Another thing I got accomplished recently was the rebuilding of Rusty’s T-96 transmission. It’s been a couple decades since I’ve rebuild a T-90, but I think a person could follow a T-90 side shift guide when rebuilding the T-96 (I didn’t think of this until after I was done — instead I used an old rebuild manual from the late 60’s that has rebuilds of 35 different styles of transmissions). Once again, I thought I had more pics, but I didn’t. So, this isn’t a step-by-step overview.
I took this photo at the beginning of the tear-down to remember which way the speedometer gear should face. The lack of a transfercase is part of what makes this rebuild different from most other jeep transmissions.
Here’s the transmission with the input shaft pulled forward. My first gear and second gears were a bit worn. 
Once I removed all the gears, I discovered the reverse gear had a broken tooth. 
Close up of broken tooth. Thankfully, Charles Tate had sent me a box of T-96 parts that included a reverse gear. I was also able to replace the entire bottom cluster, first gear, and second gear. That saved me some money!
To remove the side shifters, a pin has to be tapped out. I was able to remove the 2/3 gear shifter, but not the first/reverse unit. Since there was no critical reason I could see for removing the first/reverse mechanism, I left it as is and cleaned up the housing.
Normally, I’d paint the housing before assembly. However, with time being an issue and lacking enough warmth on the rebuild day to properly paint it, I will paint it at a later date. 
One other unique thing about the T-96: it requires the use of a special speedometer cable that is also used for Jeepsters and wagons.
[fb_button]
