UPDATE: **SOLD** Was $800
(09/23/2011) “1949 jeep body have hood , fenders, wind sheild frame asking 800.00 for its age it is in good condition but still needs work”
UPDATE: **SOLD** Was $800
(09/23/2011) “1949 jeep body have hood , fenders, wind sheild frame asking 800.00 for its age it is in good condition but still needs work”
UPDATE: **SOLD** Was $2500.
“cj3a willys jeep 4cylinders hurricane engine runs and drives with winch. Newer tires fun little. Run around”
It runs and drives, but needs some body work.
“Selling my Willys cj3a jeep. Runs good brakes need work body is rusty. 4×4 works with high and low. Has been sitting for a while and now won’t go into 3rd gear. Motor fires rite up does not smoke. Have title. 402-841-1931”
Not much info provided.
“Call for info thanks 603 3257064”
Lots of mods on this rig.
“1949 Willys CJ3A this rig has a lot of work done to it. It has a Ford SB 302 CID V8, rebuilt carburetor, new starter and alternator, power steering, electric fan and fuel pump, points converted distributor, relocated oil filter, custom headers, Flowmaster mufflers. The drive line is setup very nice T90 3 speed transmition(new clutch), T18 transfer case, Warn Saturn overdrive so it has 12 forward and 4 reverse gears, New U joints, Dane 25 front axle, offset Dana 44 rear axle with a locker. New 35x 12.50 15 BF Goodwrench KM2 on black spoke steel wheels. It has been lifted with 2.5in Rancho leaf springs and a spring over conversion. New fuel cell and gages, 8000lbs winch, two fuel cans and mounts. I have a few extra parts that I just haven’t had the time to install yet. So as you can see this is a very capable trail rig. Just about all the custom work on this was done or redone correctly by me. Asking $3000 OBO. If you have any questions please ask.”
UPDATE: **SOLD** Was $1500
You never know when you’ll need to blend in with a heard of cows.
“This is a project jeep for someone, axles have been gone through, dana 25 & 41 with 5.38 gears. Has a 302 V8 kit installed, not running & no radiator. Tow bar come’s with it. The body is very straight but has floor board rot like all CJ’s. Willing to barter, I’m into ford hipo racing parts, small block or big block parts. Ansen older 8lug pattern 16.5×10 slots, 38 inch swampers-mudders. Some where around 1k. What cha got ?”
UPDATE: Still Available
(04/25/2013) This looks good, but I can’t if it is a 1948 CJ-2A or a 1949 CJ-3A. I’m guessing 3A.
“1948 WIllys CJ3A Jeep. Restored to original specs. Rebuilt original motor, transmission, carb, fuel pump and brakes. New wiring harness. 6 Volt electrical system. Painted Luzon Red with the correct stencils. Power take off 8,000# Konig winch. New military tires. This is a jeep that brings smiles to peoples’ faces! Clean California title.”
Ryan forwarded this. It’s not perfect, but there appears to be value here. The body has some crinkles.
“All body and interior parts of Willys 1947 CJ2A, including tub, tailgate, fenders, hood, grill, instruments, and seat frames.
All in fair original shape, with some rust that will need patching in floor, and threshold area (see pictures. Fenders, hood, and grill solid, but normal dings and dents. Never bondo-ed, never patched.
All parts sold together until 6/7/13, when I will part out separately if not sold as package.”
http://www.ksl.com/index.php?nid=218&ad=25451136&cat=&lpid=1&search=willys&ad_cid=10
UPDATE: **SOLD** Was $14,000.
Pascal spotted this jeep. Note the jeep-lamp above the garage door 🙂
“willys jeep cj3a 1949 refait au complet frame differentiel et roues peinture powder coating moteur refait complet body refait complet plancher neuf banc refait a neuf lames neuves shocks neuf electricité refait a neuf terminal soudé batterie neuve starter et générateur refait poulie de crank neuve boite de controle neuve monté original cj3a tout a été sandblasté et repaint le seul cj3a enregistré au québec plaqué pret a roulé inspection fait investi plus de 12.000$ et 3 ans de travail.evaluation pg 14,000$”
This a MB-like jeep built on a 3A chassis.
“This MB-3A jeep is a completely rebuilt CJ3A frame and running gear with one of our (D&L Bensinger’s) new, reproduction MB-2A body kits installed to make this look like a WWII jeep. It is perfect for parades and reenactments.
The jeep has a new wiring harness,12-volt system, used combat wheels and tires, new seat frames and cushions. Also includes top bows but no top. New spare tire with repro combat wheel included.
More pictures available upon request. ”