UPDATE: **SOLD** Was $16,000.
Has tool indents. Has a few mods. Needs a front bumper.
“Frame up restoration. Over $18000 invested”
UPDATE: **SOLD** Was $16,000.
Has tool indents. Has a few mods. Needs a front bumper.
“Frame up restoration. Over $18000 invested”
UPDATE: **SOLD** Was $6000.
This might be a CJ-2A with a CJ-3B body.
“Runs and drives great..needs seats 4wd works great. New radiator Water pump Plugs and wires Cap and rotor Oil lines Fresh carb kit. Newer gas tank All in all it’s a fun Jeep and did everything I needed and wanted it to do.not in a hurry to sell.would much rather have a a sxs lol Asking 6000”
In March 1962, two different articles highlighted the introduction of the Jeep line of Tonka Toys.
1. Toys and Novelties Magazine: The article in this magazine noted that part of the reason the Tonka company had the financial and physical capacity to produce a wide variety of toy jeeps was that it had recently gone public.
View all the information on eBay
2. Playthings Magazine: Given this article is very similar to the top article, I’d guess both were written from press releases.
View all the information on eBay
You can also learn more about Tonka jeeps at the CJ-3B Page.
As reported in this post, in 1962 the Tonka company launched the jeep models many of us owned as kids (and some of us still own as adults). It didn’t take long for Tonka to introduce specialized packaging as well. The August 1962 issue of Playthings Magazine highlighted three different Dispatcher Tonka Toys, with Hatari-themed boxes, that were for sale in the lobby of movie theaters while Hatari played in theatres.
View all the information on eBay
The article appeared on this page:
In the Fall of 1963, Tonka introduced this three-vehicle package called the Outdoor living set, which included a jeep surrey, a jeep ‘runabout’, a jeep truck with camper, and boat.
View all the information on eBay
Update: Sold. Was $14,000.
A nice one with lots of updates.
“Steering wheel on the right side, Stock Chevy 305, Chevy sm465 4 speed, granny in 1st gear, new clutch, flywheel, pressure plate, starter, Dana 20 transfer case, Dana 44 rear with stock 4:27 gears with Detroit gear less locker, Dana 30 front 4:27 gears with Detroit gear less locker, warn 9000lbs winch, with rear mounting capability, Holley 2d projection fuel injection throttle body, on board air, Chevy power steering box, 75% 2 year old 3 ply sidewall bf good ridge mud Terran 35s, monotone mx6 adjustable shocks, electric fan, highlight jack, all new brakes, wheel cylinders, shoes and master cylinder, no worries on the rear axle I still have all the Inards from stock”
UPDATE: **SOLD** Was $5000.
Used at a “Nevada Test Site”? Bring your Geiger counter.
“Body is good ,motor needs rebuilt it is parts now,was used at the nevada test site for many yeary.”
UPDATE: Status Unknown. Was $10,800.
(08/20/2018) Appears to have a replacement tub.
“1946 willy jeep, cj2a. buick v6,winch,new top,new seats,t90 trans.”
UPDATE: **SOLD** Was on eBay.
Bill spotted this solid looking M-715 project with a generator in the back. Looks like it has potential.
“You are bidding on a 1968 Kaiser M-715 Jeep. 27k miles. This Jeep had been sitting in a garage since 1999 before I bought over this past winter.. I put it in my garage and haven’t had time to go through it. It turns over but doesn’t run…. it has a good frame, solid floors, drivers side rocker below the door is rusty, but the body is otherwise in good shape, has the 6 cylinder tornado motor, manual trans, 4×4, high/Low. Comes with a generator in the back, which I have no clue if it runs or not. Please not that we are selling this vehicle today as is, with a bill of sale, to the highest bidder of this auction AND it will be that persons responsibility to pickup this truck from our location”
No engine.
https://www.facebook.com/marketplace/item/2660587074161306/
“1958 willys mule. Rare one of the first 11000 built. Missing engine and front seat. Pretty much complete of other components. You could put original 4 cyl or update to newer 2 cyl. Best offer.”