UPDATE: **SOLD** Was $6400.

Appears to need a little body work.

“1952 Willys Jeep with V8 302 engine and 4 speed trans with Warn overdrive. Installed with Advance Adapters kit. New 20×10″ wheels with 33″ tires. Factory dana front and rear. 4wd works great. Has top frame and doors but needs top skin. Engine has electronic ignition conversion. Runs great. Body is excellent for it’s age with very little rust. All lights work. Front bumper doubles as an air tank. Fun little toy. Clear NC title.”

This restoration still needs completion.

https://oklahomacity.craigslist.org/cto/d/1950-cj3a-willys-jeep-8000-obo/6498933201.html

“This jeep has had a high end restoration started that is not far from being finished. The chassis and drivetrain are finished and like new with all new parts. It has an all new body kit along with extra original hood and tailgate. There is also $1,600.00 in new parts to finish the restoration.There is around $16,000.00 invested in this Jeep. Also has title. If interested please call. I do not text good.”

It’s an unfinished project.

https://showlow.craigslist.org/cto/d/willys-jeep-cj-3a/6492131377.html

“I’ve decided to sell our 1949 cj3a,the chassis is all redone,all new steering,exhaust system,new brake lines rubber and steel,new suspension,replaced axles with 1953 m-38 axles dana 27/44 (538) with 11 inch brakes with new seals and gaskets and new oil,frame was degreased and cleaned,sand blasted ,any and all cracks were welded,battery box was rebuilt, frame was primed and painted,also replaced pedal assy,and all bolts were new grade 8, this comes with the original 3a tub (Green)and a 2a tub (yellow), and a 2a front clip,and 3a front clip,3 windshield frames 2-2a’s and 1-3a,two heaters 1 big one for passengers side,and 1 small one for drivers side,2 extra heads,1 extra parts motor, 2 radiators ,two 2a seat frames,please note: tubs both need floors replaced.

motor is a l-134 with a kaiser supersonic head 60 over on pistons,and needs new rod and main bearings,I was told it was rebuilt,haha,not. it does have new copper head gasket,and carb has been built by me,good it has a good clutch assy,starter works but needs replaced,t-90 transmission has been torn down cleaned and case repainted,internals look good,just needs bearing and gasket kit,dana 18 tranfercase torn down and cleaned and case painted , again internals look good, needs bearing and gasket kit,also new fuel tank, there are a lot of parts ! clean arizona title. If you want a real good start on a cj-3a this is it”