Not sure how much value is here.

“1947 Willy’s Jeep 4 cylinder motor.
$500.00 OBO
It has been sitting under a tarp for 12 – 15 years. The motor is seized. Floor boards are gone and has lots of rust with scale rust on the frame. Seat frames are rusty with no material left on seats. One tire is flat and one wheel is locked up. This jeep has sat a long time. This will be sold in “AS IS” condition as I have described to the best of my knowledge. I would suggest this is a “Parts Only” vehicle. It’s NOT running, not drivable and must be trailered. It also has a good clean title. ”

http://akroncanton.craigslist.org/cto/5723060805.html

UPDATE: **SOLD** Was $2500.

(03/03/2015) The front wheels look out of alignment to me.

“48 Willys Jeep. Runs but needs some minor work. Windshield is cracked. Needs a new battery. Have title.”

UPDATE: Still Available.

(06/01/2016) Doesn’t indicate if it runs or not.

“1947 Willys Jeep flat fender, 4cylinder flat top head, winch, tow bar, trailer available for $800 more, 4X4. Come look.”

http://dallas.craigslist.org/dal/cto/5703408541.html

UPDATE: **SOLD** Was $4500.

(07/19/2016) Includes a Warn winch and overdrive. Could be a great price.

“I purchased the Jeep in 1991. It was kept on my ranch in Meeker until 2012 when I sold the ranch and brought the Jeep back to Eagle.It has a Buick V-6 motor which I believe is either a 231 or 232 cubic inch. It also has a tilt steering column from the same vehicle. The jeep has a winch and a 3 speed transmission with a high/low splitter. It also comes with a full soft top and a bikini top. It has a top speed around 65 mph on the highway and is a lot of fun to drive off road. It has always been stored indoors while I’ve owned it. It’s at eagle auto consignment in eagle and can be seen anytime.”

UPDATE: **SOLD** Was $1000.

Has a running f-head.

“1946 CJ2A for parts or restoration. Most parts are there, obviously it’s a bit rough. Has good running F-Head 134 Hurricane engine from later CJ. Windshield frame is complete but will need some attention, glass is plastic. This was originally a rare column shift model – some of the shifter parts are still there. Has transmission and transfer case. No seat frames. Many of the parts will fit CJ3A and CJ3B Jeeps (CJ-3A, CJ-3B)

VIN on clear title matches frame plate, but the firewall plate is gone. New ones are available, though.
Asking $1,000 with the motor, $750 without motor. $550 for only the running F-head engine.”