Nice Research Archives

Nice Vehicle

To Top

1960 CJ-3B Ogden, Ut **SOLD**

January 5, 2010 • CATEGORIES: CJ-3B • TAGS: , . This site contains affiliate links for which I may be compensated.
0

UPDATE: **SOLD** Was $2400!!

(12/09/09) This looks in good condition.  I’ll be heading down to Salt Lake (ogden is right on the way) in about 10 days and could look at it if it is still available.

1960 Willys CJ3B – 35K Original miles in Excellent Condition with All Original Running Gear. Frame and body are in exceptional condition, there is very little cancer. Has New Interior & Paint. Needs a top, new tires, and a tune up.From the looks of the vehicle the mileage which shows 40K is original and I think many are miles towed. There is very little rust in the front floors but it has plates bolted in, none in the bed. There is also some in the front fender supports. I don’t thinkit was preped to well butit is a decent paint job. It hasbeen converted to 12 volt. There is no overdrive but the tans and transfercase seem tight and do stay in gear. the seats are he original frames but have been recovered (I believe). It has original warn lockout hubs. The hard top was taken upto eugene and it is an original aluminum hardtop,I maybe able to get pictures.

1960_cj3b_ogden1

1960_cj3b_ogden2

[fb_button]
 
To Top

1950 CJ-3A Colfax, Ca **SOLD**

January 4, 2010 • CATEGORIES: CJ-3A • TAGS: . This site contains affiliate links for which I may be compensated.
0

UPDATE: **SOLD** Was $4900

(07/09/2010) This looks good .. I love the rims.

“1950 Willys Jeep CJ3A, 350 Chevy engine, automatic transmission, overdrive, power steering and power brakes, winch, 11″ brakes, hubs, long travel suspension, new wiring, roll cage, stock axles. New steel body, so it has no rust and no bondo, nice clean jeep ready to go. Runs and drives excellent, easy to drive. A lot of Jeep for the money, this is a great buy. – $4,900.00. ”

[fb_button]
 
To Top

1957 CJ-3B Orting, Wa Make Offer

January 4, 2010 • CATEGORIES: CJ-3B • TAGS: . This site contains affiliate links for which I may be compensated.
0

UPDATE:  Still Available.  No price shown in new Ad. Was listed at $8000.

(12/27/09) Note that the body pans are fiberglass.  Looks nice.

“1957 CJ3B Willy’s Jeep High Hood. Buick 231 V6 engine, 3 speed transmission, Dana 18 twin stick transfer case with Warn overdrive. Dana offset rear end Dana 25 front end. 538 gears front and rear. 33″ super swampers. Swing away spare tire bumper with full size spare tire. Bucket seats with seat covers. Full roll cage. Fiberglass floor pans. Everything works, even the gas gauge. Rear Gas tank with diamond plate plug over the stock fuel tank port. Has a newer soft top and bikini top. Crawls in low but will do 60 on the freeway. vanzantensteven@gmail.com

New parts:  Passenger side axle, Rear end seals, Rear end bearings, Changed engine, differential, transfer case, transmission oil. Radiator fluid. Off road heater, windshield wiper motors, 5 point harness, Battery, Alternator, 33″ super swampers, Windshield(semi truck tint), Soft top.”

http://seattle.craigslist.org/tac/cto/1546981214.html

1957_cj3b_orting

[fb_button]
 
To Top

1946 VEC CJ-2A Palos Verdes, Ca **SOLD**

January 3, 2010 • CATEGORIES: CJ-2A • TAGS: , , . This site contains affiliate links for which I may be compensated.
4

UPDATE:  **SOLD** Was $10,000.

(11/04/2010)

“First of all please note my stellar feedback so you can bid with confidence. I expect the buyer to be the same. Out of my collection is this very original 1946 CJ-2A Willys with matching civilian 1946 TC-3B Bantam trailer. This Willys is a frame off restoration. It is refinished in the original and correct color of Harvest Green. It has the correct original running gear: 134-L Go Devil engine, T-90 trans and Dana 18 transfer case. This Willys would do well in any show and is turn key ready. Best of all, you can drive it anywhere.  The reserve is set MUCH less than comparable vehicles on the market and this INCLUDES the Bantam trailer. Odometer shows 47,290. I don’t know if this is actual or not. The following are all new or professionally rebuilt. Look at the pic’s…”

[fb_button]
 
To Top

1962 Wagon Los Angeles, Ca $2500

January 2, 2010 • CATEGORIES: Willys Wagons • TAGS: , . This site contains affiliate links for which I may be compensated.
3

This looks like a pretty nice truck for only $2500.

“This is a really nice 4×4 Willys Wagon, runs strong!! With no issues! Has a 327 engine, brand new tires – great fun!! I will consider trades. (comes with extra chrome parts)”

http://losangeles.craigslist.org/lac/cto/1534751058.html

1962_wagon_losangeles

[fb_button]
 
To Top

1947 CJ-2A Douglas, WY **SOLD**

January 2, 2010 • CATEGORIES: CJ-2A • TAGS: , . This site contains affiliate links for which I may be compensated.
0

UPDATE: **SOLD** Was$3800.

(02/21/2010) “Aluminum 1/2 cab, heater 12v alt new gas gauge, new sending unit, 12 v ele fuel pump new solex carb have orig, new plugs, new cap & rotor,point,cond. new elec wiper motor. new temp gauge mech. new spare tire mount, good title, orig steel body New lube in all gear boxs,new battery”

[fb_button]
 
To Top

1950 4×4 Wagon Clear Lake, Tx **SOLD**

January 2, 2010 • CATEGORIES: Willys Wagons • TAGS: . This site contains affiliate links for which I may be compensated.
0

UPDATE:  **SOLD** Was $7000.

(12/15/09) While approximately 90% stock, the seller gives a detailed review of what’s not original about this Wagon.

“It is a 4X4-63 model which was manufactured from January 1950 until March of 1950. It has a conventional ladder-type frame, and features independent front suspension utilizing control arms and a single traverse leaf spring. A three-speed Warner Model TY-96 transmission is used with synchromesh on the top two gears, and a Borg Warner overdrive. It is powered by a 4 cylinder L-head cast iron block and cylinder head engine producing 60 horsepower at 4000 rpm. It is a true 4×4 and has a Spicer fully floating front axle and a semi-floating Spicer rear axle and a Spicer Model 18 transfer case with a 2.42:1 low and 1.0:1 high range and locking front hubs. The shift lever is floor mounted. Front and rear suspension is semi elliptical leaf springs. This was a Texas Hill Country car and has zero rust on the body, frame or floor boards. The only rust is in the hinge area of the tail gate and to be show quality it would need to be repaired, however the tail gate is fully functional and opens and closes very easily:

Ninety percent of the vehicle is bone stock, however the previous owner made the following modifications several years ago.
•Added wood panels to exterior and interior of vehicle to create a “tin woody”. Exterior panels have aged and need to be replaced or recoated. Interior panels are in nice condition. The exterior panels are easily removable (just a few screws) and the body could also be painted to look like a woody as well.
•To establish clean woody exterior, the gas filler tube was relocated to interior of back compartment.
•Original flat front grill replaced with a 1954 V-Grill with cross bars.
•Seats were removed and modern bucket front seats were installed. Original style seats are easily available.
•Vacuum windshield wipers replaced with new electric wipers.
•Electric horn installed.
•Emergency brake installed
•Car converted from 6 volt to 12 volt and three new 12 volt gauges added under dash. (Original gauges are still in place however they operate off 6 volts so they have been disconnected.)
•Engine completely rebuilt. Installed new main bearings, polished crankshaft and replaced seals.
•New starter installed
•Custom made exhaust and new muffler.
•Transfer case seals replaced.”

1950_wagon_clearlake

[fb_button]
 
To Top

Builds: Mike’s 3B build

January 1, 2010 • CATEGORIES: Builds, Features • TAGS: . This site contains affiliate links for which I may be compensated.
7

Mike emailed me pics of his beautiful custom build this morning.  He’s taken his time over the past few decades to build something nice.  I especially like the heated seats :-).  But, this build isn’t just pretty; Mike takes it out on some ‘severe’ trails in the Northwest with his friend Phil, whose CJ-3A you can see here.

“Here are some photos of a CJ3B that I have worked on over the years.  I have had this jeep for over 20 years.  The frame started life as a 1950 CJ3A but the body was shot and I really like the 3B style.  I purchased a new steel body kit from 4 wheel parts wholesalers and at the time it was on sale and cost $900 complete.

The way it is now is the final version.  The color is Impact orange, The motor is an all aluminum  5.3 L33 engine that only had 6 miles on it.  The transmission is a turbo 350 mated to a Dana 300.  The rear end is a 1975 CJ5 Dana 44 with full floating axles and disc brakes with 4:56 gears.  The front end is a dana 30 with the same gears and disc brakes.   It has power steering and an aluminum radiator .

The interior is 2008 Corvette buckets with power and they are heated (great in colder weather) Lokar shifter, autometer gauges, Flaming river column plus a lot of other things.”

Ins-Jeep-1

Ins-Jeep-2

Ins-Jeep-3

Ins-Jeep-4

[fb_button]
 
To Top

1953 CJ-3B Jerome, ID **SOLD**

January 1, 2010 • CATEGORIES: CJ-3B • TAGS: , . This site contains affiliate links for which I may be compensated.
0

UPDATE: **SOLD** Was $7500

(09/28/09) This looks like a nice, stock, early CJ-3B.

“This is a 1953 cj3b that has been frame off restored . The engine has 800 miles on it . The engine was gone through top to bottom . It has been painted back to original color. I am the third owner . I have owned the jeep sence 2003 . The seats are in new condition . It has a heater and a defroster that both work very well . The tires have about 1/2 tread and the spare is brand new”

1953_cj3b_jerome

[fb_button]