UPDATE: **SOLD** Was $4200.
(10/14/2014) Runs and drives, powered by Studebaker.
“RARE JEEP WILLY
STUDEBAKER MOTOR
RUNS GREAT
EXCELLENT CONDITION
HAS ALL 4 ORIGINAL HUBCAPS
IT IS A VERY RARE VEHICLE”
UPDATE: **SOLD** Was $4200.
(10/14/2014) Runs and drives, powered by Studebaker.
“RARE JEEP WILLY
STUDEBAKER MOTOR
RUNS GREAT
EXCELLENT CONDITION
HAS ALL 4 ORIGINAL HUBCAPS
IT IS A VERY RARE VEHICLE”
This includes a warn overdrive!
“1953 Jeep CJ3a chassis ONLY, complete with diff, tranny w/overdrive and front diff. Also has towbar. Tires don’t go with it.”
Definitely needs paint, but there could be value here.
“1947 willys cj-2a with f head engine. Rebuilt carb. New coil,plug wires,plugs,cap,rotor and points. Runs but needs points adjusted”
UPDATE: **SOLD** Was $3800.
Runs and drives.
“46 Willy’s jeep with fuel injected Chevy 4.3 with Chevy truck 4 speed it has on board air, heater,tilt wheel,power steering, disk brake up front, spring over lift with 33 inch tires,converted to hanging pedals, power brakes,locked front and rear,newer top and doors, rebuilt Dana 18 transfer case,electric wiper, no rust. runs and drives great ”
UPDATE: This looks like a good deal for only $500. I’m not surprised this sold quickly.
“1947 Willys Jeep
Rebuilt L head
Needs TLC”
UPDATE: **SOLD** Was $395.
“Selling JEEP M38A1 body which fits from a 1953-1971 Chassis (M38A1 or CJ-5)
-Southwest Jeep with no rust.
-Rear seat brackets attached.
-Fairly straight body
-As you can see in the photo, the floors are straight and solid with the original ribs
-Inside toolbox like new
-Under gas tank is solid floor
-Fender walls are straight
-Dash has radio cutout, though can be easily changed out. (bolt on)
-Rear panel was cut out for tailgate, however, rear panels are available
THIS IS A GREAT REPLACEMENT FOR YOUR RUSTY OLD JEEP BODY!!”
UPDATE: Price dropped to $2300.
(04/03/2015) Doesn’t run.
“1962 WILLYS KAISER FC-150 PARTS PARTMOBILE or BUILDER
4 cylinder Hurricane includes clear New Mexico USA TITLE (not a salvage).
I am really reluctant to get rid of my recently acquired FC, but I am slowly realizing I will not be able to get to this project. If you are interested, I have many more pictures on my personal website I can give you upon request.
This FC has been a long time resident of Northern NM and has some body wear, damage, and floor board rust through; however, the frame and axels are very, very straight and free of rust. I was almost shocked to see how true and easily a frame off restoration from this platform. The body will be the challenge.
The driver’s door is racked, much of the glass is broken up front. I have not tried to turn the engine over and was told the L134 Hurricane engine had not been started in years. The entire drivetrain is there. I did remove the ‘farmer Joe’ hoist in the back. ”
This looks like a great price. Only the hardtop is for sale.
“I have a complete Koenig hard top that has been installed on a 1948 CJ2A. The top has been on the CJ garaged for 25+ years and is rust free but does have minor dings and dents; nothing major. Driver and passenger windows function but the glass is cracked on both. I have removed the top from the CJ.”
Looks like a good price for the set. They are 11″ wide.
“Selling two pro-comp wheels, used but in perfect condition. 15” wheel diameter, “11 wide, 5×5.5″ bolt pattern.”
Parts jeep.
“This is a parts 1946 Willys CJ2A Jeep. The seats were recently sold with the MB I had for sale. It has axles, tranny/tcase, driveshafts, early CJ5 rims, 4 misc rims, and a couple gauges that are usable.”