UPDATE: **SOLD** Was $5900.
This looks ready for the hills.
“1954 Jeep Willys CJ3B
4 Cylinder F-Head Engine
3 Speed Manual Transmission with Saturn Overdrive
Great Condition, Runs and Drives Great
$5900.00”
UPDATE: **SOLD** Was $5900.
This looks ready for the hills.
“1954 Jeep Willys CJ3B
4 Cylinder F-Head Engine
3 Speed Manual Transmission with Saturn Overdrive
Great Condition, Runs and Drives Great
$5900.00”
UPDATE: **SOLD** Was $14,625
(06/14/2013) This appears in good shape.
“1954 WILLYS CJ-3B Universal / WIL235642L
Mileage: 45477
Exterior Color: Red
Interior: Black Vinyl
Transmission: Manual
Engine: 4 cyl”
UPDATE: Price dropped to $2800. I like this for the price.
(09/24/09)This looks good and comes with many parts.
“Inherited from brother and all I’ve done is store it for six years and run it once in a while. Don’t really know a lot about the jeep other than the following. Dana 23’s in the front with 35’s in the rear. Engine is 1972 Chevy Vega 140 cu/in (2300cc) aluminum block with steel sleeves. “Tight pattern” Saginaw four speed and all cynchroes work. Custom built “Very stout” rollcage with (6) bolt down locations. Roll bar is tied-in the heater system and has small holes that defog the front window and sides. Padded bucket seats have five-way seat harness system. Padded rear seat w/back rest has seat belts. Has PTO Koenig winch. I personally have never gone four wheeling in the jeep but everything seems to work. Inside floor board has some very light rust. Also has toe-bar and bakini top.”
No pics, but includes an overdrive. It’s worth a look.
“I have a jeep that needs a home where someone will give it the attention it deserves. It has the original motor , 12volt, still has the foot switch starter, Warn overdrive. This is a fun jeep , you could fix it up or keep it as is. Great project. Hasent been registered in a couple years , you would be responsible for that. Sorry no pictures its kind of buried in my garage.
Matt
951-595-Nine0Two7”
UPDATE: **SOLD** Was $1200
“1953 Jeep Willy’s with 4.0 L jeep engine. No Title.
I was building a 6×6 Jeep (if you want 4×4 you can unbolt the rear axle / frame section it is not welded)
The engine has the complete wiring harness, computer, etc. and will run (with a little work)it has had all of the pan gaskets and rear main seal replaced. I had the bell housing reworked by Novak Transmissions to adapt it to the stock T-90 transmission. It has most everything to get it going, but will probably need brake cylinders. ”
UPDATE: **SOLD** Was $6000
(05/11/2013) This is a project.
“1954 Willys Jeep CJ3B
Project Jeep.
Clean Tub
Clean Title
Front and Rear Disc brake Dana 44s loaded with 4:27s and Detroit’s front and rear, Dutchman Axles in the rear
Scout D44 complete (hub to hub) for parts
Rebuilt 350, turbo 350 and model 18
GM Tilt Column with Wood Wheel
Original manual
Wiring harness with labeled wires and manual
33X12.5 Goodyear Wranglers and wheels (never run) including a spare
All part are new or rebuilt, but none have been used since purchase or rebuild.
This is a project Jeep, however all the major parts are included
There are many more parts included not listed or shown
TOW BAR INCLUDED
Military (M100) Jeep trailer also included”
This auction occurs September 20, 2013, at Tewksbury Township, NJ. The 3B looks good.
“1962 Willys CJ 3B 4×4 Jeep w/plow (garage kept);”
http://www.auctionzip.com/cgi-bin/auctionview.cgi?lid=1843458&kwd=willys&zip=&category=0
UPDATE: Was $2500. **SOLD**.
Drive train needs work.
“NO PAYPAL !!!!!! I don’t have the title 1954 jeep Willy’s CJ3B it has original Willy’s Hurricane motor it does turn on but will need to be over hauled main bearing are out on crank shaft it has original T90 transmission and transfercase those will also need rebuilt. It has three kc light on top and vynil cover. Frame and suspension has been overhauled but not recently but in good shape.
It’s a project or parts jeep.
“Good parts or project. Tub is shot and frame will need allot of work. The engine runs well. Been sitting since I bought it a few years back. Plow not included. Has MA title .”
UPDATE: **SOLD** Was on eBay.
The 3B was used as the model for the ICON.
“When we decided to launch the ICON CJ3B, the first thing we did was search down a 100% original CJ3B. We did this so we could get to know it a bit, and to digitize the complete structure and establish a starting point for our CAD modeling work. We found this truck in central California, where it had been it’s whole life. This little CJ has exceptional integrity. It has been sitting for a few years, but it fired right up and runs and drives. Please do not expect to jump in it and go on an expedition. It stops, starts and runs, but you should plan for some tinkering. Rare PTO winch. Original paint. No rust on the body. Zero modifications other than the cheesy wiper switch and rear tire carrier, which could be removed with ease. Original California black & yellow plates. You will be hard pressed to find a more original CJ3B. You may find a shiny one, but you can never beat an original because what you see is what you get. ICON/TLC is a licensed California dealer. Buyer will need to pay $100 document fee above the winning bid. Out of State buyers must use professional transporter and provide bill of lading to be exempt from Ca sales tax and fees. In State buyers must pay DMV fees and sales tax. This truck is stored at our facility in Chatsworth Ca. You are welcomed to come visit it. Please bid to win, scammers please go away and do not waste your time or mine! Thanks for looking- J I put together this short video to show you more details. Thanks, JW”