UPDATE: **Status Unknown** Was No Price

(08/28/2022) This might have a DJ-3A or a replacement body. The looks to be a V-6.

“I don’t have many details about the motor and trans, it is not running, but all parts you need are there, transmission and transfer case are installed in the jeep, I would have both rebuilt. It’s not a rust bucket and can be restored”

Tom spotted this amalgamation of parts. Listed as a 1951 CJ-3A, this jeep has a DJ-3A front end, but the front crossmember suggests the frame is not from a DJ. The body could be DJ-3A. The engine isn’t, but it is stuck anyway.

https://www.facebook.com/marketplace/item/5273403332779471/

Flat Fender Jeep project. Titled as a 1951 CJ3A is 2WD. I believe it has a 283 Chevy engine in it but engine is stuck and I do not have time to mess with it. Has some rust, but good project. If listing is up it’s available and will not respond to that question.”

This maybe be a CJ-2A with a Dj-3A body.

https://www.facebook.com/marketplace/item/739494307293337

Have 1947 with title Tub had plate on saying 1954 took off to check and lost them in house remodeling . Did lots of work on it 11 years ago , new wiring , water pump, head gasket was leaking ( shaved head .015), fuel/water separator, new brakes and master cylinder, new muffler and homemade Bimini top.

Always smoked and not a lot of power, but plowed snow good. Daughter was driving it about 6 years ago and she said it started smoking and nocking and would not run right. Been sitting in garage. Since. Don’t have time to rebuild flat head motor or the cash right now. Block is in good shape.

I installed large bumper and boxed front of frame for snow plow, have original bumper. Added Reece hitch. It has PTO hook up but they never put leaver through floor. Decided need 24’ enclosed trailer instead….lol Have extra springs and steering linkage Did compression test 55,57,72 & 75 starting on #1 . Askin $2200 obo”

Tom shared this flattie for sale. This looks to be a DJ-3A Convertible body on a CJ chassis (probably 2A based on the engine and radiator). I’m betting the gas inlet on the driver’s side is a mod.

https://www.facebook.com/marketplace/item/739494307293337

“Have 1947 with title Tub had plate on saying 1954 took off to check and lost them in house remodeling . Did lots of work on it 11 years ago , new wiring , water pump, head gasket was leaking ( shaved head .015), fuel/water separator, new brakes and master cylinder, new muffler and homemade Bimini top. Always smoked and not a lot of power, but plowed snow good. Daughter was driving it about 6 years ago and she said it started smoking and nocking and would not run right. Been sitting in garage. Since. Don’t have time to rebuild flat head motor or the cash right now. Block is in good shape. I installed large bumper and boxed front of frame for snow plow, have original bumper. Added Reece hitch. It has PTO hook up but they never put leaver through floor. Decided need 24’ enclosed trailer instead….lol Have extra springs and steering linkage Did compression test 55,57,72 & 75 starting on #1 . Askin $2200 obo if anyone is interest”