UPDATE: **SOLD** Was $15,000.
You can learn more about them on the CJ-3B Page: https://cj3b.info/Siblings/SurreyPepsi.html
UPDATE: **SOLD** Was $15,000.
You can learn more about them on the CJ-3B Page: https://cj3b.info/Siblings/SurreyPepsi.html
UPDATE: **SOLD** Was $6500.
Craig spotted this one. It’s not clear whether the plywood in the back is hiding the floor or protecting it.
“1963 Willys Jeep FC170. 6 cylinder, 3 speed, 4 wheel drive. Clear PA title, runs and drives. Plow and mount included. Additional parts are available.”
Some creative use of diamond plating.
“1949 willys cj3a clean title is in process of restoring. original motor..134 ci 4 cyl flathead 3speed transmission locking hubs light bar 12000lb winch military tires 6500.00”
UPDATE: **SOLD** Was $4500.
(02/15/2017) Looks in good shape.
“1979 Jeep DJ-5G Postal Jeep
just inspected, good through 10/17
this vehicle was retired in 1992, and stored inside until 2010 when I fixed it up to use as a daily driver
AM General 121cu Engine (Audi/VW casting)
Holly 2 barrel carb
Rear wheel drive
Right hand manual steering
Manual drum brakes
3 speed chrysler 904 automatic transmission
Solid frame and body, rust holes treated and covered with patches, could use proper bodywork if desired
Runs strong, engine takes a few minutes to warm up when cold
Odometer says 77k, most likely 177k, 25K being from myself
Original mail tray included”
The passenger side indents have been removed.
“1951 Willys M38 Jeep for sale, restoration project.”
Looks like the sides of the tub have been rebuilt.
“First year of civilian Jeeps. Rebuilt tub floor all new, new temp and ampere gauges, new wheel cylinders, flat head 4 cylinder with good transmission.NO SHIPPING AGENTS. PAYPAL OR OTHER SCAMS.’
According to the seller, this is “Immaculate and almost entirely original”. I’d sure like to see those rare CJ-2A 1944 data plates!
“Manufactured in 1944 and decommissioned in 46′ for civilian use. Manual 3 speed long throw shift. Beautiful body with a non-stock rag-top and vinyl door set. 4 wheel drive locking hubcaps on the front tires with high/low settings. Runs great and has no problem reaching max. speed posted on plaque on dash. Fun to off road in. Immaculate and almost entirely original. Vacuum window wiper motors, original army rucksack seats, original wooden carry-on tool box, back bench equip but not mounted for fear of ruining genuine body.
Original flat head 4cyl with refurbishment. Switched out the old 6v generator for a 9 volt. DOES NOT REQUIRE LEAD ADDITIVE – Just takes regular oct.
Can find parts and accessories all over especially online. Driven to several Willys conventions and festivals. Great addition to any parade or Dealer’s car lot.
A head turner for sure.
Included:
Lights work great and unmounted full turn signal kit will be included
Seat belt kit
Extra thermostat
“Dummy” Training grenade ready to be mounted as new shifter handle
M1 US army helmet & goggles for extra protection
New Horn button
Extra Speedometer cable
and much more to keep you busy on the weekends.”
https://fortwayne.craigslist.org/cto/6013220101.html
Some work need completing.
“1951 CJ3A WILLY JEEP – ABOUT 80% RESTORED – GOOD ENGINE, TRANNY, REAR END. MANY NEW PARTS: BATTERY, BRAKES SYSTEM, WIRING, SHOCKS, SEATS, ELEC WIPER, BEMINI TOP, TANK, CD STEREO AND MORE. SEAT BELTS AND TURN SIGNALS. MY BACK WENT OUT AND HAVE TO SELL. NEEDS STEERING GEARS REPLACED, SLOPPY STEERING. PRIMED TO PAINT. CLEAR FLORIDA TITLE. FIRST $4900 GETS IT. DELAND. PLEASE NO DEALERS OR LOOKERS. SERIOUS INQUIRIES ONLY”
It’s a project.
“I HAVE A WILLYS CJ2A PROJECT THAT WAS TORN DOWN 15 YEARS AGO TO GET UPDATED THEN THE OWNER LOST INTEREST.
THE BODY COULD USE A LITTLE WORK FLOORS ARE SOLID BUT THE PASSENGER SIDE PANEL COULD USE SOME WORK TO MAKE IT NICER BUT IS USEABLE AS IS. IT CURRENTLY HAS A 1972 FORD 2.0 ENGINE WITH A WEBER CARB THAT SHOULD RUN WITH A BIT OF WORK. THE TRANSMISSION IS A HEAVY DUTY T-18 WITH A DANA 18 TRANSFERCASE ON THE BACKSIDE. 33 INCH TIRES, 4 INCH LIFT, ORIGINAL AXLES AND BRAKES, REAR FUEL TANK, SAGINAW POWER STEERING SET-UP, CUSTOM SKID PLATE UNDER TRANS/TRANSFER, NICE BUMPERS, TOW BAR, SIX POINT ROLL BAR IS INCLUDED BUT NOT INSTALLED. WHAT YOU SEE IS ALL I HAVE FOR IT. ASSEMBLE IT OR USE IT FOR PARTS. $1000.00 OBO
POSSIBLE TRADE FOR A NICE WELDER OR OTHER JEEP PARTS / PROJECT / VINTAGE SIGNS”