UPDATE: **SOLD** Was $3000
(07/18/2014) Needs work of some kind.
“1947 jeep cj2a willys project, needs new home.
dad wants to sell, more that he could handle.”
UPDATE: **SOLD** Was $3000
(07/18/2014) Needs work of some kind.
“1947 jeep cj2a willys project, needs new home.
dad wants to sell, more that he could handle.”
UPDATE: **SOLD** Was $1500.
There could be value here.
“Have an 1946 Jeep Willys CJ-2A and various extra parts for sale. A great restore project. Been kept in a barn for the past 10-15 years but was working fine when it was last ran. Trying to clear things from the barn so can’t get great pictures at the moment but posted what you can see. Email only.”
UPDATE: **Status Unknown**
Seller has three jeeps in different condition and prices.
“We have 3 Willys Jeeps that have been sitting in the barn for about 30 years. One is complete with overhead valve engine and plow ($1200) One has flathead engine and the cab has been cut up and replaced with plywood ($1000) and one is a rolling chassis only ($500). Make an offer on the lot or individually.”
It’s a project that might have been a VEC CJ-2A at some point.
http://rockies.craigslist.org/cto/5119085804.html
“This is a nice project jeep that I have invested twice that asking price, it is just becoming painfully obvious that I just don’t have the time to work on it.
1946 Willys CJ2A with Dana 44 front and rear axles from a Wagoneer.
The tub is in very good condition, only a small hole in the driver’s side floor board, could easily be fixed, I have purchased (but not installed) new pans to weld in for both sides, Those will come with.
Continue reading
UPDATE: Was $1500. **SOLD**
Looks like a great price.
“1946 Willys CJ2A early column shift model motor and running gear complete has not been started in 10 years, engine turns free. Will need floors and restoration. This is a would be a worthy project or parts vehicle”
Listed as a 1942 Army Jeep, this is a CJ-2A. It appears the driver’s side has been altered.
“Willy Army Jeep stored in my Dads Barn for sale
My Dad used it for driving around his farm.
Thank you for your interest”
Needs some work, but looks solid.
“Body is solid for its age. Motor ran a while ago but has not been started in a year. Need the brakes redone.”
UPDATE: Price dropped to $5000.
(06/18/2015) Needs more work and is missing a few things.
“Have a 1946 Willys Jeep for sale. New paint job, new front seats with 5 point harness straps, new tires (29 by 8.50), all floor boards have been replaced, custom gas tank that is underneath the back floor board. A lot of work and time has gone into the restoration of this Jeep. Original engine that does run, but needs some work. 4 cylinder 3 speed manual transmission. 4 wheel drive DOES work and has been tested. Comes with rag top. This is a great mudding Jeep if you like to play and get dirty on the weekends.”
UPDATE: **SOLD** Was $7500.
It’s a project.
“FLAT FENDER WILLYS PROJECT
New Toledo body with script including windshield, tub, tailgate, front fenders, hood
Rebuilt Go Devil motor 4 cylinder flathead
12 volt electronic ignition
New brakes from backer out including drums
New master cylinder and lines
New springs and mounting hardware
New exhaust system
New wiring harness — not installed
Hot dipped galvanized frame and parts (rims, seat fames +)
Many extra parts including transmission and steering column to make 3-on-the-tree, extra rebuilt engine
Chasis is finished
Rebuilt axles
Transmission transfer resealed
All stock parts used”
UPDATE: **SOLD** Was $1800
(09/27/2014) Motor is stuck.
this is an ok jeep
has been in the barn for 25 years,
after a washing here it is,
has a 4 cyl engine, its stuck, Im guessing motor is from a cj3a hurricane
the tub is intact, and looks good its been patched and has old jeep rust
I have the seat frames. the windshield lays down and also flips open
frame, springs , drivetrain are very good
look at the pictures Its not pristine
a heater was installed under dash