UPDATE: **SOLD** Was $750.
(05/21/2016) Not sure there is much here.
“complete jeep. engine runs trans has clutch issue. title not in hand but it is available through dmv if anyone is interested..”
UPDATE: **SOLD** Was $750.
(05/21/2016) Not sure there is much here.
“complete jeep. engine runs trans has clutch issue. title not in hand but it is available through dmv if anyone is interested..”
UPDATE: Price dropped to $2500.
(04/29/2016) Runs and drives.
http://maine.craigslist.org/cto/5644288804.html
“This is a 1954 CJ-3B with an F-134 Hurricane 4 cyl, T-90 Transmission and D18 Transfer case. Starts instantly. Runs, drives, shifts, and stops.
Frame:
Overall excellent. Some rust in spots but no rot or evidence of repair.
Body:
Looks good at a glance but does have a lot of patch panels and bondo. Depending on your plans the body is solid enough for a “driver” quality Jeep but beyond that it is questionable. This would be a good candidate for a new repo tub or better donor tub. My guess is the existing tub would be more effort that it is worth should you remove all the bondo, patches, and try to restore to original. Tough to tell for certain until you get into it though.
Continue reading
UPDATE: **SOLD** Was $3500.
This is a custom build.



“High hood flat fender with a 1965 mustang 289 v8 with top loader 4 speed.
The pros:
newer custom postal jeep (DJ-5) frame..clean and primered black…
very little body rust
stamped willys tailgate and grill
Custom stainless bumpers front and rear
1965 mustang 289
eldbrock performer manifold,
AFB carter carb
Mallory unilite distributor
Griffin dual 1” core Aluminum radiator
SPAL 2800cfm electric fan
aeroquip high pressure fitting with stainless steel braided lines for fuel and power steering lines
Saginaw power steering
top loader four speed manual
axles were removed, cleaned and painted
confer shackle lift
new old stock 33/12.50/15 BF Goodrich mud TA on 15×10 aluminum rims
Confer axle sliders
new rancho leaf springs
all new spring mounts
stainless steel bolts throughout including body mounts
The cons:
Needs freeze plug installed….popped a few yrs back…no cracks..engine runs but..
needs holley fuel pump rebuilt or replaced.
needs clutch brake master cylinder rebuilt or replaced (froze from sitting)
Front driveline shortened and installed
battery
oil change
fuel
lights wires to “painless wiring center”
Seats recovered or replaced
Seller believes this may be an M-606. I’m not seeing it.
“I am selling one of my favorite toys, a 1953 Willys Jeep I bought to display with my M1009. I bought it as a M-606, all indications are; It probably is. The M-606 was a Willys pulled straight off the assembly line and modified. The only thing that positively identifies some of these is a stamp on the frame and I have not located it.
At some time in it’s history it received a Buick V6 conversion. When I bought it, it was camo’ed like everybody dose. I was trying to paint it back to the 1950’s era Olive Drab, as it would have been. During sand blasting of parts I found red oxide and the mustard yellow primers used on MV’s. It has a PTO driven 12000 winch on the front. Pental hitch and blackout light on the fender, two jerry can mount on the factory, full roll cage, four jerry cans, a stretcher, cot with a wool blanket, and more extras available.
Now for the bad news;
It’s all beat up and I’m leaving it that way, it has character. It is UGLY. I don’t have the combat rims that would have been on it. I don’t have provenance to show it’s history so I’M SELLING IT AS A CJ-3B, OB HIGH HOOD for $1500! cash only, no trades, no payments. If I could prove it’s a M-606 it would be much higher. It needs clutch work and breaks, I drive it around the yard, start it in gear and kill it to stop. I haven’t been able to start it this near, no spark. Passenger side of the windshield is cracked. Windshield mounting bolt broke off in the mount.
I am not going to flower it up ’cause it is what it is.
I have a Colorado title,”
http://topeka.craigslist.org/cto/5643173787.html

UPDATE: Still Available.
(06/11/2016) The drain holes have been filled, but looks solid.
“low miles partially restored 38000 miles drive home great summer vehicle 4 cylinder 3 speed 4wd title in my name utv”
Appears to have a replacement body (or replacement panel).
“53 Willys jeep cj 3b frame all sandblasted and painted ,new lift kit, springs , tub has all new floors and sides , has dauntless 225 v6 be rebuilt , t90 transmission , needs to be assembled , lots of time and money already spent on this jeep hard part has been done”
This late model 3B includes a government plate. Is that a late model Willys Overland top?
“1964 Willys CJ3B Highhood
Original F head Hurricane engine runs and can maintain an idle and sounds solid. The brakes are all there but will need some work. The clutch, transmission and transfer case all seem fully functional.
Rare Willys full hard top with hard doors and roll up windows.
The tub has significant rust throughout.”
Looks like it could use some paint. Includes a trailer.
“1954 Willys Cj3b. Original engine, drivetrain, etc. Runs great. Dana 25 and 44 axles with 5.38 ring and pinion. I have a brand new Lock Rite locker for the rear axle I have not installed. New rear seat. New upholstered front seats. New gas tank and line. New summer top. Brand new aftermarket wheels and tires. Comes with small trailer to haul it. Cash or certified bank check.”
UPDATE: **SOLD** Was $4500.
That’s a heavy looking front bumper.
“Clear title 4×4 1956 Jeep Willys runs great!”
No pics provided.
“1960CJ3B
Fiberglass tub
Metal hood and grill
New top
Roll bar
134 c.i.4 cylinder
3speed trany
Spare engine and trany
Transfer case radiator
Carb and head
I think it has a spun rod bearing. So not running”