CJ-3A Research Archives

CJ-3A, CJ3a

To Top

1951 CJ-3A Cameron Park, Ca **Status Unknown**

• CATEGORIES: CJ-3A This site contains affiliate links for which I may be compensated.

UPDATE:  Status unknown.  Price was $1700.

It’s a project.

“This is a project that I just can’t seem to finish. No more motivation, interest shifting back to old Camaros.
Here’s what it has:

New frame made from 2×3 and 2×4 box steel, stretched 8 inches (original frame comes with it)
Tub, stretched 8 inches in the cab, no tailgate
Stock flat fenders, grille and hood
Windshield frame with good glass (glass is out) and wiper motors (unknown if they are operable)
YJ springs, spring over configuration
New shackles, spring mounts and spring bushings
Dana 44 rear axle with 5.38 gears (stock)
Narrowed Dana 44 front housing from 75 Dodge, with outers from 85 Power Wagon and new rotors (no axle shafts, unknown R&P)
New Cragar black 8 hole 15×10 rims
New Dunlop Mud Rover 35×12.50r15 tires (rolled in and out of the garage a few times)
76 Chevy tilt steering column with new GT steering wheel
Two high back bucket seats
Buick 231 engine (disassembled, unknown condition, was going to have it rebuilt) with a Holley and Edelbrock aluminum manifold
Ford T18 tranny (unknown condition)
Dana 18 T-case (disassembled, unknown condition)
Has VIN plate and clear title, currently non-op status

With the stretch and the springs mounted to the bumpers, wheelbase is 96″”

[fb_button]
 
To Top

1956 DJ-3A? Caldwell, ID **SOLD**

• CATEGORIES: CJ-3A, DJ-3A • TAGS: This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $2000

(02/11/2012) There might be some good value here, though it needs work of some kind.

“1956 CJ3A Flat Fender Fiberglass Jeep on a 69 CJ frame, Spicer 44, Locker Front End, Straight Thru Transfer Case, Narrowed 9″ Ford Rear Diff, Chevy 350 w/ Aluminum High Rise Holly 4 Barrell, Headers, RV Cam, Turbo 400 Tranny, B&M Shifter. Super Swampers. This is a parts jeep or a major project. Must be trailered home, Located at the Caldwell Airport in a Hangar. $2,000”

[fb_button]
 
To Top

1949 Flattie Linwood, KS **SOLD**

• CATEGORIES: CJ-2A, CJ-3A This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $1000

(01/03/2012) I’m wondering if this is a fiberglas body?  The driver’s seat and steering has been moved to the middle.

“1949 Willys Jeep no title. Dana 60s axles, this is a project that needs just a little work to be finished, has transfer case and turbo 350 transmission, will include running big block 454. Started as a project don’t have the room and wife says it has to go.”

 

[fb_button]
 
To Top

1952 CJ-3A Tucson, Az $5000

• CATEGORIES: CJ-3A • TAGS: , This site contains affiliate links for which I may be compensated.

This looks nice.

“I HAVE A 1952 WILLYS JEEP, V6 BUICK ENGINE , NEW TRANSMISSION, DANA 44’s, POWERSTERRING, TILT, NEW TIRES, PAINLESS WIRRING KIT, NEW INSTRUMENTS!!! SUPER CLEAN WITH POWER….. I’M ASKING $5000 FIRST ONE WITH THE CASH TAKES IT!!!!! NO EMAILS …PLEASE CALL OR TXT ME AT 520-444-1870 FOR MORE INFORMATION ….IT’S ONE SWEET JEEP!!!!”

http://tucson.craigslist.org/cto/2867862950.html

[fb_button]
 
To Top

1952 CJ-3A Pottsville, PA **SOLD**

• CATEGORIES: CJ-3A This site contains affiliate links for which I may be compensated.

UPDATE: *S*OLD** Was $4800.

Those rear rollbar angles have the strangest waves.

“1952 Willys “Farm Jeep” CJ3-A for sale. Mostly original vehicle. 4 cylinder, runs good, lock-out hubs, four wheel drive, hi/lo all work good. 6 volt electrical system, snow plow, new seats. Good PA title, vehicle not inspected. I use it around farm for towing, hauling, plowing snow. This is one of the most sought-after Willys civilian Jeep models, would make a great candidate for restoration project, or just have fun with it as is.”

[fb_button]
 
To Top

1950 CJ-3A Springfield, OR **SOLD**

• CATEGORIES: CJ-3A • TAGS: , This site contains affiliate links for which I may be compensated.

UPDATE:  **SOLD** Was $3000.

(01/23/2012) This looks like a good price.  It is still 6 volt.

“This is a very fun and reliable toy. 4 cylinder motor, was government owned for most of it’s life so it was well maintained. Has some rust but not much. 6 volt system all works. i have parts for a full top and doors that need to be repaired. this is a lot cheaper than a rhino, terex or the other side by sides and you can drive it on the street too. License is current. it has had a lot of parts replaced, it is ready to use.”

[fb_button]
 
To Top

1951 CJ-3A? Summerville, Ga **SOLD**

• CATEGORIES: CJ-3A This site contains affiliate links for which I may be compensated.

UPDATE: Was $6900. **SOLD**

It appears solid, but also appears a mixed bag of parts.

“This jeeps runs great it’s a little stock,restoration and custom….military wheels and tires 4 cyl motor three speed tran…only serious offers please!!”

[fb_button]
 
To Top

Year? Flattie Labelle, Fl $3000

• CATEGORIES: CJ-2A, CJ-3A, Unusual • TAGS: , This site contains affiliate links for which I may be compensated.

After closer inspection this looks in good shape, despite the crazy body.

“Willys Jeep in great condition, runs great, new tires-tsl super swampers, 4sp twin stick transfer case.  Please email or call me with any questions you may have. 863-673-3362”

http://fortmyers.craigslist.org/lee/cto/2865620067.html

[fb_button]
 
To Top

1952 CJ-3A Body and Parts Moberly, Mo $650

• CATEGORIES: Body Parts, CJ-3A This site contains affiliate links for which I may be compensated.

The seller is selling the body/fenders/tailgate/windshield.

“I am selling the body to my 1952 cj3a minus the grill. I am restoring my jeep back to show room condition and this body will not work. If you have a project jeep you need parts for or you are building a rock crawler this body might be what you need. The windshield frame, tailgate and hood are still in good condition. The flat fenders need sheet metal work on the mounting bracket locations. The body tub needs work but the firewall, dash and top cowl are in good shape. Its the floor that needs the work. The body panels are reusable depending on your needs. The body parts are all stamped WILLYS as well. I will take $650.00 CASH ONLY. I am keeping the grill and I will not sell individual pieces. A new windshield alone is $600.00 so $650.00 is my bottom dollar. 660-676-9707”

http://columbiamo.craigslist.org/pts/2863446070.html

[fb_button]