Check out the rims on the CJ-2A. I’ve never seen rims quite like those. I don’t have any specific information, other than the pics.
CJ-2A:
CJ-3A:
Check out the rims on the CJ-2A. I’ve never seen rims quite like those. I don’t have any specific information, other than the pics.
CJ-2A:
CJ-3A:
UPDATE: **SOLD** Was $1000.
(09/23/2010) There might be some value here. The cage appears to be a little too tall to sport a normal top.
“I am selling a 1946 jeep willys 4×4. It has a ford v8 289 with an auto three speed tranny. It has an advanced adaper kit that has the original dana 18 t-case. It has a edelbrock 4 barrel carb, with a torkker intake, and headers. It starts and runs rough, but it needs the front brakes redone, because the original drums just don’t cut it. It is in pretty good shape, all lights work, and i even have a title for it. I need 1500 because that is what i need to fix my boat. That price is firm so if you don’t want to pay than don’t bother. e-mail me at the above link and i will get back to you a.s.a.p I will even call if you leave you phone number thanks for you time.”
No green paint was spared in the coloring of this jeep.
“Willys jeep runs good. Nice tuckroll seats. Has military tires good condition. Has been stored in barn for years pulled it out put in gas fired right up. Front wheel cylinder is sticking. Clear title. Would be good restoration project! Phone 9185330661.”
A big project yes, a “good project”? I don’t think so. If only character was valuable, this might just fetch $35k at a Barret auction.
“Not sure what year it is. Has a motor in it, but would need work. Good Project.
(501) 4 1 6 – 6 1 0 7”
UPDATE: **SOLD** Was $4000.
Looks like it could be solid, but hasn’t run in 3 years.
“Work jeep with soft top. 4 cylinder. Was running when last used about 3 years ago. Snow plow included. Garage kept. NADA average retail value of $10,165.”
UPDATE: Was priced at $900. **Status Unknown**
“im selling my project all running gear work and in good shape motor is half complete so will need to be replaced tiers are 31″ on 15″ rims and only have 3000 miles on them. i will be interested in trades just make an offer. ”
This appears solid.
“i have a 46 willys jeep for sale runs rives good has 302 4 speed twin stick tcase has near new 33inch tires nice soft top and soft doors and full cage nice jeep 6500.00 trade for quads toyota ????????????”
UPDATE: **SOLD** Was $3500
This needs an engine rebuild at the very least.
“1948 WILLYS FLAT FENDER JEEP. 4CYL. 3SPD. W/OVERDRIVE .RUNS BUT SMOKES SO PROBABLY NEEDS RINGS ?. I WAS GOING TO PUT A CHEV. V-8 IN IT, BUT WENT ON TO OTHER PROJECTS. NICE PROJECT . $3500.00”
UPDATE: **SOLD** Was $35,750.
Bill spotted this … as he suggested, sit down …. the auction estimate was $12,000 – $17,000 which in itself is an inflated price in my opinion. However, this past weekend this franken jeep sold for $35,750.
“63 hp, 134.2 cu. in. flathead four-cylinder engine, Carter carburetor, three-speed manual gearbox with low-range, four-wheel drive with live axles front and rear with semi-elliptic leaf springs, four-wheel hydraulic drum brakes. Wheelbase: 80″
– From the Bill Jacobs Collection
– Only 578 miles since total nut-and-bolt restoration
– Original Forest Service Jeep with shovel and axe included
– 4WD with low range, trailer hitch, full gauge package
The 1946 Jeep offered here is beautifully finished in white. It was reportedly the property of the US Forest Service and carries the appropriate axe and shovel. It was the subject of an extremely detailed two-year restoration in 2001 by Jim Neirynck of Macomb Township, Michigan.”
UPDATE: **SOLD** Was $500
There’s some value here. Looks like a good cage and the body appears solid too.
“This is a 1948 CJ2A with a clear title. It is sitting on a DJ frame and has a center mount Dana 44 rear end. The floor boards are rusted but the toolbox and dash are good. The windshield frame,hood, fenders and grille are also good. Pretty nice rollcage. No drivetrain.”