UPDATE: **SOLD** Was $3800.
Good price, but the body may be a replacement body.
“Clean Willys, with no rust. Was running when we purchased it.”
UPDATE: **SOLD** Was $3800.
Good price, but the body may be a replacement body.
“Clean Willys, with no rust. Was running when we purchased it.”
UPDATE: **SOLD** Was $4000.
The FC-170 appears to have been a dually.
“2 60s FC170 and 150 The 170 has a small block Chevy in it with the adapter. The 150 has stuck motor in it don’t know much about it. Serious inquiries only will not answer to is this still available. Feel free to ask me any questions and I can send more pictures upon request for serious inquiries obo”
No title. This might have a Hudson conversion, but can’t tell for sure.
https://www.facebook.com/marketplace/item/604790331360324
“Will run, no title, sold as is. Located in delta Colorado.”
Maybe worth a look?
https://www.facebook.com/marketplace/item/1289272985279586
“Four-cylinder F head 134.2 in.³. Master kit installed Approximately 30,000 miles on Master kit Rockford clutch assembly Warner T14A 3-speed Spicer 18 transfer case Transfer case and transmission rebuilt Stock differential and drive lines Block crack off of sleeve Good project vehicle”
Seems worth a look. Note that it looks like part of a CJ-5 has been melded onto the driver’s side and rear of the jeep. The original body may have been an MB or GPW.
https://www.facebook.com/marketplace/item/591776329584381
“Helping sell for a family friend 1946 jeep willys it has been converted for 12 volt battery it turns over nicely with starter not currently running need some points and a condenser and a possible carb cleaning used to run 5 to 6 years ago was used on his property no title bill of sale not on record be a fun ranch toy or back woods explorer and get to feel what them army boys felt back in the day”
UPDATE: Status Unknown. Was on eBay.
Bill spotted this GPW that Andy is selling on eBay. The current bid price is $11,100 (but the reserve has not been met).
View all the information on eBay
Here is your chance to own a Beautifully preserved original 1942 Ford “script” GPW Jeep. Very rust free body. Hood numbers and Nice undamaged data plates, serial #18xxx , 4/42 …..has Ford engine and drivetrain. An excellent Start to a museum quality restoration.
Frame etc. are in very good condition, Besides the rear crossmember that has been cut. I have included an original Ford crossmember to replace. unfortunately, Inside of body has various punched drain holes, that could quite easily be welded and patched.All Ford seats are also original to the jeep. Please message me with questions, clean title ..thanks.
Jeep did run before being put into very long term storage, will need to complete going through of all systems to be drivable. Does have original Ford engine block that turns with good compression. I will include the correct ford head. Extra missing parts as needed, including windshield.”
It’s got a Bobcat body and hood. Seems like there is value here. It may have Allstate (or Husky) Hubs.
https://www.facebook.com/marketplace/item/6688351604511666
“1953 jeep cj2a,full fiber glass body,bobcat hood,rear dana 44 front dana 27, no motor or trans or title. Tube fenders that are well built. These are left over parts from my cj3b build that’s the reason for no title.”
Might be worth a look.
https://www.facebook.com/marketplace/item/1670533840050992
“Have some Willy’s cj2a parts. 47 tub and 46-48 frames. Fenders hoods windshield. Looking to get rid of all of it.”
This appears to be a project.
https://www.facebook.com/marketplace/item/888388872435564
“Top end was rebuilt on engine but the new oil line broke causing the lower end to knock. May just need bearings which are easy to install. It was a Shriners car, so interior is not original. Carpet is indoor outdoor. Not sure of rust? Top bows are rusty and not installed. And has all but one fender steps. Rare car. Fun to drive. 6 volts, except to start is 12 volts. Not sure why they didn’t just convert it to 12 volts. Looking to sell or trade toward a 67 to 72 C10/c20 plus cash. Looking for a 67-72 c10. Box full of trim and various parts including a used working speedometer. My hands don’t work anymore so I’m not able to repair it. It’s in East Wenatchee”

UPDATE: Price dropped to $3400.
(04/17/2023) This doesn’t run and has some hat channel rust, but it’s a pretty stock one.
https://www.facebook.com/marketplace/item/530017952636629
“1951 Jeep Willys CJ-3A Clean title It’s all there, nothing missing Brand new seats Brand new windshield All original, never messed with Pics are main description Body is rough Doesn’t run, been sitting for awhile with bad head gasket”