There are three pictures of this jeep.  Two I *think* are before it was torn down and the third looks like it is an in-progress rebuild.  In the third picture, shown to the right, you'll note newer rims and how the body is sitting higher than before (could be a new SOA mod or different springs).

"1953 Willys Jeep CJ3B Project 231 buick V6 stock axles trany been gone thru tube frame vary clean 1 1/2 Body left missing some parts great potential. fairly clean body. call 530-228-1763 Mark / 530-877-1663 1750– OBO e-mail mdwight@c21selectgroup.com"

http://chico.craigslist.org/pts/812373250.html 

UPDATE:  The price is now $3500

I'm not sure I have seen a jeep with a stainless steel roll cage.

"1953 Willys high hood jeep. Dana 60 rear end, detroit locker. 360 AMC motor, T18 transmission. Custom made stainless steel roll cage. This is a diamond in the rough. $4,000.00 (208) 495-1221"

http://boise.craigslist.org/cto/815863719.html 

There's been some mods to this one, more than described by the seller.  Looks like a great trail jeep.

"RARE FIND! Relocation forces sale of Jeep! Original body, new rolling chaise, tires, custom roll cage, 5pt harness seats, 20 gal fuel cell. Custom made cover for outstide storage (has been garaged). Runs great and ready for off roading! More photos available upon request. Seller will entertain all offers and call with any questions. More pictures can be emailed. 503-314-6806"

http://portland.craigslist.org/wsc/cto/809910627.html 

I love Scotts Valley .. I worked out of the old Borland Building for 3 years.  There are few better places in the US to work than the old Borland Building (now the Enterprise Technology Center).  As for the jeep, it's priced a bit high for a non-running CJ with significant rust.

"All original 1964 Willys CJ-3B (original matching serial number engine and chassis with number plate. Original body color was Spruce Green, now is painted a light blue color. Runs fine, but smokes a little (engine should be rebuilt eventually). Needs some minor work to get running again (battery recharged, gas lines and gas tank drained). Hood looks like it has been replaced at some point. Aftermarket heater installed in front passenger side. Rear bench seat is missing. CD ignition system installed."

http://sfbay.craigslist.org/scz/cto/806864236.html 

I think this is a good price.  It looks like it has a warn winch, good tires and a good top.  With the overdrive, you've got $1000 worth of value right there.

"1963 Willys CJ3B jeep V8 with overdrive 31 inch mud tires. Lots of extras. Call Andy 432-7869."

http://cosprings.craigslist.org/cto/802006118.html 

UPDATE: This was for sale for the same price in July, but the jeep was brown (as you can see in the pic on the right). Now the jeep is gray as seen in the left.

Given that the body is a fiberglass, which is very hard to find for CJ-3Bs (actually impossible is a better word), I'm positive this was produced in the 80s or early 90s.  Looks to be in great shape.

"This 1954 3-B Highhood powered by a Chev 383 stroker V-8 and 4-Speed transmission.  warn 12,000 lb winch.  36×14.50×16.5 swampers. dana 44 front axle. dana 18 transfercase.  Fiberglass Body …."

http://seattle.craigslist.org/tac/cto/802615382.html 

(SEE COMMENTS)  It appears a great deal of meticulous work has gone into this ‘restoration’ and it looks nice.  However, this doesn’t make a whole lot of sense to me.  If you are trying to make jeep that’s just come off the battlefield of WWII and you are going to invest the time and energy, why not do this with an earlier model such as an MB (that really did come off the battlefield) or it’s closest cousin the CJ-2A?

“98K original miles, 6 volt, all stock and original, new engine (it purrs) with maybe 5K on it, rebuilt transmission, rebuilt brakes, fresh upholstery on the original seats, a few dents and dings. Its turn key, needs nothing, starts, runs and drives excellent for a near 60 year old Jeep. Built to look like it just rolled off the battlefield in WWII, extended bed, Flat military green paint,loaded with ammo boxes, vintage tools, military surplus stuff, canvas etc.”

**SOLD*

UPDATE:  **SOLD** Was $1750.   I think this is a good deal.

This ad caught my interest because I’d never heard of Newport, Washington.  Newport is located north of Spokane and west of Sand Point, Idaho.  Looks like a beautiful place.

The jeep is interesting too.  The drive train has been modernized and the jeep outfitted with a modern cage. The engine probably has some extra spunk for a v-6, but bored 60 over suggests that it might not have a ton of life left.

“1953, Complete running gear out of 1968 Jeepster Commando, 3:73 gears, model 27 up front has a 44 in the back, model 18 transfer case,turbo 400 with shift kit, 225 V6 punched over 40 headers and turbo mufflers, aluminum high rise with 4 barrel carb, saginaw power steering, 2 inch lift kit, we have a few spare parts that go with it. Hasn’t been started in three or for years. missing coil and ballast resister. Has a nice full cage. Front and rear seats out of CJ-7”

UPDATE: **SOLD** wAs $3500.

“I am selling a 1953 Willys CJ3B. This is a rare hi hood flatfender. This jeep is curently regestered and driven all the time.It runs great. It has F head engine and 3 speed tranny,everything works good.I am asking $3500.00 obo.I do not need to sale this jeep so no low ballers.”

UPDATE: **SOLD** Was $2500.

“1954 Jeep Willys 3b project. This Jeep would make a perfect project or with a little work make the pefect Hunters Jeep. It has the High hood, Buick V6 motor and a PTO winch. It has been sitting for a few years and at this time does not run. If you have any questions give me a call and I will answer them the best I can.”