Fiberglass Research Archives

To Top

1948 CJ-2A Iuka, Il (+parts jeep) **SOLD**

• CATEGORIES: CJ-2A • TAGS: This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was on eBay.

This fiberglass body has an unusually short dash. I can’t tell if it came that way or if it was cut.

“Willy’s CJ2A 1948. Fiberglass tub, all tires 99%, newer wheels, Baja lights, new starter switch and master cylinder, tow bar. The brakes need bleed, battery works but needs replaced, and engine is hard mounted. It also has a transmission leak from somewhere. Engine starts easily. Four wheel drive works. The title says 1949 but the VIN is from the 1948 period so I’m not sure what happened there. No VIN tag. Head 648830 engine P31351. from what I can tell its a F-head engine M-38. Block 646228-L-W10ANI-CR-N2.

Willy’s CJ2A 1946 parts jeep. Dualmatic hubs, hood is restorable, gas tank appears to be good, transmission appears to be ok, wheels are restorable, vin tag in place. VIN 79023, tailgate 6988. The engine was already removed whe I got it. I pulled it apart and it appears to be rebuildable. Head 640161 engine J206101. No title for this jeep. Block 641087-L-W7ANI-CR-N2 4-22.

I have described these to the best of my ability. It has been a while since I wrote all these numbers etc down so I hope I got them all correct. If you have questions please ask. I bought these to restore but due to back problems I had to stop.

I have more pictures if interested. All pictures were taken today. I plan to loosely assemble the spare motor with all misc parts bagged and tagged. All is sold as is and final.”

View all the pics on eBay

[fb_button]
 
To Top

Parkette Body and Bobcat Hood (& more) Yakima, Wa **SOLD**

• CATEGORIES: Body Parts, Features, Racing, Roll Cage • TAGS: , This site contains affiliate links for which I may be compensated.

UPDATE:  Last price was $1000. It sold.

The Parkette fiberglass body is an extreme rare, well made body.  One of the best things about this body is that a CJ-3A windshield will properly fit it, unlike the fiberglass Bobcat body.   During the 1970s, a friend of mine bought a Bobcat body, prepped it, and painted it.  When he stuck on the windshield he discovered the cowl was too flat to properly seat the windshield to the cowl.  To say he was angry was an understatement, because he felt he was mislead by the promises the manufacturer made.

So, after talking with the Parkette body manufacturer and getting assurances that the measurements were more accurate, he bought the body and has been happy about it ever since.

The body shownn below has had it’s rear wheel wells cut a bit.  It’s got a good looking rollcage that has been attached to the frame.  If this has been available when I was building biscuit, I would have started right here.

[fb_button]
 
To Top

1949 CJ-2A Parkette Body Buckley, Wa $1599

• CATEGORIES: CJ-2A • TAGS: , This site contains affiliate links for which I may be compensated.

UPDATE:  Price dropped to $1599

(07/24/2011) This might be worth a look. It runs, too.  It appears a bit hacked up.  I’m very curious about the headlight bezels.  Those look unusual.  It has a bobcat hood.

“CJ5 frame
Parkeet fiberglass body
Buick 225 odd fire V6
Dana 44’s locked
racing seats
runs good
needs TLC
253-224-9450 no texting please”

http://seattle.craigslist.org/tac/cto/2538085459.html

[fb_button]
 
To Top

1948 CJ-2A Kenosha County, Wi **SOLD**

• CATEGORIES: CJ-2A • TAGS: This site contains affiliate links for which I may be compensated.

UPDATE:  SOLD.  Was listed at $750.

This is has a fiberglass body.

“A 1951 Willys Jeep for sale.
Barn fresh.
Fiberglass body, metal hood and windshield frame. Aluminum cab included (not pictured, pics available)
Sears front hubs.
$750 or best offer.
More pics available on request.
Thanks for looking.”

[fb_button]
 
To Top

1942 MB Auburn, WA **SOLD**

• CATEGORIES: MB • TAGS: This site contains affiliate links for which I may be compensated.

UPDATE **SOLD** Was $4000

(03/14/2010) Here’s a highly modded flattie.

“i have 1942 willys jeep that i have owned for 14 yrs it has a fresh rebuilt chev 350 4 bolt main that only has about 5 miles on it. it has a ford t-18 trans jeep dana 20 transfer case and dana 30 front and dana 44 rear with brand new 4 wheel disk brakes . the frame was replaced with a m38 frame and was boxed in for strength witch increased wheel base by 6 inches and leaf springs where upgraded to wrangler springs. the tub was replaced with a old school bobcat racing fiberglass tub it has tilt steering and was set up for a bigger guy since i am 6foot 2 inch and 320lbs it has 8000lbs warn on front and its setup for reciver mount winch on the rear and a swing away rack on the rear that holds shovel and ax and 2 jerry cans and hi lift mount .it has a set of 5 33 12 50 15 wild cat ext that are about 90% tread left and i built on board air compressor that works sweet . and i do have 14 years of receipts too i am asking $4000 o.b.o or willing to do partial trade for motorcycle + cash thanks for looking”

[fb_button]
 
To Top

1963 Flattie Covington, WA **SOLD**

• CATEGORIES: CJ-3A • TAGS: , This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $6500

“This is a fun, mechanically solid trail jeep. It has been on almost every trail in Washington and every sand dune in Oregon, so it has some issues. I have alway driving this Jeep hard but not to the breaking point. After every trip this Jeep got a good cleaning, fluids checked then got it ready for the next trip before putting it away. It drives pretty good on the street, but with the rear spool and no turnsignals and no full top, it is not a daily driver.
Continue reading

[fb_button]
 
To Top

1946 CJ-2A Broomfield, CO **SOLD**

• CATEGORIES: CJ-2A • TAGS: , This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $5990

(09/22/09) It looks nice. I’d like to see more pics.  It sounds like this has had a complete overhaul over the years.

“1946 Willys CJ-2A $9,000 or best offer.  Miles: 23k on odometer. 1946 3-speed transmission and transfer case rebuilt in 2007. New fiberglass body and canvass top installed in 1995.  1974 Buick Jeepster V6 engine rebuilt in 1981. 1946 Frame rebuilt and installed in 1981. Exhaust redone in 2009. Electrical redone in 2008.  Includes tow bar and towing lights.  Operating 2-hi, 4-hi and 4-low gears. Max speed 60-65 mph. Overdrive kit, power steering, bucket seats, backseat with storage locker, 2-speed heater, spare tire, individual wiper motors. Family-owned since 1978.”

[fb_button]
 
To Top

1951 CJ-3A Project Billings, MT **SOLD**

• CATEGORIES: CJ-3A • TAGS: , This site contains affiliate links for which I may be compensated.

UPDATE: **SOLD** Was $2500.

This is a project.

“So Heres the deal I have this willys jeep project I started years ago. The tub is fiberglass, stretched 15inches by a fiberglass shop. I have a roll cage that was built by a offroad shop in utah. the whole thing is mounted on a chevy fram with skid plates for the engne tranny and fuel tank. There is a cage in the engine bay tied into the main cage. Was set up with a SBC 350…. I will sell the body for 1700 OBO I have over 3500 in it already, on top of the glass work and extension I had diamond plate kickguards with step reinforcements built as well as aluminum Tread plate on the inside and a tread plate top rail. Would take 2500 OBO for the chassis body and cage. The rear bumper has a built in reciever and swinging tire carrier the front bumper has build in winch mount.”

[fb_button]
 
To Top

1952 Sand Drag Flattie Rancho Cucamonga, Ca No Price

• CATEGORIES: Racing • TAGS: , , This site contains affiliate links for which I may be compensated.

UPDATE: Still Available.  Was listed at $15,000.

(12/08/2010) Looks fun.

“1952 Flat fender jeep, full fiberglass body, Chevy 406cu small block 450 hp, Dana 60 in rear w/locker, Dana 44 in front w/warn hubs, 4-link in rear, fuel cell, 205 transfer case, B&M Trubo 400 w/clutch, B&M cable shifter, disk braks w/hill assist, scatter shields, MSD ignition w/two step rpm limiter, sand tires and garage tires. This is licensed as a 1952 and is current (clean title) ready to dune or do the hill. Call Chris @ 909-944-7173.”

http://inlandempire.craigslist.org/cto/2465414203.html

[fb_button]