UPDATE: **SOLD** Was $2250.
If it includes the winch, this looks like a good price.
“HAS A 4 CYLINDER FLATHEAD MOTOR THAT RUNS GREAT.
NEEDS NEW BREAK LINES
****READY TO GO IN MUD NOW****”
UPDATE: **SOLD** Was $2250.
If it includes the winch, this looks like a good price.
“HAS A 4 CYLINDER FLATHEAD MOTOR THAT RUNS GREAT.
NEEDS NEW BREAK LINES
****READY TO GO IN MUD NOW****”
UPDATE: **SOLD** Were $7200
Looks like a flat fender body (mb? or vec CJ-2a?) has been dropped onto a 1979 CJ-5 chassis.
“Titled as a 79 cj5 but hav a 48 willys title that came with the tub. Has a 302 v8, t18, dana 44 front, custom 35 spline 9 inch rear, 4:56 gears and Detroit lockers f/r, wheelbase stretched almost 10″, all new wiring, gauges, custom seats, full cage, tilt steering, wildwood brakes and clutch. Motor has new water pump, oil pump, gaskets and seals, alum rad, optima red top, spring under, waggy spring up front, 4″ BDS springs rear, 35/12.5/15 BFG MTs about 80% and one for a spare. Body isn’t great. Only needs a little bit to be perfect. I drive this everywhere. Hate to get rid of it.
$7200 with hardtop $6200 without or may take a partial trade on good gas mileage car or truck. Got a soft top but it’s rough.”
UPDATE: **SOLD** Was $7500.
“Original flathead 4 cyl motor, runs great, previously restored and makes heads turn. Have clear Florida title.”
UPDATE: **SOLD** Was $2200.
Not perfect, but looks like a great price assuming it runs.
“1949 Willys CJ3A. New 4 cyl motor 6 years ago. Also has an 8,000 lb wench. $2,200 OBO”
UPDATE: **SOLD** Was $650.
It looks like there’s value here. This was listed a few days ago, but I didn’t see it.
“For sale (2) 1960ish Willy’s Jeeps for parts, no titles, as seen in photo, will not separate or part, go to crusher on 11/22/2013”
UPDATE: **SOLD** Was $7500.
This appears to have early CJ-2A tags on the dash. So, there might be some 2A on the jeep as well. The front bumper has been shortened.
“1950 Jeep Willys 4×4. Always garaged. Lots of extra parts; transmission, rear end, gas tank and more.”
UPDATE: **SOLD** Was $4000
This might make a good parade jeep. I’m not sure why the gas inlet has been altered.
“I have a 1951 cj3a for sale or trade for a 18ft pontoon. lots of new parts.”
UPDATE: Was No Price. **SOLD**
This is listed as a 57 jeep, but looks like a CJ-3A to me.
“1957 willys jeep 4×4. Awesome piece of history. These things were built well. Made to military standards. Motor has been rebuilt and runs great. Trans shifts good. 4×4 hi and low works well. This would be a cool jeep for a swap or restore project or drive it as is.
Interested in 4×4 rigs. 4×4 four wheelers or anything of real value that interests me. Just ask.”
UPDATE: Still Available
(11/07/2013) This is a project that has a F-Head installed.
“1949 willys cj3a
Almost all new
New tires
New suspension
Rebuilt engine
Rust free body
Just needs a new carburetor
I just don’t have time to finish it
I will move on the price ready to sell
Dana 44 axles
T90 transmission
4 cylinder
4×4”
UPDATE: **SOLD** Was No Price.
The body and cage look in good shape.
“I have a willies jeep body that was used on a rock crawler its just the body has a roll cage gauges head lights tail light and the body wire harness”