To Top

1942 MB/CJ-2A Boise, ID **SOLD**

• CATEGORIES: CJ-2A, MB This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $1450

(08/23/2016) The chassis is from a CJ-2A.

“I have a 1942 Willy MB project. I do not have the time or space to complete this the way I would like it. I have all the components, hood, grille, fenders, tub, frame, wheels/tires, seat, fuel tank, steering shaft and wheel, axels, motor and transmission. The frame is from a 1947 CJ-2 I was modifying it to be like the 1942 frame. This is where I have run into trouble the frame is setup for the T-90 transmission not the T-84 I want to have on it. I also have another motor. It is title and registered. Engine does run. Everything is apart right now waiting for the right person to complete. ”

1942-mb-boise-id1 1942-mb-boise-id2 1942-mb-boise-id3

[fb_button]
 
To Top

Tuesday Sep. 27th: … Then I Lost My Wedding Ring

• CATEGORIES: Features • TAGS: This site contains affiliate links for which I may be compensated.

On Tuesday we drove from Dallas to Denham Springs, Louisiana. The drive itself was uneventful, but not without its challenges:

2016-09-28-dallas-denhamsprings

Our drive from Dallas to Denham Springs, LA.

2016-09-28-dallas-dfwairport

Uh oh … this is a tight squeeze!!

1) When returning the rental car we had for two days, I was driving the motorhome and missed the turn for car rental returns. Instead, I headed straight towards Dallas/Fort Worth International Airport…….. There were no other options. I had to drive very slowly going through the concrete barriers to get my entry ticket. I fit, but barely. I estimate that I had two inches on either side of the motorhome. Ann was behind me and took a photo. Well, I did have to sacrifice a little bit of the generator tailpipe, which apparently stuck out the side a little too far.

2016-09-28-dallas-dfwairport2

Hmm … something’s not quite right, but it will work.

2) I turned over the driving to Ann after we left Dallas so I could get some eWillys done. I took off my wedding ring to type (which I always do) and set it in front of me on a sweater. That sweater got upended at some point and the ring rolled somewhere in the motorhome. Sigh.
3) When we arrived at the KOA trailer park about 9pm (reserved and paid for a site), we discovered the staff had left NO check-in info, so we took the LAST available site even though earlier in the day the reservations gal said only a back-in sit was available.
4) It seems this park includes much of Baton Rouge. We’re guessing a good number of these folks are recent flood victims  🙁
5) Our trailer neighbors just got done partying, but left a friend passed out on the bench 5 feet from our door. The scene is complete with bottles scattered everywhere. Oh well. Maybe they are finally watching the toddlers that were running in front of our rig as I tried to park it.
6) On the opposite side of us was a couple from New York who asked for help getting their cable to work.  We were never able to make that work.
8) Our trailer was invaded by some local bug life as we searched for my ring.

Yet, we are still having fun. It’s all part of the adventure!! Once we get done with our visit, we have to decide how to proceed home. We are unsure of which route to take.

 

 

[fb_button]
 
To Top

Year? CJ-3B Fortuna, CA **SOLD**

• CATEGORIES: CJ-3B This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $5000.

This looks like it has potential. That’s nearly, low hoop.

“1950 Jeep Willy’s for Sale
High Hood
Original Body
Fold down wind-shield
Road ready
Perfect for hunting in the hills”

year-cj3b-fortuna-ca

[fb_button]
 
To Top

1947 CJ-2A Leesburg, FL **SOLD**

• CATEGORIES: CJ-2A • TAGS: , This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $7500.

(02/18/2016) Looks nice.

“1947 Willys-Overland CJ2A
4.25 Lift (3 inch Black Diamond spring lift w/ 1.25 lift Confer shackles)
32×9.5×15 Swamper TSLs (almost nothing for wear)
6 point cage tied to the frame on the front hoop
53′ CJ3A 134ci L-head flathead 4 cylinder
T90 3 speed transmission (rebuilt with a Novak master rebuild kit)
Dana 18 transfer case (rebuilt with a Novak master rebuild kit)
full Painless wiring harness
all new brakes”

1947-cj2a-leesburg-fl0 1947-cj2a-leesburg-fl1 1947-cj2a-leesburg-fl2 1947-cj2a-leesburg-fl3 1947-cj2a-leesburg-fl4

[fb_button]
 
To Top

1945 MB Fredericksburg, VA **SOLD**

• CATEGORIES: MB • TAGS: This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $18,500.

Not sure why it doesn’t have full floating rear hubs? Seems a strange detail to miss

“1945 Willys MB, completely restored and parade ready. Frame off restoration, engine, transmission and drive train completely rebuilt. Professionally painted replacement tub, hood and windshield frame. Jeep looks and runs like new. Rebuilt chain drive engine is from an early CJ2a, and rear axle is a Dana 41. All other parts are either original, NOS or replacement. Ready for your show or parade. Clear Virginia title. Less than 500 miles driven since restoration.”

1945-mb-fredericksburg-va

[fb_button]
 
To Top

1942 MB Phoenix, AZ $5000

• CATEGORIES: MB This site contains affiliate links for which I may be compensated.

It’s still a project. Looks like it might be on a 1970s CJ-5 chassis.

“1942 willy’s jeep MB
Runs and drives but still a project
327 Chevy small block
Muncie m21 4 speed
Dana 30 front and rear front locking hubs
Edlebrok 1403 carb
Comes with roll bar, soft top, doors, seats with sliders
Body is alright
Tires are old but a lot of tread left

Possible trade for prerunner with cash or dirt bike on my end”

http://phoenix.craigslist.org/nph/cto/5802243851.html

1942-mb-phoenix-az1 1942-mb-phoenix-az2 1942-mb-phoenix-az3

[fb_button]
 
To Top

1962 FC-170 Butte, MT **Status Unknown**

• CATEGORIES: FC150-FC170-M677 This site contains affiliate links for which I may be compensated.

UPDATE: **Status Unknown** Was For Trade.

It’s a project.

“I’ve got this cool old truck ive been tinkering on for a year now. Ive replaced various things and though it runs good when it runs, i just can’t get it right. Its got lots of rust and some body damage but all the parts are there except for the bed. Original gas tank was hopeless so it’s running off a fuel cell. Its got 2 inch wheel spacers to accommodate the larger tires but still have the original rims. Its a one ton.
This truck would make a really cool hunting rig or just something to drive around in the mountains if you want to put the work into it. It IS a project. They’re quite rare. Have clean title in hand.

Id like to trade this for a good running 3/4 ton or better truck.
The bigger the better, needs to pull a travel trailer. Im open to an suv or even a van if its heavy and in good shape.
I don’t know what the truck’s worth but i dont want to trade for anything with major issues. I don’t mind something ugly. Just depends what it’s worth to you. Please send pics. Thanks for reading.”

1962-fc170-butte-mt1

1962-fc170-butte-mt2

[fb_button]
 
To Top

MB/GPW Body Boise, ID $150

• CATEGORIES: Body Parts This site contains affiliate links for which I may be compensated.

Sides are rough according to seller.

“This is a world war II jeep tub. Good for parts or for a retro rockcrawler project. no data plates, no script, 1943 or 44.
tub sides are bondo. looks good in the picture but sides are rough. cowl is great. floor is rusty. This is a fab situation, not bolt on.
I will help you load this or deliver locally if necessary. i can’t help you if your wife gets mad. mine will be happy its found a new home.

folks always ask if I have other ww2 jeep parts. I have center parts of a cut frame (no front or rear), a front axle, hood that Is covered in bondo and that’s about it.

IF THIS AD IS UP, ITS AVAILABLE. Email me pls, that’s how I communicate best. don’t ask if its available. come look at it. ”

http://boise.craigslist.org/atq/5798302770.html

mb-body-boise-id

[fb_button]