UPDATE:  **SOLD** Was $7000.

(12/15/09) While approximately 90% stock, the seller gives a detailed review of what’s not original about this Wagon.

“It is a 4X4-63 model which was manufactured from January 1950 until March of 1950. It has a conventional ladder-type frame, and features independent front suspension utilizing control arms and a single traverse leaf spring. A three-speed Warner Model TY-96 transmission is used with synchromesh on the top two gears, and a Borg Warner overdrive. It is powered by a 4 cylinder L-head cast iron block and cylinder head engine producing 60 horsepower at 4000 rpm. It is a true 4×4 and has a Spicer fully floating front axle and a semi-floating Spicer rear axle and a Spicer Model 18 transfer case with a 2.42:1 low and 1.0:1 high range and locking front hubs. The shift lever is floor mounted. Front and rear suspension is semi elliptical leaf springs. This was a Texas Hill Country car and has zero rust on the body, frame or floor boards. The only rust is in the hinge area of the tail gate and to be show quality it would need to be repaired, however the tail gate is fully functional and opens and closes very easily:

Ninety percent of the vehicle is bone stock, however the previous owner made the following modifications several years ago.
•Added wood panels to exterior and interior of vehicle to create a “tin woody”. Exterior panels have aged and need to be replaced or recoated. Interior panels are in nice condition. The exterior panels are easily removable (just a few screws) and the body could also be painted to look like a woody as well.
•To establish clean woody exterior, the gas filler tube was relocated to interior of back compartment.
•Original flat front grill replaced with a 1954 V-Grill with cross bars.
•Seats were removed and modern bucket front seats were installed. Original style seats are easily available.
•Vacuum windshield wipers replaced with new electric wipers.
•Electric horn installed.
•Emergency brake installed
•Car converted from 6 volt to 12 volt and three new 12 volt gauges added under dash. (Original gauges are still in place however they operate off 6 volts so they have been disconnected.)
•Engine completely rebuilt. Installed new main bearings, polished crankshaft and replaced seals.
•New starter installed
•Custom made exhaust and new muffler.
•Transfer case seals replaced.”