The windshield has the square washer washers. It could use some glass, too.
“1946 Willys Jeep in working condition. It does have some rust. 4×4 high and low works. Manual 3 speed transmission.Asking $3500 or best offer. Cash only.”
The windshield has the square washer washers. It could use some glass, too.
“1946 Willys Jeep in working condition. It does have some rust. 4×4 high and low works. Manual 3 speed transmission.Asking $3500 or best offer. Cash only.”
It seems to have a replacement body with a variety of mods.
“Willys Jeep, exact year unknown but it’s currently titled and registered as a 1945. This jeep has a 4.3 tbi motor with a th350 automatic transmission and a np205 transfer case. Power steering has been added.
So many new parts including:
seat frames, 12 volt wiring harness, fuel tank, painless tbi harness, aluminum radiator, alternator, custom steering column with removable steering wheel, front bumper, custom exhaust, gauges, manual master cylinder setup, battery, fuel pump, etc.
This is a fun little jeep that fits in tight places, for a size comparison this jeep is 59″ wide, a Polaris Ranger is 60″ wide. Asking $3700, may take partial trade for firearms.”
UPDATE: Was $5500. **Status Unknown**
(09/26/2012) It appears solid.
“I am selling a 1968 Jeep CJ6.The engine is the original 225 V6 with a three speed transmission. The transfer case and axles are original. I did install a 2.5″ black diamond lift kit and shocks. The other improvement is power steering with a tilt steering collum. There is a winch mount and custom front bumper. I have a lot of the original nick nacks that were on it when i bought it. Selling AS IS. No returns or warranty.”
UPDATE: **SOLD** Was $6000
Lots of updates.
“Jeep is lifted on new 36×13.5 irocs. Locked front and rear. I do not know what type of lockers but I can find out if you want me to. Motor is a 231 odd fire. Transmission is a sm420. $6000 obo This jeep will be sold as is.”
Looks solid.
“1949 CJ2A Willy Jeep – 351 V-8
Windsor Engine, Body Lift, 33 x 12 X50 Mickey Thompson Tires, Bucket seats
Runs good.
Serious inquiries only”
UPDATE: **SOLD** Was $1000
The engine and the steering has been modified. Looks like the windshield has been used for bullet practice.
“FOR SALE -1948 Willy’s Jeep-this is a project vehicle-adapter plate to original transmission-engine 2.5 4 cylinder Chevrolet motor-engine is bad-Extra rebuilt motor in garage goes with. Clear Nevada Title.”
UPDATE: Was listed at $2950. **Status Unknown**
Not perfect, but runs and drives.
“1974 Am General Jeep DJ-5 RHD. Rear wheel 2WD with automatic, 232 CID in line 6 cyl. Fully Functional and ready for mail route. Odometer functions and shows a little less than 73K, but being 40 years old I have no idea if that is correct. Tires very good, brakes and steering recently adjusted. Just installed new radiator and wiper blades 3 weeks ago and new Duralast Gold battery 4 weeks ago. I purchased this in January of this year to use on a rural mail route as a part-time carrier, and used it several times on the route, but was just hired as a full time driver for Fedex, so I no longer need it.
Previous owner replaced many parts and I have his service/parts records as well as my own. Cosmetically, it’s not by any means perfect, but it’s not a certified clunker, either. I have not had it tested for emissions so I have no idea whether it will pass or not. It does run and drive good and I have a clean title.”
UPDATE: **SOLD** Was $3300.
Looks like a good start on a project.
“Great project vehicle!! Hard-to-find 1952 Willy’s Station Wagon; 283 Chevy engine with stock Willy’s running gear with Warn overdrive. I have all glass, window frames, gauges, seats, wood boardrunners in back passenger floor area, chrome strips, bumpers & insignias.”
UPDATE: **SOLD** Was $1600
“Very complete and original 1951 M38 Jeep project. 24 volt system is intact ! All nomenclature plates / data tags present . Serial number MC34482 Date of Delivery 9/1951. Needs Resto , ran when parked, motor turns freely . LOTS of parts included, like the windshield frame and pioneer tools , etc. Bill of Sale Only”
A rear PTO unity is available, too.
“This is a Willys Jeep 4×4 Flatfender project. Very solid 1960ish CJ3B frame–chosen for its strength above all other flatty frames. Currently has a 4.3 Chevy GM Vortec motor ( condition unknown–assume its an anchor! ) with 4 speed auto and adapter to Jeep transfer case. Includes a previously installed MD Juan All Steel replica tub, in need of a some floor repair but nice and straight. Also have all steel nose and windshield frame, your choice of M38 , CJ2A , CJ3B , or MB GPW . I also have available a 1951 Willys military M38 flathead motor that runs great if you want to build a cool Tribute Jeep. Also have a 1969 Camaro Z20 M21 close ratio 4 speed adapted to a late model 18 transfer case with Hurst shifter if your building a hotrod Jeep . PTO winch setup available too, and PTO rear unit for Ag Jeep”