bar and a lot of misc parts. Needs fuel tank, blinker handle and I’m sure some other misc parts. Has Florida Title. Has never seen snow. No tires or rims. I can load on your trailer for you, or I can deliver but we would have to talk about that. No trades”
UPDATE: Was $14,500. **Status Unknown**
(05/18/2014) Lots of mods to this CJ-6 or M-170.
“1958 jeep cj-6, sbc 350, nv4500, twin stick dana 20, PTO winch, Currie high pinion 9’s with detroit lockers front and rear 4.88 gears, 37×12.5×17 BFG km2s, aluminum radiator, truck avenger 670cfm, aqualu industries one off aluminum front fenders, LED lights, too much to list. This is a Excellent turn key jeep ready for whatever.”
UPDATE: **SOLD** Was $3500
(01/28/2014) This appears in good shape.
“for sale a 1956 jeep cj6 4×4, 4 cylinder with 3spd manual. jeep is really clean, straight and no rust. runs and drives great and everything works. asking $3500 O.B.O”
Here some parts that might help someone.
“Frame very clean, no damage. Axles very clean and no damage as well. $300 for the frame, and $200 for axles or $400 for both.”
UPDATE: **SOLD** WAS $800.
“have a nice looking cj6 1964. its setting on 79 bronco chassis anf whoever done it looks like they did abgreat job. had a set of 40s on it but being sold asnit looks in the pic. I have the title for it as well. no engine trans or case. your buying the body frame liftnaxles pretty much. 800 cash moneynyou haul.”
UPDATE: **SOLD** Was $3000
Needs battery, but runs.
“1967 Jeep CJ6-A Half-cab
This is a rare vehicle- approximately 400 made. Has a Buick V-6 engine which is probably the original motor. Not sure of the exact mileage, but motor is very stong and this little Jeep is a great runner. You will need a new battery, but once jump-started it runs just fine.
Has a 3-speed transmission with a nice tight clutch. It is very low geared – so great for off-road – but goes down the highway at 55 mph very nicely. I have driven it 40+ miles, and back – several times – and never had a problem. I have also driven it in a few local parades, and it does catch peoples’ eye.
Good brakes – just had them checked and some lines replaced (notice the bent front bumper – that was before the brakes were fixed and a tree stump stopped me). Will need some body work done to restore it to perfect condition.
Speedometer and temp gauge work, but most the others don’t. Horn, windshield wiper, and all lights work. Has a brand new driver’s side seat belt, but passenger belt needs replaced. “
UPDATE: **SOLD** Was $400
Looks like an early CJ-6.
“Early mid 60’s cj6 tub and 2 frames. No front sheet metal it is a roller sitting on later axles amc 20 and dana 30. I do have a second frame same vintage. No paper work.”
UPDATE: **SOLD** Was $3250.
(04/17/2014) This has a variety of updates.
“I’ve had this jeep for 4 years. It is drivable and I take it everywhere. It has 3/4 ton Chevy axles and 24 bolt humvee wheels with 37″ military tires with run flats. It need a little bit of everything and now that I live on the beach I don’t have anywhere to continue working on it. The crazy stuff been done but it does need to be finished. Ie: tie the cage in to the frame, relocate the shock mounts, install the front driveshaft. So this jeep does need to go to someone who has some technical skills and can weld. This cj6 is a rare model and it gets tons of attention. It’s so much fun to own and drive but the time has come to pass it on. It has a Buick 231 v6, rebuilt Buick 350 transmission. I 281 tcase, whatever the full size Chevy tcase is. I’ve got an extra one with the opposite output just case you feel like switching front axles. Front axle is a 10 bolt, corporate 14 bolt rear with welded rear-end. It’s currently registered, insured and drivable. Just a little love. It’s parked in Ocean beach where West point loma ends if you’d like to see it. I’m not in a hurry to sell it and am firm on the price. I’m not interested in any trades of any kind. Thanks. Adam”