UPDATE: Still Available.
(09/02/2015) The steps have been modified and the front frame rails lengthened.
http://gainesville.craigslist.org/cto/5593245329.html

“1958 Willys CJ3B
This is the “High Hood” Jeep that replaced the CJ3A with the introduction of the Hurricane engine. That engine replaced the flathead Go Devil with overhead valves and a little more horsepower. I bought the vehicle in October of 2011 with the intention of a full restoration, but as I got into it I decided to concentrate on the mechanicals and make it roadworthy and reliable, then use it for light off-roading.
Since then I have just under $ 12,000 in it. $ 3500 up front, and $ 8200 in parts. Here’s a partial list:
• Full engine teardown and rebuild, mid 2014. Only about 600 miles since then. Rings haven’t even fully seated yet.
• Monstaliner bedliner on floor
• New speedometer and cable
• New gas tank
• New temp switch
• New carb
• New water pump
• Grab handle
• Heavy duty shackles
• Air cleaner hose
• New springs and shocks
• Headlight switch
• New u-joints rear
• New radiator
• Five new NDCC tires and tubes (period correct, like mil tires)
• New spare tire mount
• New windshield
• New battery
• New clutch Continue reading →