Paul’s made some progress on his Willys. You can read past posts about his jeep, Knardly Rolls, here: http://www.ewillys.com/tag/paul-m38/

Paul writes, I’m using thin poster board to make patterns for the interior panels on the Willys. Since the reinforcing structure for the top and doors will be visible from the inside and not covered by upholstery I’ve had to make 33 individual paper patterns so far. After adjusting the fit of these patterns I’ll transfer their measurements to 3/4 inch thick high density foam and then it’s time for the upholstery wizards to work their magic. Fourteen yards of fabric are on order so that should be enough to cover everything but the floor. All of the top and side wall panels will be covered with a silver gray fabric and this same fabric will be used on the seats with the exception of blue insert panels covering the center of the seats. That’s the plan right now. I still need to buy some thick upholstery foam so I can begin cutting out the padding for the seats but I wanted to finish with the patterns first.

More pattern pictures. To have enough room to make the patterns and install the upholstery pieces it was necessary to remove the fuel tanks and both front seats. The more work I can do myself the lower the cost will be to get the upholstery done so I don’t mind constantly climbing into and out of the Willys all day long. Things would be a lot easier if the Jeep was just a little bit bigger or I was just a little bit smaller. Oh well, I guess I need to call a Waaaaaaaaaambulance. Paul