Looks good.
“1958 Wilys Maverick Wagon .4cyl F head engine. 3 speed with overdrive. ”
Looks good.
“1958 Wilys Maverick Wagon .4cyl F head engine. 3 speed with overdrive. ”
UPDATE: **Status Unknown** Was $5900
“1978 Mitsubishi Jeep J58
Factory Astron 2.0 Gas 4 cyl
Bestop top and doors
Factory Light Guards, Runs and Drives Well, New Weber Carb
New Starter
Would make great off road beast”
UPDATE: **SOLD** Was $5500.
Might be a good price.
“1953 Willys P/U Great Condition SOLID NO RUST THRU at all
no rust in bed – cab corners – rocker panels – under the doors – very rust free
Has a V-6 Buick motor runs good 4 wheel drive works great
Michelin tires are good – could use brake work – heater works – tach works
new lights all work – turn signals – inside lights – wiper works – straight bench seat
has a crack in drivers door glass and has a boat fuel cell needs a new tank
GREAT CLASSIC TRUCK FOR 63 YEARS OLD good TN. Title in my name
pictures were took on 4/21/2016 don’t need any help selling it
$5500.00 or may trade just tell me what you have”
UPDATE **SOLD** Was $3500.
Has a few updates, but may be worth a look.
“1949 Willys CJ3 for sale. Runs great. I’ve had for 20 years. I believe I’m the 3rd owner.”
UPDATE: **SOLD** Was $1500
(05/03/2016) Might have some value.
“Death forces sale of Plum Crazy Jeep. 9″ rear, dana 44 front axle, fuel cell, radiator and custom built shroud for radiator to be mounted behind seats. Custom hand built frame. ”
Has a new body.
“1947 willys cj2a frame off restoration, new metal body, body not painted, engine,trans,transfer all rebuilt. Wanting to trade for manlift that can be used off road, cannot use scissor lift. Possibly trade for bucket truck. I value the jeep at $10,000 so let’s see what kind of deal we can make. I do not need help selling this item. Also if you are bored and need someone to talk to I’m not interested. ”
UPDATE: Still Available.
(09/02/2015) The steps have been modified and the front frame rails lengthened.
http://gainesville.craigslist.org/cto/5593245329.html
“1958 Willys CJ3B
This is the “High Hood” Jeep that replaced the CJ3A with the introduction of the Hurricane engine. That engine replaced the flathead Go Devil with overhead valves and a little more horsepower. I bought the vehicle in October of 2011 with the intention of a full restoration, but as I got into it I decided to concentrate on the mechanicals and make it roadworthy and reliable, then use it for light off-roading.
Since then I have just under $ 12,000 in it. $ 3500 up front, and $ 8200 in parts. Here’s a partial list:
• Full engine teardown and rebuild, mid 2014. Only about 600 miles since then. Rings haven’t even fully seated yet.
• Monstaliner bedliner on floor
• New speedometer and cable
• New gas tank
• New temp switch
• New carb
• New water pump
• Grab handle
• Heavy duty shackles
• Air cleaner hose
• New springs and shocks
• Headlight switch
• New u-joints rear
• New radiator
• Five new NDCC tires and tubes (period correct, like mil tires)
• New spare tire mount
• New windshield
• New battery
• New clutch Continue reading
Has a couple different rim types.
“Needs to be restored. Has 9400 original miles make offer”
UPDATE: Price dropped to $2500.
(03/04/2016) It’s rough, but looks like fun. Might be a good value.
“Turn key/wheeling ready
Buick 225
T90 transmission
Dana 18 transfer
Dana 44/Dana 27 w/limited slips
4.11 gears
It’s more reliable than it is pretty! My dad and I have had a blast in this jeep over the years and always get lots of smiles and waves on the trail. This jeep will get you thru most anything. If interested call or text and swing by to see it and hear it run. Asking 3000$ but are open to offers. We’ve seen these iconic rigs going for far more than this so no low ballers please. ”
UPDATE: **SOLD** Was $1000.
Looks like there could be value here.
“1974 cj6 jeep sitting on a k5 blazer frame had a Tbi 350 engine that had a 140000 miles on it has 38.5 tires with 50 percent tread or better Dana 44 front and 10 bolt rear needs finish up wiring harness needs put on and everything hooked up engine just had heads done before pulled out of the the other truck”