This quiz was part of the Joe Booth training brochure above.
1943 GPW Costa Mesa, CA $8500
This appears to be a mix of parts. The hood may be fiberglass. The dash appears replaced.
https://orangecounty.craigslist.org/cto/d/1943-ford-jeep-gpw-wwii/6743086406.html
“Runs and drives well, military tires. Has a clear title in my name.”
1961 CJ-5 Spokane, WA $900
Given the hardtop, it looks like there’s value here.
https://spokane.craigslist.org/cto/d/1961-willys-jeep-900-obo/6741449021.html
“Selling as a parts jeep (no title) $900 OBO”
Willys/Jeep Parts Modesto, CA **SOLD**
UPDATE: **SOLD** Was No Price. Possible Coast Guard Super Jeep?
That’s an interesting, extended WWII body.
“Need a part for your WILLYS JEEP? I have anything and everything (Mechanical [Non-Electrical]) you can think of!
The parts I have are for a Willy’s GPW L134!
(1941-1945) are the years the Willy’s GWP (GO DEVIL) were manufactured! This is a very light weight and capable 1/2 ton vehicle used in WW2. Because these parts were manufactured from 1941-1945 they are very good quality.
Some parts are quite rusty due to being left outside but most were in a basement located near Seattle, WA and are brand new…. as in fresh out of their boxes!
I have loads of bearings and gears! 5 transmissions, 2 engine blocks, 2 transfer cases, 2 bell housings, 3 cylinder heads, 3 oil pans, 3 fly wheels, 1 crank shaft, 1 camshaft, 1 starter, 2 front axles, 1 rear axle, 6 pistons and so much more!!!!! MESSAGE ME!!!!”
5 Slots Rims Penn Valley, CA $250
Four rims match. A fifth is different.
https://sacramento.craigslist.org/wto/d/ford-jeep-western-wheels/6742157672.html
“Old school Jeep wheels. They are the big 5 bolt pattern 5 x 5 1/2. Will work on 4 wheel drive.. Will not work on disk brakes, the only reason I am getting rid of these. The rims will also fit older Dodge, Willys and Fords. The tires are old. I have 5 rims 4 match and one is different the third rim picture is the spare”
Koenig CJ-5/M-38A1 Hardtop Scranton, PA **SOLD**
UPDATE: **SOLD** Was $400.
Looks like a good price. I can’t tell if there’s rust or not.
“M38a1 hardtop and doors good shape $400 or obo”
CJ-3B Hardtop Butler, PA **SOLD**
UPDATE: **SOLD** Was $150.
Has some rust.
“Looking to find a good home for a half decent metal top and doors for CJ3B.
I really don’t want to scrap the top, it’s completely saveable.
will trade for CJ3B/ flatfender parts or make me an offer”
4 15×7 Slotted Rims Berea, KY $150
Looks like a good price.
https://louisville.craigslist.org/pts/d/15×7-slotted-wheels/6726107158.html
“15X7 SLOTTED WHEELS 5×5 bolt pattern fits ford /jeep vehicles.No curb scraps should clean up nice.”
1949? CJ-2A Payson, AZ **SOLD**
UPDATE: **SOLD** Was $9500.
Engine is out of the vehicle.
“49 Willys Jeep, all stock including 6 volt system and flathead engine. Engine is not in the veh. but has been recently machined and partly assembled. has many brand new stock parts, including all new wire harness(not installed) and new stock like tires(5 including spare). Also have soft top frame and doors(no material). The jeep was running in good condition until cylinder failed on engine, had it machined and started to assemble and at this time unable to continue. Asking 9500 or best offer, only respond if serious buyer, thank you.”
1949? CJ-2A Kalama, WA $200
I suppose the dalmatic hubs, the grilles, and the rims have some value.
https://portland.craigslist.org/clk/pts/d/49-willys-jeep-cj2a-rolling/6743230342.html
“what ya see in the pics….is what ya get. Rolling frame with wheels & locking hubs, roll bar, front grill, tub, 2 gas tanks, and an oregon title.”














