The PNW4WDA racing year is almost over. Here are a couple videos from past years. The first is a great overhead view of some the tracks, which are changed slightly for every race.
Here are a few clips from the 2017 season.
The PNW4WDA racing year is almost over. Here are a couple videos from past years. The first is a great overhead view of some the tracks, which are changed slightly for every race.
Here are a few clips from the 2017 season.
A couple days ago someone asked about the difference between a long bed and a regular truck bed. I’ve never heard of there being too sizes of truck beds. The standard size is 79″ or 80″. However, someone measured their bed at 88″. I am awaiting a remeasursement, but until then, has anyone heard of large beds (either factor or aftermarket)?
The bed below reminded me of the question, which is why I’ve listed it (though it looks pretty rough).
https://kpr.craigslist.org/pts/d/1956-willys-overland-pickup/6682990404.html
UPDATE; **SOLD** Was $4500.
Located along old Route 66.
“Selling For my father in-law, He has owned it since the late 70’s. Still has the old flathead 4 in it that runs as you can see by the fan in the motor pic. All factory except for the turn signals. Those were added by previous owner. It comes with a Warren over drive, factory installed. New Tires, brakes all the way around a few years ago, along new front knuckles as well. Fuel pump and water pump replaced to get it running again. Does need restoration, but is solid. Comes with new set of plug and wires. Not used much, carb needs cleaned I suspect, have to choke a bit to keep it idling. Valid title as well.”
Has a rear PTO.
https://stcloud.craigslist.org/cto/d/1946-willys/6683901028.html
“Willy s Jeep 1946, 4 cylinder manual transmission hi and low range with pto out the back”
UPDATE: Price dropped to $7500.
(11/20/2017) Looks in good shape.
“1951 WILLYS WAGON, 2-wheel drive, F-head 134, three on the tree. Runs and drives nice! Front seats not stock, have rear seats.”
https://spokane.craigslist.org/cto/d/51-willys-jeep/6683609094.html
UPDATE: **SOLD** Was $7300.
Runs and drives.
“Selling my 1947 Willys CJ2a lots of work done on this CJ runs and drives titled and plated to drive on roads.”
UPDATE: **Status Unknown** Was $4000.
Travis shared this odd-bodied jeep. Is that a cut down 3A windshield?
“custom body on a frame off rebuild about 10yrs old. motor completely done, as well as suspension drive train etc. body is extremely strong. made of 1/8 inch plate steel. undercoated. jeep could use a bath and a little tlc and maybe some camo paint. 3 way plow included. registered and inspected–runs and drives good. tranny has a chipped tooth in 1st and reverse gear still drives ok but you will hear a clicking sound other than that this thing is a tank. it will go anywhere. strong and dependable. we are moving and can not take with us.”
Includes a Warn OD.
https://denver.craigslist.org/cto/d/1947-willys-v8/6682826494.html
“I have a 1947 Willys with a 68 Mustang 289 in it everything from the motor back is stock has 33 inch tires great cheap to finish does have a warn overdrive with 3 speed tranny”
UPDATE: Price dropped to $4500. Early Free-Lock maybe?
(08/10/2018) Need some more pics. Has some type of unusual hub.
https://fargo.craigslist.org/cto/d/willys-jeep/6648092267.html
“1946 willys jeep cj2a, 12 volt with altanator,stainless steel brake lines,receiver hitch front and rear, lock out hubs,canvas top with doors,very little rust,almost new tires,runs good.”
Price is best offer.
https://up.craigslist.org/cto/d/1944-willys-mb/6678636485.html
“Possibly 1944, just a guess, looks to be a later composite body and has the torque reaction spring on the front drivers side. Has CJ2A grill, windshield, and engine. Everything else is WW2 military, Willys MB. Hood has actual blue drab numbers on it under 50 layers of paint. Trans, t-case, axles, frame, all look to be original Willys MB. Body is very rough, frame it patched, rusted, and weak. This sat outside for at least 20 years, it will not run or drive, engine is free and i have gotten it to fire but looks to have a bad head gasket or worse, i would consider it not to be a rebuilder, but lots of good parts. Will roll. Price is OBO.”