This looks like it needs some work.
“1945 cj2a with half military parts has m38a1 motor 134 f head with new head gasket runs needs starter and work on brakes has a roll bar and side rails would make a great hunting jeep”
This looks like it needs some work.
“1945 cj2a with half military parts has m38a1 motor 134 f head with new head gasket runs needs starter and work on brakes has a roll bar and side rails would make a great hunting jeep”
The seller has added a price and clarified thisis a 1944 GPW.
“Nice and fun jeep to drive .. there is a pin hair crack near the distribtor in the block …but the jeep runs and drives it all ready for the next person .. in done lots of money invested”
This appears to be in very good shape for the price. The engine even runs.
“1964 Willy’s Jeep FC 170 L-6 motor (runs) needs restoration Robert cell 860-883-7722”
This looks like it could be a good price for an MB in very good condition.
“THIS 1943 WILLYS ARMY JEEP IS AVAILABLE AS PART OF THE LIQUIDATION OF A COLLECTION OF COLLECTIBLES PARTING OUT AN ESTATE. IT IS STREET LEGAL WITH DIRECTIONALS AND WAS MANUFACTURED DURING WW II WHEN THERE WAS NO CIVILIAN VEHICLE PRODUCTION. IT CAN BE SEEN BY APPOINTMENT BY CALLING JOHN AT 609-665-0679 OR ANN AT 609-965-4058 OR REQUESTING MORE INFO BY E-MAILING frcvette@aol.com”
“$1500 OBO. 1953 CJ3B in the process of being restored. Everything is stock, but the stock axles are not under it (they’ll need new lock-out hubs). Currently it has a set of CJ5 axles under it for moving purposes (included). The springs are brand new Rancho 2.5″ lift springs and new shocks. New front and rear bumper and the frame has been stripped and painted. It’s been pretty well cleaned up and ran 2 years ago when I started the rebuild. Engine still turns by hand. The body is gone except for the firewall, but the data plates are here. Basically, I’m bored with it and have no money. As far as I know, to start it all ya need is a bolt for the block (one of the bolts for the carb is stripped. It’s out, but ya need a new one), fuel lines and electrical. Everything is there, with a spare windshield and windshield frame, early CJ roll bar, and an extra set of gauges for the dash.”
This might be a very good deal. Note: the engine needs work..
“You are looking at a 1959 Cj-3a. Body is in good shape..there is a new gas tank, fuel pump, coil-over shocks and other small items. I have the frame for the top which will go with the jeep. It needs seats..( I do have the frames that was in it when I bought it ) .. The original 134 L-head engine is complete but does not run…it will turn over. It has a bad rod..but it is an easy rebuild..All parts can be bought from Turner 4-Wheel in Canton. This is a great restorable jeep or a great hunting jeep. All the electrical works and the 4-wheel drive works. For you jeep guys—–it is a 1959 body..looks like a DJ though..but it is on 4-wheel chasis. The vin # is a ’59 DJ.. look at the pics”
There was no price listed on this trencher. It’s bit rusted, but these are hard to find.
“Trencher from an old jeep. Just removed from the jeep. Complete. Call Bob at 605 852 2156”
This appears to have a CJ-3B windshield with a CJ-2A body and maybe a CJ-3A title?
“1952 Willys jeep. Would be a great project or hunting vehicle. Runs but needs a new carb. Has recently been converted to 12 volt. Has the flat head 4cly.(go devil)? Comes with tow bar and tows great. The jeep has some rust and holes but could be patched. Comes with a hard top also, and a extra military hood. I am in the process of working on this jeep so price is, as is right now. Call Chuck 719-243-3425”
It appears in decent shape.
“CHECK THIS OUT. 48 WILLY’S CJ2A, 4X4 , 4 CYL., STICK. RUNS GOOD BUT BODY NEEDS A LITTLE TLC.”
This MB appears in good shape, though I can see some body dents. I think it has a CJ-3B windshield though.
“1945 military Willy’s jeep. 4-cylinder motor. some rust. runs great. clear title. all original. painted military drab. new windshield. with military tires. David Escalera- (352)538-9761”