CJ-2A Research Archives

CJ-2A, cj2a

To Top

1946 CJ-2A Parts Richmond, VA **SOLD**

• CATEGORIES: CJ-2A This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was Make Offer

There are some useful parts here.

“I have a 1946 Willys Jeep for sale. I have the grill, fenders, and hood that go with it. Missing steering parts. Trying to get it out of the yard. I am open to all offers. Money or trade. Motor ran a year ago, ”

[fb_button]
 
To Top

1948 CJ-2A Ventura, CA $2000

• CATEGORIES: CJ-2A This site contains affiliate links for which I may be compensated.

It runs, but looks rough.

“1948 willys jeep 4cyl runs but needs work good project or ??? was used on ranch for many years registration is currently on NON-OP PINK IN HAND”

http://ventura.craigslist.org/cto/3450790629.html

[fb_button]
 
To Top

1946 CJ-2A Akron, OH $5000

• CATEGORIES: CJ-2A • TAGS: , This site contains affiliate links for which I may be compensated.

UPDATE:  Still Available

(09/28/2012) Bob spotted this one.  That sure looks like a Bobcat fiberglass body to me, based on the wide rear top lip and the steps that taper to the body fold.

“1946 Willys CJ 2
Rare fiberglass, flat fender, military style body.
1960’s Chevy Iron Duke 4 Cylinder engine. 3 speed high and low 4 wheel drive
Summit Racing seats and cushions
Custom pedals
New bikini top
New Cragar Wheels
Wrangler Tires
Some custome diamond plating and ’65 Mustang tail lights
Newer military OD green paint. Alot of work was done to this car.

Call Rick at 330-753-0553

http://akroncanton.craigslist.org/cto/3447453825.html

[fb_button]
 
To Top

1946 CJ-2A Wichita, KS **SOLD**

• CATEGORIES: CJ-2A • TAGS: This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $2000

(11/14/2012) Lots of customization here.

1946 Willys set up for SBC and tranny, tub and frame where stretched 9inches, 4 inch springs over XJ axles, power steering, power brakes, brand new 35-12.5-15 Thornbirds on soft 8 rims, rhino lined inside, with race seats and harnesses, all new wiring and gauges please call for more info”

[fb_button]
 
To Top

1947 CJ-2A Fort Dodge, IA **SOLD**

• CATEGORIES: CJ-2A This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was on eBay.

This is rough with rust. It appears to have a twist looking from the front.

“For Sale a 1947 Willys Jeep with a Clear Title Starts up and sounds good Not the original engine. Has the same # of my friends 1952 army jeep.Was told buy owner that engine had been rebuilt. Then parked in 2003. I put a new gas tank in it & points, master cylnder,& brake lines, plugs. Started up. I have driven it around my yard, but the brakes don’t work. Previous owner has patched the floor & other areas will work to drive as is. Underneath is rusty so is where you see primere. Frame is pretty solid except for right by the front spring mounts, there is alittle bit of rust. I took pictures they will be the last two. if you need more info let me know.THIS JEEP NEEDS A LOT OF WORK BUT IT RUNS & DRIVES & CLEAR TITLE IN MY NAME It is also advertised localy so i reserve the right to end the auction early.

[fb_button]
 
To Top

Year? CJ-2A Junction City, OR **SOLD**

• CATEGORIES: CJ-2A • TAGS: This site contains affiliate links for which I may be compensated.

UPDATE:  **SOLD** Was $1500

This might be worth a look.

“Outstanding project 99% complete only missing fuel tank. Motor was rebuilt at one time but it has sat for a few years now so will need work. email or call for more info.”

[fb_button]
 
To Top

1947 CJ-2A Redding, CA **SOLD**

• CATEGORIES: CJ-2A • TAGS: , , This site contains affiliate links for which I may be compensated.

UPDATE **SOLD** Was $19,500.

Lots of custom work here.

“1947 Willys Jeep built from the ground up, all custom built, 19, 500 or best offer.

SUSPENSION:
4 corner Superior coil suspension, shock hoops front and rear, 22 in. dual Comp shocks in front/singles in the rear, rear 4 link with 3 ¼ in. heim joint, front axel radius arms with knuckle over steering linkage, aluminum cross over support between front coil towers, frame is partially boxed, gusseted and reinforced. 4 corner full backing plate manual disc brake conversion 16 in. aluminum modular rims, with 34 in. supper swamper tsl’s,

ENGINE/DRIVE TRAIN:
Ford 3.8 fuel injected factory air to air super charged V6, after market air intake, new D.I.S. module, coil packs, plug wires, cam shaft sensor, crank shaft sensor, alternator and motor mounts. Custom shorty headers with 3 in. collector, 22 in. glass packs with 3 in. inlet and outlet with 3 in. turnout. Stock electric fan with shroud, stock re-cord radiator with custom chrome cylinder overflow tank.
NP 435 4 speed with overdrive, 6.68 to 1 granny, new snycros, bearings, seals, short throw top cover, 11 in. clutch, finger style pressure plate, new flywheel, all new hydraulic clutch. Cast iron truck style bell housing, Advanced Adapters outlet to Dana “Super 18″ model 20 case, Dana 18 2.46 to 1 gear set 1 ¼ in. intermediate shaft, ½ in. steel stud girdle, screw in grade 8 studs, polished worn gear splitter all range overdrive, custom front and rear drive shafts, all new u joints through out, rear Dana 44 front Dana 27, 5:38 gears with new bearings and seals.

BODY:
Full metal tilt front end with removable fender skirts, removable polished aluminum dash, access panels at firewall, transmission and fuel tank. New Summit racing seats, original rear seat with new seatbelts through out. 6 point fully welded roll cage with dash style front mounts, undercarriage and interior fully bed lined for rust prevention and easy clean up, rear wheel wells boxed for shock hoops, front firewall boxed for engine accommodation. Fully accessible passenger seat box. New stainless wiper motors (wired independently). Pillow block bearing mounted 3 ¼ in. stainless steel steering shaft with borgenson u joints and removable steering wheel. Custom brake and clutch swing pedal assembly, custom front and rear bumpers, 5000lbs Ramsey electric winch. 15 gallon aluminum rear mounted fuel tank, aluminum rear corner diamond plate, new windshield glass. All new heavy gauge wiring front to back, all new lights, lenses, fuel lines, fuel pump, brake hoses, hard lines and new hardware grade 8 through out.”

[fb_button]
 
To Top

1946 CJ-2A Kissimmee, FL **SOLD**

• CATEGORIES: CJ-2A This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $5900.

Check out the front shackles on this.  I have seen similar shackles on an other rig, but can’t remember where.

“1946 Jeep Willys military jeep. clear title. is running good and the 4×4 also work. NO RUST”

[fb_button]
 
To Top

1946 VEC CJ-2A Santa Maria, CA **Status Unknown**

• CATEGORIES: CJ-2A • TAGS: , This site contains affiliate links for which I may be compensated.

UPDATE:  **Status Unknown** Was listed at $3490.
Serial number 14984.

The seller lists this as a 1947, but this is a ’46.

“Selling my black plate 1947 Willys Jeep CJ2a, it’s an early model with the rare column shift. Original color beige.
I have brand new parts for about 1000$, still in the box that comes with it.
The car is unmolested, very original, very little rust.
Comes with two sets of wheels, the original size and a slightly bigger size.
Try to take some pictures today.”

[fb_button]
 
To Top

1948 CJ-2A “Lefty” in Maine $2000

• CATEGORIES: CJ-2A • TAGS: This site contains affiliate links for which I may be compensated.

UPDATE:  Still Available

(11/24/2012) Glenn has his Lefty CJ-2A for sale.

“This is Willys CJ2A S/N 185318, a documented Lefty, as discussed in “Calling All Leftys” on The CJ2A Forum. This is a PROJECT!! It needs EVERYTHING restored. Mostly complete vehicle, rusty body and frame. Frame has been repaired, repaired again, needs more repair now. Body has been off frame, repaired, welded in floors, panels and needs more repair now. Engine, drive train are stock, non running, looks complete, I haven’t tried. Has a rear PTO unit, but needs repair also. As per PO, this Jeep was running when put into storage about 5 years ago. I added stock KH 16″ rims with oversized 7;50X16 tires, took out bucket seats, added stock left seat frame. RH seat is not stock, maybe Crosley. The dash tag is very readable with CJ2A-185318. The frame tag is missing. The ACM Number looks like 17?579 and others in that neighborhood show the third digit might be a 5 or 6. Buyer will research further. This is very near the end of Lefty production as per Willys Service Bulletin 48-27 and less than 20 have been accounted for making this a very worthwhile project. Sold with a Bill of Sale only as Maine is a non title state. I can license and insure legally in Maine as it is. What you need in your state is up to your DMV at your expense.  Email me at glenns@tdstelme.net and I’ll send pix and complete details. Don’t bother me with silly questions like, “How are the hat channels?”. Like I said, EVERYTHING needs repair. Understand this, EVERY bolt will be turned. What level you take this restoration to is up to you. If a real Lefty in your garage is on your bucket list, here it is for $2000. Might partial Willys trade. Call 207-491-one,two,three,Four. Glenn”

http://maine.craigslist.org/cto/3441238826.html

 

[fb_button]