This ad appeared in the February 20, 1948, issue of the Oxford Leader, out of Oxford, Michigan.
1953 Truck Aubrey, TX $18,000
UPDATE: Note the comments below. The engine wasn’t original to this model and the grille has the vent hole, which didn’t come out until later.
Nice looking truck that has both a winch and a rear PTO gearbox.
https://dallas.craigslist.org/dal/cto/d/aubrey-1953-willys-4wd-pickup/7069198693.html
“1Rotisserie restoration 1953 Willys 4wd pickup, original 226ci motor and manual transmission, collector’s dream. Rare rear pto and heavy duty frontend winch.”
1959 Truck Platteville, WI $8500
Appears in good shape. Unique paint job.
https://madison.craigslist.org/cto/d/platteville-willys-jeep-truck-super/7065555670.html
“1959 Willys Jeep Truck. Very solid body/frame with newer complete paint. I have many pictures of body as we sandblasted everything to white metal to show how solid the Jeep is/was before painting about 8 years ago.
327 V8 from 1969 Camaro with Edelbrock torquer intake and Edelbrock street carb. T90 3 speed transmission.
Comes with 1976 Scout II Dana 44/3:08 front (disc brakes) axle with all parts to renew from knuckle to wheels. Also Turbo 350 transmission with shift kit completely rebuilt and Chevy gear to gear HI/LO transfer case all these extras to be installed by buyer to handle the horsepower and torque of the 327 engine. Runs 70mph on hot July days and no problem with overheating. There is a lifter noise that you need to consider before buying decision is made. The Ahooga horn you see in pictures does no go with Willys as I have had it for 45 yrs and is a heirloom of sorts. The original Willys horn was working when I put Ahooga horn in truck. Continue reading
1960 CJ-3B Chino Valley, AZ **SOLD**
UPDATE: **SOLD** Was $4500.
May need additional work.
“1960 Willys Jeep in Good condition. Runs well with a rebuilt less than 2000 mile Hurricane F head engine With a new head installed and the block Magna-fluxed at the builderWestcoast engines in Oxnard CA. Radiator replaced with high-efficiency aluminum. The clutch replaced at the installation of the engine. Shifts and drives 4X4 operates as it should. Brakes are out but will be redone this week, brake cylinders and shoes plus anything else I find during inspection today. parts arrive Monday. I also am replacing the cracked steering wheel, horn and button to be determined.
Fuel system cleaned and oil changed as the jeep was sitting on my property for two years unused. I am negotiable on the price I am starting at the average I have seen them going for won’t charge any extra for the bullet hole. The more I improve the jeep the less negotiable I will be. I have many extra parts plus a complete engine, needs rebuild, Solex carburetor, odds and end’s that I would include with negotiation.
I just don’t have the time and ambition for this jeep, other projects I’d rather do.
Thanks for reading and I will update pictures as I go along.”
No Jeeps, But Interesting Car Collection For Sale Duluth, MN
This collect of cars caught my eye. The prices don’t seem crazy either.
https://duluth.craigslist.org/cto/d/duluth-antique-cars/7066281398.html
1938 dodge sedan $8500
1923 Model T center door sedan $13,500
1920 White hook and ladder fire engine $6500
1936 Autocar pumper firetruck $6000
1929 International stake body $6000
1929 Ford Model AA grain truck $6500
1924 Ford Model TT stake body $7000
1925 Chevrolet sedan $5000
1927 Chevy sedan $6000
1932 Willys Knight sedan $12,500
1948 Int’l K8 $6500
1948 Ford F-3 Dump truck $8500
1947 CJ-2A Aurora, CO **SOLD**
UPDATE: **SOLD** Was $3500.
Runs and drives, but no brakes.
“1947 Willys CJ2A Flat Fender Jeep
V8 Chevy Engine conversion, Pertronix ignition, Summit electric choke carb, fenderwell headers,runs well.
35″ tires on true bead lock wheels, also has inner liner for running very low tire pressure.
Drive train is all stock.
Have a Scout 2 front axle assembly and a Chevy 4 speed truck tranny with a granny 1st gear that goes with the Jeep.
Have a 9 slot Military grille that goes with the Willys.
This is a total project vehicle that does run & drive, however the brakes do not work at all and the front tires rub on the leaf springs when turning.
I have too many projects, this is a very cool old Jeep that could be one hell of a four wheeler with some work, the granny 4 speed that goes with it will make it good for rock crawling.
$3,500 or best reasonable offer.
Would possibly trade for a good running performance big block Chevrolet, will trade up or down.”
1956 DJ-3A San Angelo, TX $800
This has a DJ-3A body and front clip. It may be a DJ-3A chassis, as it appears to have the rear tank in back. So, it may have a DJ-3A that has been converted to 4WD.
https://www.facebook.com/marketplace/item/293802601591842/
“Frame s/n 10248 good condition, no title, no motor, front and rear propelled axles with drive propellers, T90 transmission, model 18 transfer case, shift levers damaged, by previous owner, both cases will need to be gone thru for possible repairs. Body has holes in flooring and in hat channels, but can be readily repaired with just a little mig welding skill. 4 good CJ rims, axles roll easily. Also offering a CJ2A early block, s/n 23555 if not wanted, will deduct 200$ from 800$ total! Block has no cracks, face original never resurfaced, no pitting on head gasket surface area.”
1947 CJ-2A Ainsworth, IA $1000
Given we can see the cement floor through the gas inlet, I’d say this may need some floor work.
https://cedarrapids.craigslist.org/pts/d/ainsworth-47-cj2a-jeep-body-parts/7068914797.html
“Tub, front fenders, windshield”
1951 M-38 Fredericksburg, TX $2750
UPDATE: Price dropped to $2750.
(12/24/2019) The left side bumperette took a hard hit (see last pic).
https://austin.craigslist.org/for/d/fredericksburg-military-willys-jeep/7068201393.html
“In working order with original motor and transmission. Body is in good condition. New brake parts and a new electronic ignition module has been purchased and will be provided but needs to be installed. Original seat frames, windshield and tail gate have been removed but are still in tact and will also be provided. This jeep is ideal for restoration enthusiasts. It has been used as a utility vehicle on a hill country ranch for last thirty years. Originally purchased from a retired military officer who bought it from the Army when he retired as it had been his vehicle while in the service.
Pickup from seller will require own trailer transportation.”
Flatfender Jeep Bar Howell, MI **Status Unknown**
UPDATE: **Status Unknown** Was $2500.
(02/11/2019) “You may have a cool jeep but you dont have one made into a bar. The only bar ever made from an original 1945 Willys jeep. Great for a patio bar or man cave. seats eight comfortably. Jeep is pretty small compared to newer version. The interior is wrapped in stainless steel for outside commercial food service. Can fit coolers under the dash
and propane grill in back area. Seats 8 or 12 standing. the stainless speed rail is located at the passenger side opening. rolls easily Call 517-599-178six. The only bar made from an original WWII era Jeep.”






























