Yesterday I made a first pass at a design for the gauges on the dashboard.  As a part of that exercise, I tried to find a space for the data plate I have.  The data plate is original to the CJ-3A I have and in good shape, except that it is faded, so it is hard to read.  In fact, I tried to scan it into my scanner and the scanner couldn't pick up the words or pictures at all.  After pondering the situation, I decided to recreate a data plate graphic and take it into a print shop to see if I can make a raise print or sticker of some kind.  As part of the customization, I've tried to recreate the fonts as closely as possible, however, much to my surprise, the data plate uses several different fonts, some of which are the same font but stretched or bolded or both.  Also, I've updated the data plate to better reflect the drive train I have installed.

Here's the current favorite mockup so far (note the font kerning and arrangement will be more precise on the final high resolution version).

I found a very helpful article from a toyota landcruiser owner at offroad.com about building custom power hoses.  In the article he provides pictures and a list of parts he used from Summit Racing.  Unfortunately, his part numbers don't correspond exactly to the numbers from the Summit Racing catalogue I have, but they are close enough to guide me correctly.  

To do my build the way I want (which is routing the power steering through the cross member) based on this article and the new summit racing catalogue, I believe I would need:

5 -6AN EAR-309106ERL 90 degree bend tube $16
2 -6AN EAR-300106ERL straight $7 each
2 -6AN EAR-983206ERL Straight Bulkhead $4 each
1 –6AN to 11/16-18 Not sure on part number yet approx $7
1 –6an to 5/8-18 Not sure on part number yet approx $7
-6an power steering 6ft perform-o-flex hose EAR-406006ERL $45

That's a grand total of $161.  If I only do the power side, I can cut this amount in half.  I'm gonna talk to the folks at my local hydraulic store and see what they can do for me. 

Lyle from Bob's Mechanical called me today.  He left a message on my phone asking me to call back in a tone that made me wonder whether a relative of mine had died!  Turns out, the news was worse;  Both of my heads had one crack each between two valves. You can see one of these cracks in the picture to the right. 

Fortunately, my $50 engine had 2 good heads, though these heads weren't ported nor did they have their valve guides machined, they did have better seats.  Best $50 I've spent so far!