Paul shared the story behind his one-of-a-kind stainless steel steering column.

Paul writes, The steering column in my Willys has quite a story behind it, …….  About 10 years into the rebuild (1995) I began thinking about what kind of steering column and wheel I’d like to have for the Willys. I wanted a tilt column to make it easier for me to enter and exit the Willys, the steering column and steering wheel should be one of a kind and not some mass produced stuff that everyone has and if at all possible these components should be fabricated from stainless steel to match the rest of the vehicle. I wasn’t even aware of any aftermarket suppliers that made replacement steering columns for custom vehicles but if there was a company in America making replacement columns I figured they would be mentioned in the hot rod or custom car magazines. I began reading all the current car magazines I could get my hands on, searching for any mention of or advertisement from a company making replacement steering columns.

It wasn’t long before I saw an advertisement for a company called ididit and the primary focus of this company was to build replacement steering columns for custom vehicles. Their ad had their address listed along with their telephone number so I made a quick phone call to the state of Michigan and ordered a free catalog. About a week later their catalog arrived here at the house and it was full of information about the company, about how to correctly determine the angle of the steering column and the location of the steering wheel along with internal wiring specs and how to identify the correct column length for your vehicle. This catalog was full of step by step procedures to solve installation problems I hadn’t even thought of yet. According to the catalog, steering columns could be ordered in steel or aluminum (plain or polished) in either standard lengths or total custom units. I was happy.

After mocking up a column in the Willys (a sawed off broom handle with a plastic plate screwed to the upper end) I was able to find the column angle which would give me the least interference during entry and exit while still providing a reasonable position for the steering wheel and this information allowed me to get the total length of the column from steering wheel to column end in the engine compartment. With my calculations in hand I made another call to ididit and attempted to order a column. This is where things got a bit weird. Continue reading →