UPDATE: **SOLD** Was $18,999
“1949 “Willly’s” Jeepster
350 Chevy Engine with 5,000 miles
Turbo 400 Automatic
4:11 Rear end, Pinto 2 Front end
Red with black vinyl Convertible Top
Mag Wheels, Large Tires”
UPDATE: **SOLD** Was $18,999
“1949 “Willly’s” Jeepster
350 Chevy Engine with 5,000 miles
Turbo 400 Automatic
4:11 Rear end, Pinto 2 Front end
Red with black vinyl Convertible Top
Mag Wheels, Large Tires”
UPDATE: This is supposed to be Fred Weis’ first Bobcat fiberglass body. **SOLD** Was $5500.
“1948 Willys Flatfender Jeep with Bobcat fiberglass body. It has a 327 small block chevy, T18 ford 4 speed, model 20 t-case, dana 44 with 1-ton chevy locking hubs in the rear, dana 30 with open knuckles in the front, warn winch in the front, 33″ MTR tires. It runs and drives good and has great working heat. Previously it had been in storage since 1981, but is back on the road and now has current tabs. This jeep is super fast and comes with lots of extra parts. Serious buyers only; might consider possible partial trades.
$5500”
UPDATE: *S*OLD** Was $3500.
The paint on the driver’s side seems a little odd. This has the ventilating windshield, the 2/3 1/3 seat, and only 18,000 miles.
“1960 Willy’s CJ5 Jeep, shows 18,000 miles. L-head Jeep engine, gone through on top end (valves). Starts, stops, and runs terrific…very dependable. Five like new 15″ mud/snow tires on five white spoke rims. Has Factory original full front seat (seats 3), and ventilated windshield…”opens like older Jeeps”. New plugs and wires. Passenger seat recovered. New red and black paint. Call us with any questions. Make a great huntin’ rig”
UPDATE: **SOLD** Was $800
This runs. I love the shifting pattern drawn on the ‘dash’.
“Hi – what I have is a CONTRAPTION that used to be a 48 Willys Pickup – it is not roadable – however it is a good PLOW/UTILITY vehicle for personal or neighborhood use …
I removed the cab from the pickup – and made a roof – it still has the original jeep front end , fenders and hood … It has a make-shift flatbed … a roll bar , etc …
The truck has a usable frame/chassis – it would be a cool project frame to put under an El Camino 4X4 project , etc … currently it has a good running (original) 4 cylinder engine … 3 speed manual trans … 4X4 in good shape – old tires have plenty of tread – never got it stuck , but they are severally dry rotted … has a good radiator …. – converted to GM 12V system …
Has a hydraulic pump operated plow … that works good – fixed position – just up or down …
Havent started it for awhile – battery probably shot …. points may need to be cleaned …. but when these things are attended to , starts and runs very good …
I want to sell the whole thing as is … but I will remove the plow if you just want the truck – the truck will be 600.00 and I’ll charge the same for the plow if I have to seperate … better deal if you just but the whole contraption as is … I did have to gusset the frame where it was rusty on one side , but did a good job …”
UPDATE: Still Available
(04/05/2011) Looks nice.
“Off road Jeep with V-6 , winch, oversize tires, many spare parts and in good running condition. It has a military frame. Stock transmission, transfer case, front and rear diff. But the gear ratio has been changed to 4:27 and posi-traction front and rear {Powerlocks). Also installed 19 spline axles front and rear cause there stronger. Leaf springs are 3 inch lift comp springs very stiff. Engine is a 76 Buick v6. There is an adaptor between front of transmission and bellhousing. Off Road Only! Sold as is Bill of sale only! Might trade for a travel trailer that is clean and in good shape.”
Dan spotted these.
“I have a set of 5 lug narrowed Dana 44’s off of my CJ3. I’m not sure if they are locked or what the gear ratio is. I was going to use these but I have decided to use stock axles for my project. They are currently still attached to the frame and I can help remove them. They are about 52 inches wide from where the tires mounts on each side
$400 OBO”
UPDATE: **SOLD** Was $1000
(02/28/2012) It’s a project.
“I’m selling my 1948 Willy’s Jeep resto-mod project. School has limited my availability to continue to work on this project so I’m selling it with 2 motors, and an ORIGINAL hard top
-1948 Willy’s cj2a
-s10 Frame
-early 90’s 4.3L
-2001 vortec 4.3L
-Dana 30 front and rear
-Power steering and brakes
-Hard Top
I have the body and the tub already separated for you so you don’t have to. I’m not trying to make a lot off this, I Just want someone who will finish it to buy it. So make me a reasonable offer.”
UPDATE: **SOLD** Was $2500
(02/16/2012) This has a cracked block, but comes with extra parts and an engine.
“1951 Willys Jeep ready to restore. Still ran when parked however has a cracked block. Comes with engine from 1952 willys ran when pulled. Lots of extra parts; gasket kit, carboraters; etc. Have been gathering parts to restore it but ran out of time and money. Good project for someone who wants an original Willys.”
UPDATE: Price now $4995
(12/01/2011) Lots of updates on this jeep.
“THIS IS ONE STRAIGHT JEEP!!! WITH NEWER TIRES…..A V6…..WITH A MANUAL…..AND IN PRETTY DARN GOOD SHAPE FOR OVER 60+ YRS OLD. JUST TOOK IT ON TRADE AND GOT IT THRU THE SHOP AND IT IS READY TO GO!! TO SEE MORE PIC’S GO TO WWW.A1AUTOSALESPULLMAN.COM OR CALL ME WITH ANY QUESTION’S AT 509-715-7062. WE DO TAKE TRADE IN’S AND WILL CONSIDER ALL REASONABLE OFFER’S!! VIN#CJ2A206185. COME IN AND DRIVE IT MON-SAT 9-6!!!!
HAS:
New Tires
New Brakes
Buick 238 V6
3 speed manual
2 stick transfer case
Chevy Monza steering column and box
Locking hubs
Custom bumper w/
Wench mounts (no wench)
PTO gearbox
Full size spare
2 jerry can (gas cans)
Rhino Lined interior
Vinyl Seats front and rear
Buck seats front
Bench seat with storage compartment in the back
U joint front axles (hard to find on a willys)
New fuel tank
Comes with:
Bikini top
2 doors
New in box Painless wiring harness (retails for almost 500 dollars)
TITLE IN HAND”
http://kpr.craigslist.org/ctd/2951314211.html
UPDATE: **SOLD** Was $4000
(04/08/2012) This has a fiberglass body and tilt front end.
“1949 willys Cj3
In 1970s it was took to Novak Enterprises A Jeep
conversion specialiste To V8 AT & Fiber gass body
Now it has
New Paint is the original green
for the year 49
& Letting & stars
350 Chevy and 350 AT & PS, PB,
new Tranmission mount
& transfer case, axles front
and rear end in good shape
New Drive Shaft,
Hust Shilter
Headers
Electric Fuel Pump
Tilt Wheel
Back Sent, but not got the
fronts seats
New after market Wiring Harrness
All lights works Great
Tilt Frontend & Fibergass Body
All new frontend parts re condition Steering box
Tie Rods ends & new Steering Stabilizer bar
Just needs frontend line up
Bridgestone Dueler
33×12.50 R 15 LT over 500$ in tires”