Project or buckets of parts.

https://wichita.craigslist.org/cto/d/jeep-cj-2a-project/6557174159.html

“I am selling a CJ-2A. I have a shed full of spare and misc. parts. Among the parts are the grille, hood, and windscreen frame. As well as 2 Bell housings, 2 transmissions – 1 complete,2 Transfer-cases – 1 complete, and Willy’s Go-Devil Flathead Engine. I would prefer to sell the car complete, however I am willing to part this car out. If looking for full car, it will be bill of sale. If looking for a part, just ask! Never hurts to check. Any Jeep part in the pictures is available. The body/Tub is in decent shape has a few dents and issues on exterior body, as well as drivers side floor is rusted out. The bed has also been covered up with diamond plate after the bed was dented.”

UPDATE: Price dropped to $1400.

(09/09/2017) Neither run.

“Good project vehicles
Good tires and a good motor for one
Have seats, windshield, hood and other parts that come with them.”

https://fayar.craigslist.org/cto/d/1946-and-1947-willis-jeep-cj2/6288510926.html

Update: sold.

Brad has this CJ-3A setup to be a farm jeep. It includes a set of dually adapters, a Monroe lift, and more.

“For sale, cj3a farm jeep, 1951 I think, has Pto, Monroe 3 pt hitch, counter weight, overload stops, snow plow lift and brackets( removed) set of four Hicky duel wheel adapters, has duel altanators, lots of parts! Engine is locked up and I have too many projects and it needs to be finished. Body is fair, needs floorboards mainly. I was going to leave a survivor. Located in western ky, $2900″

Continue reading →

UPDATE: **SOLD** Was $6000.

This looks familiar, but I can’t place it.

“I’m selling my 1950 Jeep Willy. It has a built 302 Ford
Ford 9 inch rearend
All the running gear transmission transfer case front end are out of a 1969 Ford Bronco.
It is meant for fun.
Serious inquiries only please. I am in no rush to sell.
Asking 6,000 obo”

Missing the parking brake and the windshield vent lid.

https://sandiego.craigslist.org/csd/cto/d/1950-willys-jeep/6562064479.html

“1950 cj3a completely restored 5 yrs ago.rebuilt motor trans transfer case front rear diffs.new suspension steering.new wiring brakes master cylinder.new upholstery.has maybe 1000 miles on it since resto.paints good but has some chips in it.”

Has a variety of updates.

https://modesto.craigslist.org/cto/d/1951-jeep-willys/6561276134.html

“Very clean Willy’s Jeep with rattle can olive drab paint job. Runs very good and everything works. Has a bimini top, gas can, rear seat, seat belts, and power steering! Previous owner installed power steering and upgraded the motor to a ’53. Diamond plating in the back seat area and a winch. Odometer says 6830, but surely that isn’t accurate. No low ball offers, and no I won’t trade for anything other than cash.”

Seller plans to raise the price to $4000.

https://losangeles.craigslist.org/sfv/cto/d/today-only-1952-willys-jeep/6560629455.html

“HEARD IT RUNNING GREAT 2 WEEKS AGO. Then my mechanic moved out of state. NEEDS BRAKES AND SOMEONE TO RECONNECT THE REALLY SIMPLE ELECTRICAL. Other than that it is rust free and has BRAND NEW TIRES AND I HAVE A BUNCH OF NEW PARTS I HAD BOUGHT AND WERE NOT INSTALLED. (INCLUDES fuel pump brake parts etc)
SO far I found one of the headlight rings and buckets….the other is around here somewhere
Waiting on my disability check and as soon as I get it I will raise the price again to $4k.”

UPDATE: **SOLD** Was $2000.

(03/30/2108) It’s a project.

“Unfinished project 75% done.
Has a lot lot of goodies. Which I will list at bottom of post.
***I cannot stress this enough 75% Done***
I would say if your not a fabricator this is probably not the project for you.

Here’s what it needs;
Transmission tunnel, transmission mount, re hook up break lines, fuel system, steering column needs to be mounted,
*Motor will turn on but obviously needs work to drive.
Continue reading →

UPDATE: **SOLD** Was $6900.

(01/28/2018) The top doesn’t look like it would hold up well at faster speeds. The jeep has a variety of mods.

“Super fun to own and drive. Pretty much rebuilt when I bought it a couple years ago. Rebuilt six cylinder flat head Studebaker engine, stock running gear, tow bar for front, 2 sets of tires and wheels, manuals, prior owner receipts for work done, two 10 gallon gas tanks under the seats, four extra 5 gallon gas cans, hi-lift jack, Replica 50 caliber machine gun & mini gun, military tool box, ammo cans, replica radio transmitter with working lights in it, front halogen light and two spotlights, antennae base. I made a top for it out of canvas, you can leave it or take it off. Performs really good in sand & desert.Would make great parade vehicle. Open to offers.”