To Top

1951 CJ-3A Wyoming $3500

• CATEGORIES: CJ-3A This site contains affiliate links for which I may be compensated.

This has a cab enclosure hardtop.

https://wyoming.craigslist.org/for/d/cj3a-willys-universal-jeep/6606314663.html

“For sale title says 1951 CJ3A Willys Universal. Has hard top and doors. Don’t know if the top is a Artic top, Kelly or Koenig .

Does not run. Engine will turn over by crankshaft pulley. Needs total restoration. Would make good project.”

1951-cj3a-wy

[fb_button]
 
To Top

1960 CJ-5 Bessemmer, PA $500

• CATEGORIES: CJ5 This site contains affiliate links for which I may be compensated.

No pics provided.

https://pittsburgh.craigslist.org/cto/d/1960-willys-jeep-cj5/6604979932.html

“1960 cj5 disassembled down to frame for complete rebuild. Motor, transmission, front and rear axils operational. Frame in good shape. Have title. In my opinion the tub is shot, but have all parts. You will have to hall it all.”

[fb_button]
 
To Top

1951 CJ-3A Chester, VA $2500

• CATEGORIES: CJ-3A This site contains affiliate links for which I may be compensated.

I was just in Chester …. no pics provided.

https://richmond.craigslist.org/cto/d/1951-willys-cj3a/6608988654.html

“The Willys is a work in progress. Lots of new parts. 4 new springs and shackles, new brakes, brake lines and hoses, master cylinder. New exhaust system. Converted to 12 volt, new alternator, New points, condenser, cap and rotor. New fuel pump, New motor mounts. Several more new parts, Needs a wiring harness. I currently have too many projects. Will post pictures when I get time.”

 

[fb_button]
 
To Top

1946 CJ-2A Newnan, GA **SOLD**

• CATEGORIES: CJ-2A This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $600.

Project.

“I am selling my 46 Willy project that I started the work but realized I have too many projects at once. The body is stripped and and started replacing metal but needs floors finished. I have 2 sets of fenders, 2 hoods, 1 rough windshield frame, 2 tail gate, 2 grills, 1 frame with steering and axles and 1 frame with motor, trans and transfer case. I also have adapter to put the 225 v6 in it.”

1946-cj2a-newnan-geo1 1946-cj2a-newnan-geo2

[fb_button]
 
To Top

1958 CJ-6 Yuma, AZ **SOLD**

• CATEGORIES: CJ-6 This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $9000.

(05/05/2018) Has some mods.

“1958 CJ 6 Frame-Off Restoration
Rebuilt 4 cyl. F-Head engine, 3-inch lift kit, Roll bar. New Bestop soft top.”

1958-cj6-yuma-az

[fb_button]
 
To Top

1953? CJ-3A/M-38 Taylor Ranch, NM **Status Unknown**

• CATEGORIES: CJ-3A, M-38 This site contains affiliate links for which I may be compensated.

UPDATE: **Status Unknown** Was $4000

(12/18/2017) Seller describes this as a 1953 CJ-3A. It may be a CJ-3A chassis and M-38 body (seller indicates the body is “new”). It lacks the holes necessary to mount the M-38 grille hinges to the frame.

“This jeep is a 1953 cj3a, but it now has a brand new body tub that is a m38 body. Its just primered to stop from rusting. Lots of new parts rebuilt tcase, and trany diffs have been gone through. The engine turns but hasent been gone through. Its all stock has a doner frame from another jeep. Its like 90%, it does need wireing figured out, or just put new wireing harneses. Also needs brakes looked at, the spring kits were replaced i think not adjusted properly. It stops on one wheel but pedal goes to floor.

We have clear title. Most work was done buy Savios fwd in albuquerque at the time. We dont have the time or money to finnish it. It does retain the factory gauges. The shifters were also cromed out. All the original seats, willys tailgate, no back seat. Some one could easily finish this with alittle time. We got with the intention on converting it to a v8, but would requier to many mods. Plus its a small jeep. Its all original drive train numbers match on diffs, trany engine ect. Some one needs to finish it off.”

1953-m38-alb-nm1 1953-m38-alb-nm2

[fb_button]