UPDATE: **SOLD** Was $1100.
This includes an extra body and parts.
“2 JEEPS ONE WITH A ford inline 6 cyl 200ci runs great ITS A 1964 BRAKES LIGHTS WORK RUNNING. 2 IS A 1957 WILLYS TUB AND FRONT END ALSO HAVE FRAME WITH TRANS AND TRANSFER ”
UPDATE: **SOLD** Was $1100.
This includes an extra body and parts.
“2 JEEPS ONE WITH A ford inline 6 cyl 200ci runs great ITS A 1964 BRAKES LIGHTS WORK RUNNING. 2 IS A 1957 WILLYS TUB AND FRONT END ALSO HAVE FRAME WITH TRANS AND TRANSFER ”
UPDATE: **SOLD** Was $2000
(02/09/2013) Was running until electrical went bad.
“1946 Willys Jeep all original everything is there in very good shape for it’s age
needs some minor repairs was in running conditions till electrical went bad
$2000.00 OBO”
Marc and his son were driving in Anderbolt (South Africa) when his son spotted this beautiful truck sitting in a showroom at Boston 4×4 Accessories. If you are in South Africa, check out their store.
He writes, “This truck is their company demo vehicle for the 4×4 accessories and parts they supply under the name of Boston 4×4 Accessories, +27 11 914 3004 or sales@boston4x4.co.za. and are located in Anderbolt, Boksurg, Gauteng, South Africa. I see their web page is down, under construction.
It has a small block V8 (ford) but I didn’t learn the transmission set up. I could not find the data plate for the serial number any where. As noted in the photos, this truck is right hand drive, not a factory mod. Done way after it left the US.”
Paul’s made some progress on his Willys. You can read past posts about his jeep, Knardly Rolls, here: http://www.ewillys.com/tag/paul-m38/
Paul writes, I’m using thin poster board to make patterns for the interior panels on the Willys. Since the reinforcing structure for the top and doors will be visible from the inside and not covered by upholstery I’ve had to make 33 individual paper patterns so far. After adjusting the fit of these patterns I’ll transfer their measurements to 3/4 inch thick high density foam and then it’s time for the upholstery wizards to work their magic. Fourteen yards of fabric are on order so that should be enough to cover everything but the floor. All of the top and side wall panels will be covered with a silver gray fabric and this same fabric will be used on the seats with the exception of blue insert panels covering the center of the seats. That’s the plan right now. I still need to buy some thick upholstery foam so I can begin cutting out the padding for the seats but I wanted to finish with the patterns first.
More pattern pictures. To have enough room to make the patterns and install the upholstery pieces it was necessary to remove the fuel tanks and both front seats. The more work I can do myself the lower the cost will be to get the upholstery done so I don’t mind constantly climbing into and out of the Willys all day long. Things would be a lot easier if the Jeep was just a little bit bigger or I was just a little bit smaller. Oh well, I guess I need to call a Waaaaaaaaaambulance. Paul
Charles explained that these are photos of Padre Van Der Goten, a beloved priest in the Belgian Army. According to this Wikipedia article, his jeep’s motto was “Belgian’s Can-Do Too”, pictures of which we saw in this post.
UPDATE: **SOLD** Was on eBay
Here’s an unusual photo.
“This is an original 5×7 black and white photo. Showing an Army Jeep pulling an anti-aircraft gun behind it in a parade. My guess would be late 1940’s by the looks of the cars in the back ground. Great Vintage photo to look at!
Not sure of the exact time frame or location. The back of the photo is stamped with
Photo by Bill Shoopman, Odessa Texas”
UPDATE: **SOLD** Were $750.
“I have two steel Army jeep bodies, Go kart size, Just like the old m38 military jeeps, Picked these up about 20 years ago, A lot of people use quad frames and running gear to power them. this is the bodies only, Lift up hood, fold down windshield, fold out glass,”
UPDATE: **SOLD** Was No Price
Here’s an unusual setup.
“Owned by a local irrigation district and used to haul concrete to canal since the 60’s. Back has been cut out to allow dump to operate and passenger seat is gone so dump parts could be placed there, Engine does not appear to be original but runs and was maintained but needs a good tune up. Spent 200 on rebuilding dump so I could haul concrete threw narrow openings and haul rocks. Have not used it since I rebuilt it but did try it a few times. Dents from years of abuse. Original stars. No data plates or title. Irrigation district lost title and some dumb deputy told them to sell it to get a salvage only paperwork. Tried to explain to them what they did but they were not getting it. Said this is fine since it was told to them by a deputy. I do have a bill of sale. And if you can get them to understand great. Does have numbers on frame. I wanted to trade it for a Minelab metal detector or a White Detector and probe and hoops worth about 1500. ie: a V3i white or Minelab Safari. Might have tail light covers and a few smalls that go with the M38A1. (Triangle on back not included)”
Need a jeep that’s a little taller? Here it is.
“52 willys cab on top of custum frame tons of stuff.spun berring in motor its a 454 big block, i have another motor that will go with it for nether $1000.oo.350 trany , 5 ton transfer case 2.5 ton rockwell axles welded front&rear, hydro steering, pion brakes , new aluminum radator race seats new pull headers, 16 gallon fuel sell, b&m shifter,its all painted green and bed is made just have make rear fenders. cage needs finishing, sure forgot lot stuff asking $3900 obo.cash posable trades .i also have the doors just not on or painted. text or call with questions. come c in person get much better idea.”