This was listed at $4800, but that price has been crossed out. Perhaps the seller is taking offers? The front suspension setup is unusual. It appears a bump stop has been added to the rear of the springs, replacing the shackles. It also looks like some kind of block or wedge sits between the springs and the axle.

https://www.facebook.com/marketplace/item/768304708324018/

“Complete frame up restoration project that is very close to being finished. It came from California and is extremely solid. It was taken down to bare metal and there was not a spot of rust anywhere. A skim coat, block, primer, block seal, and painted gray. It’s a 46 CJ2A with CJ5 running gear that has overdrive so it will have no trouble running the freeway. Has a chevy 350. Lot’s of new parts. Part’s alone cost more than the asking price. I have the windshield frame and windshield for it. its painted black. I will not respond to is this still available. Located in napavine Washington. Cash only sale, no trades. First person here with cash takes it home. Change of plans…..I’ll part it out. Let me know what you need. It has a really nice suspension setup. I think I’ll keep the 350 SBC that’s in it for another project.”

Continue reading →

The seller has a lot of money into this, but the jeep remains in pieces. The pic below was taken prior to it being disassembled.

https://www.facebook.com/marketplace/item/244281111765795/

“Hello, I have a 1952 Willys CJ3A project for sale. I have had it for about 25 years now and don’t see myself finishing it anytime soon. So it’s time for it to move on. I have about $12k into it and it’s still in pieces. I bought the replacement panels and $4k in parts (see lists in photos). I also had engine completely gone through, machined, and professionally rebuilt ($3k) with hardened vavle seat so it is good for todays gas. It has a Dana 44 rear axle, original heater, professionally rebuilt front and rear driveshafts, and quite a few spare parts including a spare transmission and transfer case. I also have a full steel hard top (no side doors) and a half cab/doors. Have clean title too. I also attached a couple photos of when it was together. I would like to get $6k because there is $4k in parts on the lists alone, $3k in the engine, plus everything else. Open to offers/trades especially a for 55’-59’ Chevy/GMC truck driver/solid project. Goose neck livestock trailer w/lvg qrtrs.”